Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.03 seconds.
Search: Posts Made By: peewee2you
Forum: Early V8 (1932-53) 02-27-2019, 06:36 PM
Replies: 38
Views: 2,977
Posted By peewee2you
Re: DEAD: 1948 Super Deluxe 8 Sedan

Pigpen, I see in previous post the condensor has been mentioned, and you stated coil was replaced, as others I had the similar problem and indeed turned out to be the condensor, if I missed it I...
Forum: Early V8 (1932-53) 09-03-2018, 12:33 PM
Replies: 22
Views: 2,288
Posted By peewee2you
Re: Ford Flathead Coffee Table

I'm guessing he's married, has a son, and stated in the office area. That is one piece of beauty, nicely done. Both you and your son did a terrific job on it.
Forum: Early V8 (1932-53) 08-31-2018, 11:10 PM
Replies: 29
Views: 2,802
Posted By peewee2you
Re: engine colors

I have a 47 Ford, a week after I bought it I had the Flathead rebuilt when it came back from the builder it was painted green, and I got used to it, so when I cleaned up the engine compartment I...
Forum: Early V8 (1932-53) 08-23-2018, 01:48 AM
Replies: 15
Views: 1,729
Posted By peewee2you
Re: 1947 Ford Radio Installation?

the link listed below the installation instruction pic above is another photo just click on it.
Forum: Early V8 (1932-53) 08-23-2018, 01:40 AM
Replies: 15
Views: 1,729
Posted By peewee2you
Re: 1947 Ford Radio Installation?

more photo's of 47-48 Radio http://pic20.picturetrail.com/VOL1755/12057965/24176261/413981417.jpg
http://pic20.picturetrail.com/VOL1755/12057965/24176261/413981418.jpg
Forum: Early V8 (1932-53) 08-23-2018, 01:36 AM
Replies: 15
Views: 1,729
Posted By peewee2you
Re: 1947 Ford Radio Installation?

My hope is that is of use to you. http://pic20.picturetrail.com/VOL1755/12057965/24176261/413981416.jpg
Forum: Early V8 (1932-53) 08-21-2018, 01:32 AM
Replies: 6
Views: 532
Posted By peewee2you
Re: Question about hubcaps not fitting.

I am not that familiar with a 32? I own a 47 Ford, however I was thinking your all stock so probably using stock caps or want to? Have you tried to get the cap to the wheel without the grease cap...
Forum: Early V8 (1932-53) 04-17-2018, 01:47 AM
Replies: 6
Views: 1,103
Posted By peewee2you
Re: my new fancy pants wheel painting rig

Back in my twenties I knew a fine gentleman Ted Crosby he restored model A's did beautiful work, i became his helper and learned a lot, he had rigged a similar wheel machine that rotated all four...
Forum: Early V8 (1932-53) 11-15-2017, 02:24 PM
Replies: 5
Views: 860
Posted By peewee2you
Re: Ford Scripted Water pumps

Thanks to all that viewed, and i appreciate those that actually replied, Kube that's pretty much what if I figured value vs. shipping, so the idea of rebuilding them is probably the way to go, for...
Forum: Early V8 (1932-53) 11-14-2017, 05:16 PM
Replies: 5
Views: 860
Posted By peewee2you
Ford Scripted Water pumps

I have 2 Ford scripted Water pumps, I'm cleaning out my shop and not sure if I should just discard them? I kept them because they were the ones on my 59AB Flathead. I replaced with some rebuilt...
Forum: Early V8 11-12-2017, 02:06 PM
Replies: 0
Views: 293
Posted By peewee2you
Flathead Air Cleaner

http://pic20.picturetrail.com/VOL1755/12057965/24727507/413646004.jpg
Flathead V8 Oil Bath Air cleaner, no dings or dents, doesn't have the rod clamp.
$55.00 shipped. I will get the carb diameter...
Forum: Early V8 (1932-53) 07-07-2017, 08:44 PM
Replies: 49
Views: 3,679
Posted By peewee2you
Re: 1951 F2 Information

I owned a 51 F2 back in the day, it was awesome, had general tires up front and the grill was all chrome, fire red, swapped out the flathead for a 302 with C4, stock rear end and that truck flew like...
Forum: Early V8 (1932-53) 08-07-2016, 04:22 PM
Replies: 18
Views: 1,875
Posted By peewee2you
Re: Bolt finishes

I agree with Paul, I have a 47 4dr Ford, and currently restoring a 61 vw convertible, and have literally, wire wheeled every nut, bolt, washer using this method, along with a dremel for those tight...
Forum: Early V8 (1932-53) 04-19-2016, 06:52 PM
Replies: 83
Views: 7,078
Posted By peewee2you
Re: High Beams stick on.

Henry,

it's good because if you end up some time wanting to remove it you can.
Forum: Early V8 (1932-53) 04-19-2016, 06:51 PM
Replies: 83
Views: 7,078
Posted By peewee2you
Re: High Beams stick on.

Henry,

if possible why not try shrink wrap tubing, heat with a hair dryer, can't remember if those are bullet type connectors or male spades, if male spades not sure if you want to cut em off...
Forum: Early V8 (1932-53) 03-29-2016, 01:36 PM
Replies: 31
Poll: Repop Parts
Views: 4,200
Posted By peewee2you
Re: Repop Parts

Imagine if no parts were reproduced, the cost we'd have to put out to get even a good useable part would be thru the roof. I'm happy to work with a part of good quality even if they are made in a...
Forum: Early V8 (1932-53) 02-15-2016, 02:21 PM
Replies: 102
Views: 7,881
Posted By peewee2you
Re: Goodbye Little Pepe

Old Henry, My apologies I'm a little late on this news of little Pepe's passing as I have many cars and tend to climb into that particular one at the time, and only check in from time to time on the...
Forum: Early V8 (1932-53) 01-27-2016, 06:17 PM
Replies: 78
Views: 5,704
Posted By peewee2you
Re: Start the "happy birthday" wishes for walt dupont !

Walt, Happy 80th have a wonderful day... :)
Forum: Early V8 (1932-53) 11-02-2015, 07:56 PM
Replies: 18
Views: 1,940
Posted By peewee2you
Re: Starting problems

Listen to Bubba and it's the cheaper of the two, I have a 47 Ford for most part original and had same experience when heated up...
Forum: Early V8 (1932-53) 06-12-2015, 05:05 PM
Replies: 6
Views: 1,090
Posted By peewee2you
Re: What program do you guys use >>>

www.picturetrail.com (http://www.picturetrail.com) it's free to sign up and provides the url info to copy and paste
Forum: Early V8 (1932-53) 06-06-2015, 04:58 PM
Replies: 53
Views: 9,285
Posted By peewee2you
Re: cost of a paint job?

if budget is a concern, Maaco is not a bad idea, more than a few times I asked folks where did you get that paint job and to my suprise Maaco? and I was only asking because a really nice paint job,...
Forum: Early V8 (1932-53) 06-05-2015, 02:40 PM
Replies: 23
Views: 3,300
Posted By peewee2you
Re: Another Walt Dupont Engine Running!

2935 Ford, are those head bolts holding the head down? don't see studs is ti the lighting.. sounds great and looks real nice.
Forum: Early V8 (1932-53) 05-30-2015, 12:45 PM
Replies: 54
Views: 6,627
Posted By peewee2you
Re: The coupe is out of commission

Hello, I'm in the same position as Scott Wheaton, my family know's I'm a car guy and I'm 60 have had somewhere's in the neighborhood of 60+ over my span since I was 17yrs old. That being said...
Forum: Early V8 (1932-53) 05-27-2015, 07:04 PM
Replies: 48
Views: 5,213
Posted By peewee2you
Re: Birds in my shop

Take some old cd's or dvd's or blanks, tie fishline thru them hang them hanging down at various heights, around rafters or ceilings spread around. See if that might work they will spin with the...
Forum: Early V8 (1932-53) 05-27-2015, 06:58 PM
Replies: 23
Views: 3,663
Posted By peewee2you
Re: Henry with a pretty thing

That truck really brings out the beauty in that gal, don't get rid of the truck.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:55 PM.