Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 94
Search took 0.01 seconds.
Search: Posts Made By: 39deluxecp
Forum: Early V8 (1932-53) 11-17-2020, 10:18 AM
Replies: 1
Views: 157
Posted By 39deluxecp
60hp oil pan interchange

I have a rebuilt 1940 ford long block. I need a oil pan for it. Will a 1937-1939 oil pan work? Thanks Henry
Forum: Early V8 10-28-2020, 10:16 AM
Replies: 0
Views: 745
Posted By 39deluxecp
Rebuilt 60 hp engine

I have a completely rebuilt 1940 60 horse engine. It has the long snout crank and bigger bearings. Call 712-579-0447
Forum: Early V8 10-10-2020, 07:45 PM
Replies: 0
Views: 200
Posted By 39deluxecp
60 HP Ford v8 parts wanted

Need parts for my 60 hp flathead engine. Oil pan, fuel pump, carburetor, crank pulley and crank mounted fan. Generator also.



Call me at 712-579-0447 Henry. Thanks
Forum: Late V8 08-27-2020, 03:14 PM
Replies: 0
Views: 238
Posted By 39deluxecp
1955 t-bird for sale

Frame off restoration. 351 Cleveland and C4. Call 712-579-0447 or message me.
Forum: Late V8 (1954+) 07-31-2020, 09:04 PM
Replies: 5
Views: 441
Posted By 39deluxecp
Stop light switch used for safety starter switch?

Why not use the hydraulic brake stoplight switch for the safety starter switch?. Just connect the wires for the starter solenoid through the brake switch. Then the brake pedal will have to be...
Forum: Late V8 (1954+) 07-31-2020, 08:50 PM
Replies: 15
Views: 665
Posted By 39deluxecp
Re: 1956 Thunderbird brake question

There are smaller diameter boosters available that should clear the battery. I would check in to one with dual booster diaphragms.
Forum: Late V8 (1954+) 07-26-2020, 04:21 PM
Replies: 42
Views: 2,723
Posted By 39deluxecp
Re: 351c miss/backfire under load?

I am going to go back to the original jets, then set the timing, and carb.i bought a new 750 Holley so that when I replace this 351 with the 408 stroker I am replacing it with next winter the carb...
Forum: Late V8 (1954+) 07-26-2020, 12:27 PM
Replies: 42
Views: 2,723
Posted By 39deluxecp
Re: 351c miss/backfire under load?

Hallalua!! I found the missfire at full throttle problem!

asked my son what he thought might be causing the backfire and loss of power under load. He crawled under the car to check the fuel lines...
Forum: Late V8 (1954+) 05-30-2020, 03:05 PM
Replies: 23
Views: 1,321
Posted By 39deluxecp
Re: idle adjusting needles

if it does not affect the idle, the idle passages are plugged
Forum: Late V8 (1954+) 05-30-2020, 03:04 PM
Replies: 20
Views: 1,690
Posted By 39deluxecp
Re: Y block fuel pump

must be a stuck or inoperative check valve in the pump.
Forum: Late V8 (1954+) 05-06-2020, 06:45 PM
Replies: 42
Views: 2,723
Posted By 39deluxecp
Re: 351c miss/backfire under load?

I ty it was stale gas.
Forum: Late V8 (1954+) 05-05-2020, 02:25 PM
Replies: 9
Views: 473
Posted By 39deluxecp
Re: 57 fairlane 4dr

yes, most of the "57 parts will fit the "55. Not all. one is 6 volt, other 12 volt as I am sure you know. I would jump on it, not many parts cars fpr 55-57 fprds, we raced the hell out of them on our...
Forum: Early V8 (1932-53) 05-05-2020, 02:18 PM
Replies: 22
Views: 1,127
Posted By 39deluxecp
Re: Valve Spring Shim Question

if the valve seats are cut too far down, makes everything else lots harder to do. it the block needs new seats, better to do it.
Forum: Early V8 05-01-2020, 03:42 PM
Replies: 0
Views: 210
Posted By 39deluxecp
1939 ford deluxe windshield frame

rust in lower outer corners. 1 good glass, other is cracked. plus shipping. Thanks Ford Barn.
Forum: Late V8 (1954+) 05-01-2020, 03:19 PM
Replies: 42
Views: 2,723
Posted By 39deluxecp
Re: 351c miss/backfire under load?

E85 to the rescue!!! after a new 180* edelbrock manifold, bigger (92) jets in the primary and secondary , new autolite 26 plugs, various timing adjustments, I put in a half tank of good old E85 to...
Forum: Late V8 (1954+) 04-30-2020, 03:12 PM
Replies: 42
Views: 2,723
Posted By 39deluxecp
Re: 351c miss/backfire under load?

Just wanted to give an update. I replaced the sparkplugs with autolite 26 , which is 2 heat ranges hotter than the 24 that were in it. Ran much better, but it is still cutting out at higher load and...
Forum: Late V8 (1954+) 04-27-2020, 11:01 AM
Replies: 16
Views: 946
Posted By 39deluxecp
Re: dif gear ratio

I like 4.11
Forum: Late V8 (1954+) 04-25-2020, 03:28 PM
Replies: 24
Views: 1,392
Posted By 39deluxecp
Re: Which PS fluid

IHC hytrans fluid
Forum: Late V8 (1954+) 04-25-2020, 03:23 PM
Replies: 5
Views: 459
Posted By 39deluxecp
Re: oil flow

The pushrods are hollow on a Chevy at supply oil to the rockers. 272 has no oil passage in pushrods.
Forum: Late V8 (1954+) 04-21-2020, 06:31 PM
Replies: 7
Views: 560
Posted By 39deluxecp
Re: 64 Galaxie rear brake cylinder

This station wagon and 427 engined cars had bigger brake than a cheep 6 banger custom
Forum: Late V8 (1954+) 04-21-2020, 06:24 PM
Replies: 10
Views: 723
Posted By 39deluxecp
Re: 351 cleveland engine

All the same pump
Forum: Late V8 (1954+) 04-19-2020, 09:50 AM
Replies: 42
Views: 2,723
Posted By 39deluxecp
Re: 351c miss/backfire under load?

I have used this distributor before and it worked fine. If I had another distributor I would try it.i do believe it is ignition.buying all new duraspark components runs into a few bucks to. I have...
Forum: Late V8 (1954+) 04-18-2020, 08:19 PM
Replies: 42
Views: 2,723
Posted By 39deluxecp
Re: 351c miss/backfire under load?

Keeps me out of the bars!!!
Forum: Late V8 (1954+) 04-18-2020, 06:57 PM
Replies: 3
Views: 430
Posted By 39deluxecp
Re: How to adjust a HOLLY 4 BARREL CARB

If the choke is not opening all the way, it may be stuck on high idle cam
Forum: Late V8 (1954+) 04-18-2020, 06:00 PM
Replies: 42
Views: 2,723
Posted By 39deluxecp
Re: 351c miss/backfire under load?

Sorry for the delay. Been too cold to mess with the car.tbe distributor is a cheep $50.00 self contained with the module in the distributor.i have checked and re checked float level, timing, vacuum...
Showing results 1 to 25 of 94

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:03 AM.