Forum: Late V8 (1954+)
02-08-2024, 03:41 PM
|
Replies: 13
Views: 707
Re: Under hood Insulation
The 19-49 Ford factory parts manual does not show insulation used in the hood, only a a extrusion that is installed on the cowl to seal the hood to the cowl.
|
Forum: Late V8 (1954+)
05-28-2023, 10:28 AM
|
Replies: 4
Views: 706
Re: Yblock help - MN
Josh,
I live between Lakeville, Prior Lake.
I have a 56 Ford Victoria.
I've been working on cars for over 50 years and I have a lot of Y block parts around the shop. I have a Fordomatic on my...
|
Forum: Late V8 (1954+)
01-20-2023, 02:22 PM
|
Replies: 13
Views: 1,734
|
Forum: Late V8 (1954+)
01-19-2023, 07:23 PM
|
Replies: 13
Views: 1,734
|
Forum: Late V8 (1954+)
11-15-2022, 03:23 PM
|
Replies: 40
Views: 3,704
Re: Timing at full advance?
Ron,
I think you really need to use a troubleshooting process that starts with a guess (hypothesis) and then use a test that tells you if you are right or wrong.
You think the harmonic...
|
Forum: Late V8 (1954+)
11-12-2022, 12:50 PM
|
Replies: 40
Views: 3,704
Re: Timing at full advance?
Ron,
Some thoughts.
The info SCIALA just posted is the best procedure when checking total timing.
Your engine ID plate confirms it's an industrial engine. Most, if not all, industrial...
|
Forum: Late V8 (1954+)
09-28-2022, 09:30 PM
|
Replies: 22
Views: 2,432
|
Forum: Late V8 (1954+)
08-01-2022, 08:32 PM
|
Replies: 25
Views: 3,795
|
Forum: Late V8 (1954+)
08-01-2022, 06:38 PM
|
Replies: 25
Views: 3,795
Re: 1956 Victoria overdrive
DaveBPT,
I agree with the previous posters that the T85 transmission is stronger than the T86.
I don't believe however that the T85 was used in the 1956 passenger car behind the 312.
I am...
|
Forum: Late V8 (1954+)
07-29-2022, 04:05 PM
|
Replies: 113
Views: 14,051
|
Forum: Late V8 (1954+)
05-01-2022, 02:06 PM
|
Replies: 26
Views: 2,894
Re: 1954 239 distributer
Here is a link to the removal tool. Last posts on page 2.
https://www.fordbarn.com/forum/showthread.php?t=299011&page=2
|
Forum: Late V8 (1954+)
04-21-2022, 07:46 PM
|
Replies: 21
Views: 2,072
Re: 1959 Mercury Monterey 312 2v Ballast Resistor
You have part of it right, but we need to modify somewhat.
As a number of posters have mentioned, the ballast resistor is basically taken out of the ignition circuit during cranking by the starter...
|
Forum: Late V8 (1954+)
04-21-2022, 03:51 PM
|
Replies: 21
Views: 2,072
Re: 1959 Mercury Monterey 312 2v Ballast Resistor
Stephenorf,
The reason it's called a ballast resistor is they are used to stabilize current flow in a device.
I believe the "normal" resistor your referring to is typical electronic resistor and...
|
Forum: Late V8 (1954+)
04-19-2022, 09:44 PM
|
Replies: 21
Views: 2,072
|
Forum: Late V8 (1954+)
04-18-2022, 01:17 PM
|
Replies: 12
Views: 1,166
Re: New regulator problems
delco1946,
Are you sure the belt is tight? It could be slipping enough so that at idle the voltage is low enough to turn on the light.
Don
|
Forum: Late V8 (1954+)
04-11-2022, 10:15 AM
|
Replies: 13
Views: 1,590
|
Forum: Late V8 (1954+)
04-10-2022, 10:29 PM
|
Replies: 13
Views: 1,590
Re: A mystery water pump pulley?
dmsfrr,
Did you see this one on ebay? It looks just like the one in your pic, and it has the same part number, but unfortunately there isn't anything that would confirm it's actually for a...
|
Forum: Late V8 (1954+)
01-23-2022, 03:40 PM
|
Replies: 12
Views: 1,033
Re: '52 F-1 Engine Swap
Looks like a great candidate for a "mechanical" restoration. Solid body, nice patina, and a Y block to make freeway driving easier.
IMO you are doing the right thing.
Take a look at the bottom...
|
Forum: Late V8 (1954+)
12-11-2021, 02:09 PM
|
Replies: 72
Views: 12,906
|
Forum: Late V8 (1954+)
12-10-2021, 02:39 PM
|
Replies: 72
Views: 12,906
|
Forum: Late V8 (1954+)
10-20-2021, 07:22 PM
|
Replies: 113
Views: 14,051
|
Forum: Late V8 (1954+)
09-23-2021, 03:23 PM
|
Replies: 32
Views: 3,012
Re: '56 Country Sedan Overheating
tsanborn,
This is a bit puzzling. You had an engine rebuilt that was not overheating, and added some modifications to reduce potential overheating, and now it overheats.
Dmsfrr’s suggestion of...
|
Forum: Late V8 (1954+)
09-21-2021, 10:08 PM
|
Replies: 32
Views: 3,012
Re: '56 Country Sedan Overheating
[ in the high 70s to low 80s, the engine temperature climbs above the gauge range and will continue to peg on hot if I don't shut it down. ]
Has it gotten hot enough to blow out antifreeze? You...
|
Forum: Model A (1928-31)
09-14-2021, 05:11 PM
|
Replies: 34
Views: 4,532
Re: Four Post Lift Recommendations….
Same problem. Getting just too hard to get down and up from a creeper.
Just bought and installed an Advantage lift about three months ago. Quality is good. Welds seemed good, and paint is good. I...
|
Forum: Late V8 (1954+)
08-22-2021, 10:03 PM
|
Replies: 27
Views: 3,814
Re: Heating up a block to get stuck dizzy out
Jim,
I haven't tried it in a car, but I built it as small as possible just so it would. I haven't had a chance try it on my 56, but hopefully will this week.
It definitely works great on engines...
|