Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.04 seconds.
Search: Posts Made By: marko39
Forum: Early V8 (1932-53) Yesterday, 10:36 AM
Replies: 1
Views: 114
Posted By marko39
Re: center Grille trim moulding

That doesn't appear to be a Ford piece. There have been several repros of this piece. Should have a 91a part number.
Forum: Early V8 (1932-53) 10-16-2021, 01:01 PM
Replies: 10
Views: 412
Posted By marko39
Re: 1934 ford bb truck

This is a good excuse to get a "parts truck"
Forum: Early V8 (1932-53) 10-16-2021, 12:48 PM
Replies: 4
Views: 310
Posted By marko39
Re: Granada engine noise

You may have a better chance of a reply on the late v8 forum.
Forum: Early V8 10-16-2021, 12:43 PM
Replies: 0
Views: 72
Posted By marko39
39-40 running board covers

Nors. Covers for 39 deluxe and 40 car. Bought years ago and never used. For the budget minded, 100.00 plus shipping. Can email pics. Mark
Forum: Early V8 (1932-53) 10-12-2021, 12:34 PM
Replies: 10
Views: 380
Posted By marko39
Re: Worn Clutch and Brake Pedal/Spring Pins?

The speedometer gear chart can be found in the Green Bible page 632
Forum: Early V8 (1932-53) 10-12-2021, 11:42 AM
Replies: 26
Views: 1,072
Posted By marko39
Re: 59AB advice on "new" flathead

I would want to also check the valve springs after sitting so long.
Forum: Early V8 (1932-53) 10-12-2021, 07:11 AM
Replies: 7
Views: 429
Posted By marko39
Re: Resistor installation

on my 39 i mounted resistor right on coil using the coil nut to hold it.
Forum: Early V8 (1932-53) 10-09-2021, 11:54 AM
Replies: 78
Views: 3,794
Posted By marko39
Re: A few questions on a 8BA

Looks like it had a little water in its oil at some time. I would clean it up better and put it back in the block where you can check it with plastigauge to check clearance.
Forum: Early V8 (1932-53) 10-09-2021, 07:49 AM
Replies: 78
Views: 3,794
Posted By marko39
Re: A few questions on a 8BA

check the fingers on pressure plate to see that they are equal. there is an exact adjustment that can be found in the old Motor manual.
Forum: Early V8 (1932-53) 10-08-2021, 01:25 PM
Replies: 15
Views: 656
Posted By marko39
Re: 1953 f100

I would soak it for 12 hours and check it. Use a box of baking soda mixed with 2 gallons of water to neutralize. I would get a gallon of metal prep from Bill Hirsh and use this to prevent flash...
Forum: Early V8 (1932-53) 10-08-2021, 12:23 PM
Replies: 26
Views: 686
Posted By marko39
Re: 1938 Tudor Windshield

If you're intent on getting it open, you can disconnect the mechanism to prevent damage.You have to remove inside garnish to get to the mechanism arms. I have the opposite problem, getting it to...
Forum: Early V8 (1932-53) 10-08-2021, 07:14 AM
Replies: 19
Views: 800
Posted By marko39
Re: Removing the Flywheel

in my opion that is the best way the ujoint will be the only connection to make.
Forum: Early V8 (1932-53) 10-07-2021, 01:05 PM
Replies: 19
Views: 800
Posted By marko39
Re: Removing the Flywheel

If all you want to do is replace pilot bearing, you can borrow a puller from autozone ,easy.
Forum: Early V8 (1932-53) 10-07-2021, 07:12 AM
Replies: 19
Views: 800
Posted By marko39
Re: Removing the Flywheel

is your oil pan off?
Forum: Early V8 (1932-53) 10-05-2021, 01:09 PM
Replies: 11
Views: 661
Posted By marko39
Re: 2nd battery question for electric guru's

I have a heavy old charger that charges at 12,24, and 32 volts. I have hooked 2 12 volt and one 8 volt in series and they charged fine with charger set to 32 volts. I figured it was the only way to...
Forum: Early V8 (1932-53) 10-05-2021, 11:40 AM
Replies: 8
Views: 323
Posted By marko39
Re: 40 tudor replacement quarter glass

Pay close attention as where the glass sits in the channel. If new glass is not exactly positioned as the old, problems will arise when installed to regulator.
Forum: Early V8 (1932-53) 10-04-2021, 10:23 AM
Replies: 11
Views: 320
Posted By marko39
Re: windshield chrome trim

If you are talking about the windshield frame you will need to have it replated, not inexpensive. After getting prices 20 years ago I decided to paint mine since I was not building a show car.
Forum: Early V8 (1932-53) 10-03-2021, 10:40 AM
Replies: 10
Views: 293
Posted By marko39
Re: 1942 Ford Super Deluxe Door Handle Escutcheon

Did you try it without the spring? On my 39 there was no way I could get pin in with spring. Aftermarket escutcheons. Without the spring they are fine and was still a battle to get the pin in.
Forum: Early V8 (1932-53) 09-29-2021, 10:14 AM
Replies: 16
Views: 820
Posted By marko39
Re: 1939 Ford Deluxe Vert STUCK in Reverse

You could try rocking the car to remove any load present but you may have to remove trans. top to free it and see if anything looks wrong. Problem may be in shift tower if you're lucky.
Forum: Early V8 (1932-53) 09-26-2021, 09:22 AM
Replies: 656
Views: 43,701
Posted By marko39
Re: 1932 The Deuce, Dually, Dump Truck

We used these belts in the hvac trade as a temporary fix when a belt was needed. They did seem to last at least until the correct belt was installed.
Forum: Early V8 (1932-53) 09-16-2021, 07:27 AM
Replies: 26
Views: 7,136
Posted By marko39
Re: Naphtha for cleaning carbs and fuel pumps

i have a gallon of carb cleaner made by Gunk. Comes with a basket and works well but may not be available in all states. second best is acetone.
Forum: Early V8 (1932-53) 09-09-2021, 01:05 PM
Replies: 13
Views: 625
Posted By marko39
Re: remove surface rust on transmission gears

A gallon of muratic acid is cheap, works fast and is smelly. be sure to degrease first and neutralize with baking soda after.
Forum: Early V8 (1932-53) 09-07-2021, 01:13 PM
Replies: 21
Views: 1,443
Posted By marko39
Re: The 1BA block Mystery What's the Story ?

For what it's worth, my 51 block does not have the hardened seats. I had them installed on the exhaust only.
Forum: Early V8 (1932-53) 09-06-2021, 07:31 AM
Replies: 18
Views: 727
Posted By marko39
Re: 1934 Ford Trouble Starting

the best way is to have dist. set up on a machine. there are members of this forum who can do this for you.
Forum: Early V8 (1932-53) 09-05-2021, 09:49 AM
Replies: 18
Views: 727
Posted By marko39
Re: 1934 Ford Trouble Starting

Sounds like timing is off.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:57 PM.