Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: Tom Wesenberg
Forum: Model A (1928-31) 10-12-2017, 11:06 PM
Replies: 21
Views: 4,374
Posted By Tom Wesenberg
Re: Checking rear ratio

Was the other wheel locked from any turning? If it didn't turn at all, then you have a 2.75 rear end ratio, but that can't be.
Are you sure it wasn't 3 and 3/4 turns, which is the standard 3.78...
Forum: Model A (1928-31) 09-19-2017, 09:07 AM
Replies: 21
Views: 4,374
Posted By Tom Wesenberg
Re: Checking rear ratio

Yep, sounds like you have the 4.11 ring and pinion. I can trade you a 3.78 for it if you want.
Forum: Model A (1928-31) 05-19-2017, 11:12 AM
Replies: 21
Views: 4,374
Posted By Tom Wesenberg
Re: Checking rear ratio

Jack up only one rear wheel, put the tranny in high gear. Mark the tire and ground, then hand crank the engine. If you have to crank the engine just a little over 4 full turns to make the tire turn...
Forum: Model A (1928-31) 05-19-2017, 06:07 AM
Replies: 21
Views: 4,374
Posted By Tom Wesenberg
Re: Checking rear ratio

You asked the same question yesterday and got an answer.
Showing results 1 to 4 of 4

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:22 AM.