Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: quickchange
Forum: Model A (1928-31) 02-11-2019, 01:16 PM
Replies: 6
Views: 430
Posted By quickchange
Re: Need help identifying this Ford Hubcap

Jim , yes but it must be from a gear driven cam , ie an early ford 8 or 10 hp as later ones chain driven cam , rotation the other way ,
Forum: Model A (1928-31) 02-10-2019, 11:52 PM
Replies: 6
Views: 430
Posted By quickchange
Re: Need help identifying this Ford Hubcap

correct Justin, might have some,
Forum: Model A (1928-31) 02-04-2019, 03:45 AM
Replies: 19
Views: 1,006
Posted By quickchange
Re: Blown HG results

Use a copper head gasket , spray with copper coat ,too many failures with the one you used,
Forum: Model A (1928-31) 02-03-2019, 07:49 PM
Replies: 6
Views: 522
Posted By quickchange
Re: Turlock CA 2019 Swap Meet Coverage

Yes thanks enjoyed the tour , Hoping big 3 one will have some goodies like that,
Forum: Model A (1928-31) 01-26-2019, 05:51 PM
Replies: 6
Views: 450
Posted By quickchange
Re: 31 delux roadster folding windshield AGAIN

Do you have an original dash rail ? could this be the problem ? lead shims under the lower stanchion mounts ?
Forum: Model A (1928-31) 01-22-2019, 03:31 AM
Replies: 8
Views: 520
Posted By quickchange
Re: Distributor Drive

Easy fix , take side plat off, flick the spring out then remove the drive & fit one with a tongue as it should be , that way if you ever want to change the dizzy on the road or anywhere you can ,...
Forum: Model A (1928-31) 01-22-2019, 03:24 AM
Replies: 16
Views: 839
Posted By quickchange
Re: Squealing engine

So as the winner when do I receive my prize ?? Hot & dry in NZ
Forum: Model A (1928-31) 01-17-2019, 01:34 AM
Replies: 6
Views: 390
Posted By quickchange
Re: Starter hums will not turn engine over.

bendix spring broken or bolt sheared off , or pinion drive on starter need light lube after cleaning , pull the starter & check it ,
Forum: Model A (1928-31) 01-17-2019, 01:32 AM
Replies: 16
Views: 839
Posted By quickchange
Re: Squealing engine

After trying the above can be dry dissy shaft , belt slip , use candle wax or wd40 on belt,
Forum: Model A (1928-31) 01-17-2019, 01:30 AM
Replies: 62
Views: 3,409
Posted By quickchange
Re: OK! Oldtimers, Gimme your best answer, Stuck Engine

The fact that it ran for 30 seconds more than once may suggest more than one problem , 1st problem sounds like fuel ,now its locked up could be a separate problem like starter bolt jammed fly wheel...
Forum: Model A (1928-31) 01-13-2019, 09:10 PM
Replies: 12
Views: 916
Posted By quickchange
Re: Rear Main Bearing Oil Behavior

I found most of the leak happens once one stops, ( the sump fills up with its oil ) How many have seen how much oil is in the sump when engine running ? the end of the drain pipe is out of the oil I...
Forum: Model A (1928-31) 01-11-2019, 08:22 PM
Replies: 18
Views: 653
Posted By quickchange
Re: Original v. Reproduction Wind Wing Brackets

When we get the glass cut , to the pattern supplied or your pattern ,the glass man drills it for you, Lets hope by complaining to companies they will improve their product, But we need to make all...
Forum: Model A (1928-31) 01-11-2019, 02:30 PM
Replies: 18
Views: 653
Posted By quickchange
Re: Original v. Reproduction Wind Wing Brackets

Re repo w/w brackets, never had a problem , Mount ,draw lie on glass around top bracket, remove glass , drill 1/8hole through glass , Now with out drilling right through drill hole on inside of...
Forum: Model A (1928-31) 12-28-2018, 03:07 PM
Replies: 11
Views: 614
Posted By quickchange
Re: LA members

Two Kiwis will be over too, San Diego, - Az we could even carry them home for you, Might not see them again , Lawrie Any chance of meeting up, ???
Forum: Model A (1928-31) 12-16-2018, 10:26 PM
Replies: 4
Views: 609
Posted By quickchange
Re: Front wheels offset

Guards the same, Check front u bolts pos loose BUT if correct center bolt in spring it locates into square hole in cross member, Something not right, Derek on other side of the strait,
Forum: Model A (1928-31) 12-15-2018, 08:35 PM
Replies: 21
Views: 981
Posted By quickchange
Re: Tire sizes again for 16"

Joop what was the cost to cut , weld, powder coat as a matter of interest,
Forum: Model A (1928-31) 12-15-2018, 08:33 PM
Replies: 21
Views: 981
Posted By quickchange
Re: Tire sizes again for 16"

205 x 80 8ply radials cockies here remove from Toyota Nissan utes & fit mud grips we buy with delivery miles only $25 kiwi $16-50 usd, each .ok on 35 v8 wires ,
Forum: Model A (1928-31) 12-14-2018, 10:51 PM
Replies: 4
Views: 522
Posted By quickchange
Re: Model A s in Reno area.

Great bunch of folk there even make Kiwis very welcome , Joe Callahan Carson city now set up to help repair & advise owners ,
Forum: Model A (1928-31) 12-14-2018, 10:47 PM
Replies: 15
Views: 899
Posted By quickchange
Re: king pin fit

yes no problem & will be tight due to the shrinkage , just clean up the weld which is hidden anyway buy the stub & paint , Had to do a number over the years , 26c here,
Forum: Model A (1928-31) 12-14-2018, 06:02 PM
Replies: 15
Views: 899
Posted By quickchange
Re: king pin fit

If the k/pin is loose in axel eye can be fixed ,PUT the KING PIN in the axel, run a vertical run with arc welder down outside of the eye , MAKE sure the pin is in otherwise will shrink to far & you...
Forum: Model A (1928-31) 12-10-2018, 07:43 PM
Replies: 46
Views: 2,515
Posted By quickchange
Forum: Model A (1928-31) 12-07-2018, 06:30 PM
Replies: 190
Views: 7,883
Posted By quickchange
Re: OK! Let's get personal!

Not as good as I once was, but as good once as ever I was ,coming 75 But an injection of salt fever few years ago Has turned the clock backwards, So counting down instead of up , Summer time in...
Forum: Model A (1928-31) 12-03-2018, 04:00 PM
Replies: 14
Views: 744
Posted By quickchange
Re: How does the top work on my Roadster Pickup?

Steve, Front bow held to stanchion by th two wingnuts, But front bow also has a flap which is part of the top, buttons on front of screen , Originally top fitted under the wood strip on back of cab...
Forum: Model A (1928-31) 11-26-2018, 01:38 PM
Replies: 18
Views: 1,419
Posted By quickchange
Re: Sue Mitchell

So sorry to hear of this , Great lady & friend, spent time with her at the Reno meet in June , also called in to see her in April , We will miss her, Derek & Jude in NZ,
Forum: Model A (1928-31) 11-24-2018, 07:17 PM
Replies: 9
Views: 665
Posted By quickchange
Re: Model B oil filler

Arizona Model A Has them ,
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:53 AM.