Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: runewilliam_merc
Forum: Early V8 (1932-53) 01-04-2019, 12:26 PM
Replies: 5
Views: 444
Posted By runewilliam_merc
Re: mighty wiper

I Will continue to use my belt driven GM 6.2 diesel vacuum pump and lube my vacuum Wiper motor as spesified in the 1952-1954 Ford repair manual. Instead of complicating the electrical system and...
Forum: Early V8 (1932-53) 12-30-2018, 03:14 PM
Replies: 36
Views: 1,439
Posted By runewilliam_merc
Re: Penetrating oil-what is best

If I have "all the time in the world", if I see a rusty screw that I plan to remove Next year or so, I will use chassis grease.

If I have less time, I will use chain spray for forklift chains....
Forum: Early V8 (1932-53) 11-28-2018, 11:54 AM
Replies: 11
Views: 442
Posted By runewilliam_merc
Re: 1952 Keys

I bought a used trunk lid emblem(?) for my 1952 Mercury. I used a whole evening with a feeler gauge (0,05mm) and different wires to pick the lock, so that I could get the cylinder out. On the...
Forum: Model A (1928-31) 11-06-2018, 06:14 PM
Replies: 22
Views: 1,368
Posted By runewilliam_merc
Re: Stuck engine

Too bad the pistons are on TDC/bdc.
I took off the rocker arms om a Ford V4 once and machined a plug that would fit in the spark plug hole with a grease nipple.
Poured ATF oil in the cylinder and...
Forum: Early V8 (1932-53) 09-22-2018, 04:02 PM
Replies: 18
Views: 692
Posted By runewilliam_merc
Re: After polarity change with 12v conversion the heater becomes an air conditioner

Hi!

Om my 1952 Mercury Custom, I went to my local Mustang parts dealer with the 6v defroster assembly. The guy behind the counter looked at it for about five seconds, put his hand into a shelf,...
Forum: Early V8 (1932-53) 09-22-2018, 02:11 AM
Replies: 5
Views: 346
Posted By runewilliam_merc
Master sylinder for 1952 Mercury

Hi!

I have a 1952 Mercury Custom.
To upgrade safety, I would like a dual bowl(?) master cylinder.

I have searched the web as good as I can, but haven't been able to find one.

The bore is...
Showing results 1 to 6 of 6

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:34 AM.