Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: Gary WA
Forum: Model A (1928-31) Yesterday, 07:58 PM
Replies: 6
Views: 251
Posted By Gary WA
Re: Body Shudder - Rear Motor Mounts

What type front motor mount? and is it worn out ,springs etc?Flywheel housing alignment? Is this a new engine (miles), just start doing or been going on for a while? Many variables?
Forum: Model A (1928-31) Yesterday, 11:37 AM
Replies: 13
Views: 437
Posted By Gary WA
Re: New Guy

Welcome Back!
Forum: Model A (1928-31) 01-19-2019, 09:46 PM
Replies: 4
Views: 400
Posted By Gary WA
Re: Best head gasket

My take Copper Only! I have had 3 graphite fail with proper torques,flat head and block. I just don't care for them,But that's me.
Forum: Model A (1928-31) 01-17-2019, 08:36 PM
Replies: 6
Views: 357
Posted By Gary WA
Forum: Model A (1928-31) 01-17-2019, 08:33 PM
Replies: 7
Views: 435
Posted By Gary WA
Forum: Model A (1928-31) 01-16-2019, 08:58 PM
Replies: 6
Views: 357
Posted By Gary WA
Re: Starter hums will not turn engine over.

Thanks for the update- Simple things first, Enjoy your A!
Forum: Model A (1928-31) 01-15-2019, 10:23 PM
Replies: 2
Views: 228
Posted By Gary WA
Re: WTB - International Model A Day Patches 2018

I have 11 if you want them? I'll send you email to exchange addresses.Let me know
Forum: Model A (1928-31) 01-15-2019, 10:16 PM
Replies: 12
Views: 671
Posted By Gary WA
Re: Engine Water Jacket Cleaning

I have used a piece of speedometer cable,about 2 feet long, Model A of course, in a drill, going in and out of all holes in block, also used on heads to clean, air compressor,and I have a set of...
Forum: Model A (1928-31) 01-15-2019, 10:11 PM
Replies: 10
Views: 485
Posted By Gary WA
Re: Shock fluid substitute

Hydraulic jack oil too!!
Forum: Model A (1928-31) 01-15-2019, 04:54 PM
Replies: 22
Views: 758
Posted By Gary WA
Re: Starter hums will not turn engine over.

low voltage battery,or ground
Forum: Model A (1928-31) 01-13-2019, 07:30 PM
Replies: 2
Views: 268
Posted By Gary WA
Re: 31 late model carburetor

All Jets one washer,Float valve may need 2 for height adjustment, but rarely,Idle jet no washers! No washer on the venture, and should fit easily. And make sure to look in jet holes for old gaskets.
Forum: Model A (1928-31) 01-13-2019, 03:10 PM
Replies: 3
Views: 286
Posted By Gary WA
Re: exterior colors

Need year and type vehicle?
Forum: Model A (1928-31) 01-13-2019, 03:06 PM
Replies: 4
Views: 249
Posted By Gary WA
Re: '31 Horn Button Trim Ring

Both the lever and horn button were chrome plated, all spark and throttle rods were bright nickel plated. in 1930-31 the horn button was bakelite and the switch lever and horn bezel (retaining ring)...
Forum: Model A (1928-31) 01-12-2019, 10:01 PM
Replies: 7
Views: 540
Posted By Gary WA
Re: The Can-Am Model A Reliability Run;"Mt. Hood A-dventure"

Hello Benny, Sounds Good will try to make it! Mt Baker was Great!
Forum: Model A (1928-31) 01-12-2019, 09:58 PM
Replies: 25
Views: 1,235
Posted By Gary WA
Re: Ignition, way of

Welcome to the Model A World! visit Model A Basics site above- post #5
Forum: Model A (1928-31) 01-12-2019, 09:57 PM
Replies: 25
Views: 1,235
Posted By Gary WA
Re: Ignition, way of

http://modelabasics.com/home.htm
Forum: Model A (1928-31) 01-11-2019, 09:40 PM
Replies: 1
Views: 357
Posted By Gary WA
Re: 1928 model a for sale

Also place in swap meet section above.
Forum: Model A (1928-31) 01-11-2019, 09:37 PM
Replies: 5
Views: 308
Posted By Gary WA
Re: Zenith mystery again.

Do Not Seal inside Carb!All jets need one gasket, except Idle Jet, and properly tightened. If the Carbs have not been used and dry The Carbs will absorb gas into the metal of the carb. I have never...
Forum: Model A (1928-31) 01-10-2019, 06:25 PM
Replies: 20
Views: 1,009
Posted By Gary WA
Re: Common Wealth Engines

Engine Green as per JS
Forum: Model A (1928-31) 01-06-2019, 12:53 PM
Replies: 3
Views: 287
Posted By Gary WA
Restamped fire wall late 31 widebed

Incase your interested? Late 31 Roadster PU Restamped Firewall verses 31 Firewall.
Forum: Model A (1928-31) 01-05-2019, 10:11 PM
Replies: 10
Views: 550
Posted By Gary WA
Re: Zenith 2 mystery

No Sealer! Check float Height?Make sure all jets are tight with washers. no washer on ldle jet.http://modelabasics.com/home.htm
Forum: Model A (1928-31) 01-04-2019, 09:47 PM
Replies: 10
Views: 473
Posted By Gary WA
Forum: Model A (1928-31) 01-04-2019, 09:45 PM
Replies: 4
Views: 242
Posted By Gary WA
Re: Windshield Wiper

Car Model Year would help? thanks
Forum: Model A (1928-31) 01-02-2019, 09:57 PM
Replies: 31
Views: 1,323
Posted By Gary WA
Re: broken screws in oak, drill or give up?

I'd remove remaining screw parts any way you can-screw extractor etc,fill whole with a good glue epoxy and redrill for proper screw size. Chisel around screw or use dremmel tool then vise grips....
Forum: Model A (1928-31) 01-02-2019, 06:34 PM
Replies: 61
Views: 1,919
Posted By Gary WA
Re: Gas today-can you beat this?

$3.39 Still!!!??? Model A Gas here on Whidbey Island is probably highest in Nation>!!!
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:44 PM.