Forum: Model-A
08-23-2019, 07:58 PM
|
|
Replies: 4
Views: 1,980
|
|
Forum: Model-A
08-21-2019, 08:34 PM
|
|
Replies: 4
Views: 1,980
|
|
Forum: Model-A
08-20-2019, 09:06 PM
|
|
Replies: 4
Views: 1,980
|
|
Forum: Model-A
08-20-2019, 06:11 PM
|
|
Replies: 4
Views: 1,980
|
|
Forum: Model-A
08-19-2019, 05:22 PM
|
|
Replies: 4
Views: 1,980
|
|
Forum: Model-A
12-15-2014, 02:44 PM
|
|
Replies: 0
Views: 1,538
1931 Model A Deluxe Phaeton (180-A)
This is a very nice 1931 180A Deluxe Phaeton. It was owned by the same gentleman for over 30 years. When I acquired the car I had the fuel system cleaned and the carburetor rebuilt. The car was...
|
|
Forum: Model A (1928-31)
05-23-2014, 08:08 PM
|
|
Replies: 12
Views: 2,633
Head Flatness
I have a police head for my car (has a B cast in the top) and I measured the flatness on the bottom of the head with a straight edge and it is 5 thousands of an inch off in the center. Is this too...
|
|
Forum: Model A (1928-31)
05-10-2014, 01:55 PM
|
|
Replies: 10
Views: 2,053
Re: No Spark..this is ridiculous..need help
Well, I just tried running the hot wire into the distributor again and I get no spark!!! I dont see what is wrong. I also took the plate off of the distributor and everything looks fine inside, the...
|
|
Forum: Model A (1928-31)
05-10-2014, 01:00 PM
|
|
Replies: 10
Views: 2,053
No Spark..this is ridiculous..need help
I have no spark. The car has no spark at the points. I dont understand whats going on. I replaced the coil, I replaced the ignition switch and I have a brand new distributor..I ran a wire straight...
|
|
Forum: Model A (1928-31)
04-20-2014, 10:34 PM
|
|
Replies: 10
Views: 2,170
|
|
Forum: Model A (1928-31)
04-20-2014, 10:26 PM
|
|
Replies: 10
Views: 2,170
|
|
Forum: Model A (1928-31)
04-20-2014, 10:18 PM
|
|
Replies: 10
Views: 2,170
|
|
Forum: Model A (1928-31)
04-20-2014, 09:33 PM
|
|
Replies: 10
Views: 2,170
|
|
Forum: Model A (1928-31)
04-20-2014, 09:29 PM
|
|
Replies: 9
Views: 2,013
Re: New Distributor (Locating pin) doesn't fit
Thanks everyone for the great advise. I will try cleaning the hole first with some sand paper and if that doesn't work I think I will just file the pin until it fits. The pin on the new distributor...
|
|
Forum: Model A (1928-31)
04-20-2014, 10:53 AM
|
|
Replies: 9
Views: 2,013
New Distributor (Locating pin) doesn't fit
I purchased a brand new distributor for my car and the pin in the bottom of the distributor that fits into the top of the head is too large in diameter to fit into the hole in the head. So, my...
|
|
Forum: Model A (1928-31)
04-01-2014, 10:46 AM
|
|
Replies: 27
Views: 5,067
Re: Model T&A era only Car Show in CT
The T & A show is a great show that should not be missed if you like old Fords. I will be there this year with one of my cars. As for the HCCA Redding show, I am a board member of the Fairfield...
|
|
Forum: Model-A
09-22-2013, 06:25 PM
|
|
Replies: 1
Views: 1,439
|
|
Forum: Model-T
09-21-2013, 06:15 PM
|
|
Replies: 0
Views: 1,695
|
|
Forum: Model A (1928-31)
06-16-2013, 11:18 AM
|
|
Replies: 4
Views: 4,023
Re: How to remove lower distributor shaft
Gary, thanks for the quick response. Yea I just figured this out. It was just stuck so I took the valve cover off and grabed it from the underside and worked it out. :D
|
|
Forum: Model A (1928-31)
06-16-2013, 10:48 AM
|
|
Replies: 4
Views: 4,023
How to remove lower distributor shaft
I need to remove the lower distributor shaft on my 2 piece style distributor (the shaft that runs from the upper shaft to the oil pump drive gear). Can anone tell me how to go about doing this? How...
|
|
Forum: Model A (1928-31)
04-17-2013, 05:14 PM
|
|
Replies: 19
Views: 3,411
Need Help...Head is stuck
Does anyone have any good ideas on how to pull a stuck head off of the block? I am trying to change my head gasket/head and the old head is really on there. I have been soaking around the studs with...
|
|
Forum: Model A (1928-31)
04-04-2013, 03:32 PM
|
|
Replies: 41
Views: 25,295
Re: Installing emergency brake return springs
Does anyone have a picture of what they are supposed to look like when they are installed on the car? I dont understand how they go on. My car had the orignal springs on it and bothe were broken so I...
|
|
Forum: Model-T
03-27-2013, 12:30 AM
|
|
Replies: 1
Views: 1,044
|
|
Forum: Model-T
03-27-2013, 12:29 AM
|
|
Replies: 1
Views: 1,044
1917 Model T "Chicago Truckmobile"
I have a 1917 Model T "Chicago Truckmobile" for sale. Its a Model T kit that was sold originally to convert your car into a truck. Very interesting truck. I don't know much about this specific...
|
|
Forum: Model A (1928-31)
03-26-2013, 04:51 PM
|
|
Replies: 25
Views: 7,280
Re: Original Quail Cap Value
I bought the cap! Thanks for all the info. It did end up being an original stanco and I paid $75.00. It is in perfect condition for my car. It has a fiew pits, but thats it and its already on my car....
|
