Forum: Model A (1928-31)
04-08-2018, 07:03 PM
|
Replies: 7
Views: 1,471
|
Forum: Model A (1928-31)
04-07-2018, 09:07 PM
|
Replies: 7
Views: 1,471
|
Forum: Model A (1928-31)
04-07-2018, 06:42 PM
|
Replies: 7
Views: 1,471
Throttle rod length?
Just got a new set of control rods for 1930 coupe. The old ones were bent up a lot. The spark rod (17") and carb rod (10.5") went on great; but the 6" throttle rod will not fit without bending it a...
|
Forum: Model A (1928-31)
04-05-2018, 02:57 PM
|
Replies: 4
Views: 1,300
Re: Timing setup sequence.
Thanks everyone. I went with touching on upstroke and not worrying about downstroke. Purrs like a kitten---or should I say a Ford Lion.
|
Forum: Model A (1928-31)
04-05-2018, 12:12 PM
|
Replies: 4
Views: 1,300
Timing setup sequence.
I watched Les Andrew's videos on timing setup, which I used and it was great. However, I have one question (30 coupe). Les said that by adjusting the steering column, the control arm on the...
|
Forum: Model A (1928-31)
04-05-2018, 12:05 PM
|
Replies: 9
Views: 2,508
|
Forum: Model A (1928-31)
04-05-2018, 12:02 PM
|
Replies: 14
Views: 2,222
Re: Steering Column Adjustment
Its my understanding that if the car is a 28-29, there is not adjustment to the steering column. On the 30-31 there is a clamp just above the steering box that you can loosen and then turn the...
|
Forum: Model A (1928-31)
04-04-2018, 08:07 PM
|
Replies: 9
Views: 2,508
Re: Red Hot Exhaust
thanks everyone for your input. Got it timed correctly and runs great!!!!!!!!!
|
Forum: Model A (1928-31)
04-04-2018, 06:29 PM
|
Replies: 9
Views: 2,508
Red Hot Exhaust
I'm pretty new at these Model A's. Need the expert advice now. Just completing a 100$ disassembly and restoration of 30 coupe that I inherited from father-in-law; including engine overhaul. Just...
|
Forum: Model A (1928-31)
04-03-2018, 08:29 PM
|
Replies: 3
Views: 881
|
Forum: Model A (1928-31)
04-03-2018, 03:15 PM
|
Replies: 3
Views: 881
wiper switch
This switch was on my 30 coupe; for the wiper control. Don't believe it is a ford product. Any help identifying it?
|