Forum: Early V8 (1932-53)
02-26-2021, 11:31 AM
|
Replies: 23
Views: 710
|
Forum: Early V8 (1932-53)
10-19-2020, 11:22 AM
|
Replies: 27
Views: 1,944
|
Forum: Early V8 (1932-53)
10-07-2020, 09:46 AM
|
Replies: 85
Views: 2,744
|
Forum: Early V8 (1932-53)
10-07-2020, 09:38 AM
|
Replies: 85
Views: 2,744
|
Forum: Early V8 (1932-53)
10-03-2020, 04:09 PM
|
Replies: 20
Views: 1,499
|
Forum: Early V8 (1932-53)
09-22-2020, 09:33 AM
|
Replies: 9
Views: 631
|
Forum: Early V8 (1932-53)
08-27-2020, 03:50 PM
|
Replies: 20
Views: 852
Re: Horn wires
The wires to the horn are hot. Your horn button provides the ground.
|
Forum: Early V8 (1932-53)
08-27-2020, 09:30 AM
|
Replies: 17
Views: 983
Re: F1-missing
Check your distributor cap carefully. I had a miss on a '50 that dogged me for a long time. The cap looked good, but I couldn't see that the graphite "button" at the top was cracked and made...
|
Forum: Early V8 (1932-53)
08-21-2020, 09:47 AM
|
Replies: 9
Views: 756
Re: Stiff steering
Bill,
Dans contact information is
Dan Brusegard
Maple Grove, MN
763-533-9879
dancb@comcast.net
The bearing he sells is very well made, comes with great instructions, and worth every...
|
Forum: Early V8 (1932-53)
08-17-2020, 09:06 PM
|
Replies: 55
Views: 2,574
Re: 1940 ford sportsman?
The Merc is a real wooden body. The car is owned by a friend in Wisconsin. It was created from his imagination and put together over 16 years by some remarkable craftsmen in three states. There...
|
Forum: Early V8 (1932-53)
08-15-2020, 09:48 PM
|
Replies: 27
Views: 1,564
Re: helmet distributor
It is Michael Driskell (note spelling) in McMinnville, TN. It is best to call and talk directly to Michael at (844) 327-5988. He does a great job, quick turnaround.
Ken
|
Forum: Early V8 (1932-53)
08-15-2020, 08:52 AM
|
Replies: 55
Views: 2,574
|
Forum: Early V8 (1932-53)
08-03-2020, 03:27 PM
|
Replies: 9
Views: 547
|
Forum: Early V8 (1932-53)
07-27-2020, 10:21 AM
|
Replies: 5
Views: 359
Re: 1950 Ford Tudor Wiring Harness
Steve,
Found a picture that might help. Hope you can make out the harness in the lower left in a clip just before it goes under where the starter solenoid would be. Most of the wires split off a...
|
Forum: Early V8 (1932-53)
07-27-2020, 10:02 AM
|
Replies: 5
Views: 359
Re: 1950 Ford Tudor Wiring Harness
Steve,
The harness is routed along the driver's side fender well, about halfway down - below the level of the solenoid. There were several large clips to hold it in place - you may be able to see...
|
Forum: Early V8 (1932-53)
07-21-2020, 09:35 AM
|
Replies: 6
Views: 620
Re: '40 Radio Problem
Ralph has done two radios for me - highly recommended. He can repair an original radio to operate like new, or he can replace internals with modern circuit boards for AM/FM, iPod/MP3 jack, even...
|
Forum: Early V8 (1932-53)
07-18-2020, 03:49 PM
|
Replies: 18
Views: 813
Re: 1940 or 41 Ford Truck
Here is a picture of the '41 Pickup at Barrett-Jackson in 2010. Sales info here: https://www.barrett-jackson.com/Events/Event/Details/1941-FORD-PICKUP-81016.
Ken
|
Forum: Early V8 (1932-53)
07-18-2020, 03:35 PM
|
Replies: 18
Views: 813
|
Forum: Early V8 (1932-53)
07-05-2020, 01:25 PM
|
Replies: 46
Views: 2,624
|
Forum: Early V8 (1932-53)
07-02-2020, 09:27 AM
|
Replies: 46
Views: 2,624
Re: Pat McFarlane RIP
RIP Pat. A true gentleman. The stories of his thoughtfulness and kindness are endless.
Ken
|
Forum: Early V8 (1932-53)
06-03-2020, 09:20 AM
|
Replies: 27
Views: 1,691
|
Forum: Early V8 (1932-53)
04-25-2020, 12:56 PM
|
Replies: 4
Views: 515
Re: Idle Jets
It sounds like you are adjusting the idle jets correctly. Have you tried adjusting the idle screw on the linkage?
Ken
|
Forum: Early V8 (1932-53)
04-23-2020, 01:56 PM
|
Replies: 25
Views: 976
|
Forum: Early V8 (1932-53)
04-23-2020, 01:55 PM
|
Replies: 25
Views: 976
|
Forum: Early V8 (1932-53)
04-23-2020, 01:46 PM
|
Replies: 25
Views: 976
Re: 1953 Mercury Trim Tag help
Doug,
BG73C = 6 passenger Monterey 4 Door
70 = color code, two tone Yosemite Yellow over Sherwood Green
379 = trim code (sorry, I don't have the codes)
1J = date code, built September 1 (J =...
|