Forum: Early V8 (1932-53)
Today, 08:37 AM
|
Replies: 7
Views: 198
Re: Removing perch bolt for repair
The car would be lifted by the frame with the axle on stands if I were doing it . Depending on your spring and shackle arrangement the spring may be under some tension when you remove the shackle. ...
|
Forum: Early V8 (1932-53)
Yesterday, 12:51 PM
|
Replies: 14
Views: 598
Re: 32 Ford PIckup Wind Noise
Even in my 41 pickup we were amazed at how much more wind noise there was after we put in the Mitchell OD and started cruising the freeways. other then one rust hole the size of a quarter it is a...
|
Forum: Early V8 (1932-53)
04-21-2024, 08:36 AM
|
Replies: 14
Views: 598
|
Forum: Early V8 (1932-53)
04-21-2024, 08:25 AM
|
Replies: 14
Views: 542
|
Forum: Early V8 (1932-53)
04-20-2024, 08:27 PM
|
Replies: 14
Views: 542
Re: Oil Filter Canister Question
Scott, did you know that's how and where mercury did their sending units in 53? I pretty sure I still ha the factory brass tee that came with the 53 merc We parted out to get my motor for my 41. Tim
|
Forum: Early V8 (1932-53)
04-19-2024, 08:27 AM
|
Replies: 91
Views: 10,349
|
Forum: Early V8 (1932-53)
04-19-2024, 08:23 AM
|
Replies: 91
Views: 10,349
Re: '36 221 - rebuildable??
As GB said the heads should match. It would and did run but not right or very well. Ask around here on the barn . Somebody should have a spare set they could part with I would think. Again nice work...
|
Forum: Early V8 (1932-53)
04-17-2024, 11:49 AM
|
Replies: 20
Views: 1,302
|
Forum: Early V8 (1932-53)
04-16-2024, 08:05 AM
|
Replies: 7
Views: 484
Re: '51 o/d cable holder
Hey Scott, I found it . PM me and I'll send it. I'm down in Perry MO. just outside Hannibal. Should take about three days to get to you. Tim
|
Forum: Early V8 (1932-53)
04-15-2024, 08:49 PM
|
Replies: 50
Views: 1,805
|
Forum: Early V8 (1932-53)
04-15-2024, 08:31 AM
|
Replies: 7
Views: 484
Re: '51 o/d cable holder
Yes , I will go looking this morning. We are still getting things organized after moving 2200 miles east and having my shop built last year. So it may take some searching. Tim.
|
Forum: Early V8 (1932-53)
04-14-2024, 07:44 AM
|
Replies: 5
Views: 463
Re: 1953 fan assembly
I used 30# engine oil and if you over fill it it will just throw the excess out the rear until it has the correct amount. There is no seal and it circulates the oil when running via a screw type...
|
Forum: Early V8 (1932-53)
04-14-2024, 07:36 AM
|
Replies: 7
Views: 484
|
Forum: Early V8 (1932-53)
04-12-2024, 08:03 AM
|
Replies: 15
Views: 975
Re: What wheels are these?
If I had to guess I would say someone changed the truck to 5 on 5&1/2 bolt pattern drums and the wheels are or were narrow chrome smoothies that got painted with new caps. Tim
|
Forum: Early V8 (1932-53)
04-12-2024, 07:53 AM
|
Replies: 8
Views: 609
Re: Drove 30mi round trip burned 1qt oil
Gary , Where were you with that advice two years ago when I was bombin around Olympia with my seven cylinder low to no compression 8ba. Instead of smelling burnt oil I would have smelled like any...
|
Forum: Early V8 (1932-53)
04-09-2024, 08:29 AM
|
Replies: 7
Views: 333
Re: Driving The 52 Merc
Enjoy my friend. I'm envious as my old flathead is still 2200 miles away and not up and running yet. Mabey by July I'll have the time and money to Finnish it and driver it home. I do miss driving it....
|
Forum: Early V8 (1932-53)
04-08-2024, 08:49 PM
|
Replies: 96
Views: 6,159
Re: Break-in gone wrong!
Cameron I may be wrong but I was told here on the barn that 8ba's had 80 psi systems from the start so if that's true your 40 or 50 psi on a fresh engine would indicate a problem from the start to...
|
Forum: Early V8 (1932-53)
04-08-2024, 02:12 PM
|
Replies: 96
Views: 6,159
Re: Break-in gone wrong!
Ok. I've been following this thread from the beginning but held my tongue. I know its unlikely but when the pump gear gets up to running temp could it spin on the shaft under load then cool off and...
|
Forum: Early V8 (1932-53)
04-08-2024, 07:46 AM
|
Replies: 3
Views: 376
Re: 2 sp fordomatic
I found if I put it in first and drove mine for about two blocks it would find second and third much better for the rest of the drive. But its just a band aid fix, either your seals are worn or your...
|
Forum: Early V8 (1932-53)
04-07-2024, 07:57 AM
|
Replies: 7
Views: 480
|
Forum: Early V8 (1932-53)
04-05-2024, 08:10 AM
|
Replies: 18
Views: 946
Re: Annual MONSTER Swap Portland, Or
Hi Dale, The last two swaps I attended at Portland were very disappointing. My brother (your neighbor) and I started counting after the first hour or so and we figured for every actual old used car...
|
Forum: Early V8 (1932-53)
04-02-2024, 09:23 AM
|
Replies: 22
Views: 1,200
Re: At a loss. 1949 Ford flathead V8
Along with the coil you might try a hot wire direct from the battery to the coil. There is the chance of a bad ignition switch. I was stymied by one in the past with the same symptoms. Tim
|
Forum: Early V8 (1932-53)
04-02-2024, 09:06 AM
|
Replies: 66
Views: 3,575
|
Forum: Early V8 (1932-53)
03-31-2024, 08:24 AM
|
Replies: 16
Views: 510
|
Forum: Early V8 (1932-53)
03-30-2024, 08:17 AM
|
Replies: 6
Views: 517
Re: help identify transmissions
Let me rephrase that. I sold two like the red one for $350 each on the HAMB . If you like I can drop a note on the Cadillac Lassalle page saying I saw them here or wherever you want to post them. If...
|