Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: alanwoodieman
Forum: Early V8 (1932-53) Yesterday, 07:49 PM
Replies: 6
Views: 219
Posted By alanwoodieman
Re: Ford T8D-1 shift pattern

depending upon the year of the shift "tower" you may not have a reverse lock out lever that is pulled up. during ww2 the army had ford remove the lock out lever. we recently had a 4 speed in a 39...
Forum: Early V8 (1932-53) 10-28-2020, 09:21 PM
Replies: 11
Views: 460
Posted By alanwoodieman
Re: exhaust manifolds

if it was a set, I have a friend who would talk me out of them! anybody have the other manifold for a set?
Forum: Early V8 (1932-53) 10-28-2020, 05:56 PM
Replies: 11
Views: 460
Posted By alanwoodieman
Re: exhaust manifolds

yes, I think it is the same type for 49/51 dual exhaust-kind of strange the different lettering from ca on the same manifold
Forum: Early V8 (1932-53) 10-28-2020, 03:50 PM
Replies: 11
Views: 460
Posted By alanwoodieman
Re: exhaust manifolds

the one with the fomoco cast into it is an EAB? 52/53? the first one is an after market creation. I will try to get some better pictures.
Forum: Early V8 (1932-53) 10-28-2020, 03:47 PM
Replies: 21
Views: 373
Posted By alanwoodieman
Re: 52 F1 oil seal

drill two hole on opposite sides--run a large sheet metal screw in and pry out seal using the alternate holes. always remember the "edge" of the seal goes against the fluid side
Forum: Early V8 (1932-53) 10-28-2020, 02:19 PM
Replies: 21
Views: 373
Posted By alanwoodieman
Re: 52 F1 oil seal

changed out mine on my 49 F1-new one looks just like yours
Forum: Early V8 (1932-53) 10-28-2020, 12:19 PM
Replies: 11
Views: 460
Posted By alanwoodieman
exhaust manifolds

found two exhaust manifolds--one I know is Ford-what does it fit
second one says made in Ca-where did it come from
Forum: Early V8 (1932-53) 10-27-2020, 07:32 PM
Replies: 20
Views: 509
Posted By alanwoodieman
Re: Introduction to my 50 fordor

my friend has a 51 fordor, painted Greenbrier Green, is that the color of your car ?
Forum: Early V8 (1932-53) 10-27-2020, 03:46 PM
Replies: 9
Views: 310
Posted By alanwoodieman
Re: 1940 3/4 ton fuel tank and seat

my 41 3/4 ton with stakebed
Forum: Early V8 (1932-53) 10-26-2020, 08:49 PM
Replies: 11
Views: 335
Posted By alanwoodieman
Re: 49 Ford F1 project. What am I getting into?

pictures? trans/cross member would be helpful. just finished a 49 F1-rust in cab corners/floor and in front and rear fenders-a lot of rust repair or buy new fenders
Forum: Early V8 (1932-53) 10-20-2020, 09:34 PM
Replies: 12
Views: 621
Posted By alanwoodieman
Re: parts pickup

I would go nuts out there, thanks for the pictures.
Forum: Early V8 (1932-53) 10-19-2020, 07:47 PM
Replies: 29
Views: 1,032
Posted By alanwoodieman
Re: Does Anyone Know What This Is?

rotowrench do you know what a load coil is?
Forum: Early V8 (1932-53) 10-19-2020, 04:32 PM
Replies: 29
Views: 1,032
Posted By alanwoodieman
Re: Does Anyone Know What This Is?

it is an antenna signal "booster"
Forum: Early V8 (1932-53) 10-19-2020, 12:06 PM
Replies: 9
Views: 948
Posted By alanwoodieman
Re: Jacking 1939 model 91A

buy you a small floor jack, add a piece of 2 x 12 about 24" long and you will safely be able to jack up your car. put piece of wood on ground and roll the jack on it till it is under the axle near...
Forum: Early V8 (1932-53) 10-17-2020, 11:49 AM
Replies: 11
Views: 532
Posted By alanwoodieman
Re: Toploader installation.

use what ever you choose, butwhen you have to put thrust washers and new syncro's in your then you will change
Forum: Early V8 (1932-53) 10-17-2020, 08:11 AM
Replies: 11
Views: 532
Posted By alanwoodieman
Re: Toploader installation.

GL 1 available from tractor supply for use in Ford tractors--straight mineral oil, GL 3/4/5 from experience will melt away your syncro's
Forum: Early V8 (1932-53) 10-15-2020, 06:31 PM
Replies: 13
Views: 647
Posted By alanwoodieman
Re: Clayborne engine overhaul stand attachments maybe available

I acquired one of these stands, but have never used it, I am told it is easier than the kr wilson but would like some input on the subject from a user of this style stand
Forum: Early V8 (1932-53) 10-15-2020, 03:27 PM
Replies: 3
Views: 279
Posted By alanwoodieman
Re: The National Museum of the US Army

been there! it is worth a visit
Forum: Early V8 (1932-53) 10-15-2020, 07:31 AM
Replies: 60
Views: 2,307
Posted By alanwoodieman
Re: Marvel Classic Motor Oil

ever had a stuck valve in a flathead? if you did you would swear by MMO! if it is snake oil, but be a good snake
Forum: Early V8 (1932-53) 10-14-2020, 06:52 PM
Replies: 60
Views: 2,307
Posted By alanwoodieman
Re: Marvel Mystery Oil and Marvel Classic Motor Oil

Kendal 20w50 or valvoline 20w50, put mmo in gas tank according to directions
Forum: Early V8 (1932-53) 10-13-2020, 12:43 PM
Replies: 14
Views: 7,892
Posted By alanwoodieman
Forum: Early V8 (1932-53) 10-13-2020, 07:33 AM
Replies: 59
Views: 1,785
Posted By alanwoodieman
Re: Autolite Spark Users Only

Stromberg carb, so I would think too large jets, back up and take a picture of the engine head. take the air cleaner off and make sure it is not clogged up, It appears to be a dry type and the...
Forum: Early V8 (1932-53) 10-12-2020, 08:39 PM
Replies: 59
Views: 1,785
Posted By alanwoodieman
Re: Autolite Spark Users Only

what carb do you have on your 36? Stromberg or Ford 94 type? I use and recommend auto lite 216. power valve can be leaking in a 94 and cause this problem
Forum: Early V8 (1932-53) 10-12-2020, 03:42 PM
Replies: 3
Views: 331
Posted By alanwoodieman
Re: Need a good Suggestion on what to do

I would mount them on a board with a picture of the car and your Dad and hang in the garage or a wall in the hallway of your house as a reminder of the good times your Dad had with old cars
Forum: Early V8 (1932-53) 10-12-2020, 07:28 AM
Replies: 7
Views: 312
Posted By alanwoodieman
Re: 12v conversion

send an original coil to skip and have it converted to 12v neg ground. autolite 216 plugs gapped at 030
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:08 AM.