Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: katy
Forum: Model A (1928-31) Today, 11:10 AM
Replies: 16
Views: 473
Posted By katy
Re: My Distributor Cam Screw is Stuck

What makes you think that the timing needs adjusted?
Have you checked the timing to see if'n it needs to be adjusted?

Maybe the timing doesn't need adjusting and you're just making work for...
Forum: Model A (1928-31) Yesterday, 11:05 AM
Replies: 17
Views: 637
Posted By katy
Re: Flywheel housing mounting

It sounds like you forgot about the 2 bolts at the top of the flywheel housing.
Forum: Model A (1928-31) Yesterday, 10:59 AM
Replies: 15
Views: 568
Posted By katy
Re: Condenser mount

Ford P/N C5AF12117
Forum: Model A (1928-31) Yesterday, 10:51 AM
Replies: 14
Views: 874
Posted By katy
Re: Terry Chapman Model A engine rebuilder.

I've seen that, the oil migrates out of the lubriplate and leaves the clay behind.

FWIW, I have a glass jar of lubriplate that's been sitting on the shelf for over 40 years, the oil is at the top...
Forum: Model A (1928-31) 11-24-2020, 11:49 AM
Replies: 2
Views: 223
Posted By katy
Re: front pully

You got it!
Forum: Model A (1928-31) 11-22-2020, 11:48 AM
Replies: 2
Views: 223
Posted By katy
Re: speedo cable lubrication??

I would remove the cable from the housing, clean both the cable and the housing interior w/solvent or diesel fuel, coat the cable w/chassis grease and re-install the cable in the housing making sure...
Forum: Model A (1928-31) 11-22-2020, 11:18 AM
Replies: 7
Views: 508
Posted By katy
Re: oil lube circuit

There is also an "oil return" tube that returns excess oil from the rear of the valve chamber to the lower front of the block, where the oil flows into the dipper tray.

Also note that the engine...
Forum: Model A (1928-31) 11-22-2020, 11:07 AM
Replies: 939
Views: 111,441
Posted By katy
Re: tell a Model A related story

I heard about a girl that was such a slow talker, that before she could say she wasn't that kind of a girl, she was.
Forum: Model A (1928-31) 11-21-2020, 12:21 PM
Replies: 7
Views: 508
Posted By katy
Re: oil lube circuit

Go to: http://www.palmbeachas.com/Model-A-Instruction-Manual.pdf

Figure 5, page 12
Forum: Model A (1928-31) 11-21-2020, 12:11 PM
Replies: 9
Views: 664
Posted By katy
Re: The Ace Mechanic Again

I always understood Ace mechanic to mean a card shark.
Forum: Model A (1928-31) 11-21-2020, 12:04 PM
Replies: 35
Views: 1,575
Posted By katy
Re: Hard Brake Pedal - Update on Post #9

Check the rear motor mounts.
I once had a Model A that the brake pedal was VERY hard to push, found that the rear motor mounts were not holding anything and the trans mission was sitting on the...
Forum: Model A (1928-31) 11-21-2020, 11:48 AM
Replies: 5
Views: 324
Posted By katy
Forum: Model A (1928-31) 11-21-2020, 11:39 AM
Replies: 33
Views: 1,299
Posted By katy
Re: Jumping a 6 volt battery

If you're running any electronics and 6 volt system it would be a good idea to avoid 12 volts for boosting unless the starter is isolated.
Forum: Model A (1928-31) 11-20-2020, 11:22 AM
Replies: 4
Views: 488
Posted By katy
Re: % Year Antifreeze

Just use the "green" Prestone for 5 years. Methinks the annual change is just a marketing ploy to sell more product.
Forum: Model A (1928-31) 11-19-2020, 05:01 PM
Replies: 15
Views: 784
Posted By katy
Re: Instrument Panel Lamp

How about using a piece of flat metal to use as an "extension" to move your light over a bit.
Forum: Model A (1928-31) 11-19-2020, 12:13 PM
Replies: 33
Views: 1,299
Posted By katy
Forum: Model A (1928-31) 11-19-2020, 11:44 AM
Replies: 33
Views: 1,299
Posted By katy
Re: Jumping a 6 volt battery

FWIW, 1-3/8" is the proper size for a Model A, but I've heard that some "crank nuts" are 1-5/16" and the one on my A is 1-1/4".
Not all Model As are created equal.
Forum: Model A (1928-31) 11-19-2020, 11:34 AM
Replies: 5
Views: 562
Posted By katy
Re: Numbers on C-4 spark plugs

Have you tried contacting Champion?
Forum: Model A (1928-31) 11-18-2020, 12:18 PM
Replies: 13
Views: 712
Posted By katy
Re: Bent timing pin

One could try straightening it while it's in place.
Forum: Model A (1928-31) 11-18-2020, 12:03 PM
Replies: 23
Views: 1,391
Posted By katy
Re: A New Winter House for My "A"

I'd suggest putting a temporary ceiling,like a sheet of poly or a tarp, to keep the heat from disappearing into the roof area.
Forum: Model A (1928-31) 11-17-2020, 12:02 PM
Replies: 5
Views: 562
Posted By katy
Re: Numbers on C-4 spark plugs

I would guess some sort of production code.
Forum: Model A (1928-31) 11-16-2020, 12:10 PM
Replies: 15
Views: 813
Posted By katy
Forum: Model A (1928-31) 11-16-2020, 11:48 AM
Replies: 208
Views: 423,175
Posted By katy
Forum: Model A (1928-31) 11-16-2020, 11:38 AM
Replies: 33
Views: 1,894
Posted By katy
Re: What am I missing? 1930 Model A

Is that new coil definitely a 6 volt coil? With aproximately 1.5 ohms resistance of the primary windings?
Forum: Model A (1928-31) 11-16-2020, 11:20 AM
Replies: 39
Views: 2,228
Posted By katy
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:43 PM.