Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.10 seconds.
Search: Posts Made By: tubman
Forum: Early V8 (1932-53) Yesterday, 02:35 PM
Replies: 15
Views: 395
Posted By tubman
Re: spark plug wire conduit ID?

I still say air compressor.
Forum: Early V8 (1932-53) 09-28-2020, 08:00 PM
Replies: 15
Views: 395
Posted By tubman
Re: spark plug wire conduit ID?

Air compressor? Didn't they run on 4 and pump on 4 (2 on each side).
Forum: Early V8 (1932-53) 09-28-2020, 05:37 PM
Replies: 10
Views: 261
Posted By tubman
Re: 1939 ford flat head wont fore after a rain

I had this happen to me as well, and it was a crack in the coil tower, I only found it because it happened at night and I could see the spark "leak".
Forum: Early V8 (1932-53) 09-25-2020, 07:28 PM
Replies: 24
Views: 583
Posted By tubman
Re: 1938 Firestone whitewall tire pressure

There was an interesting thread on the H.A.M.B. about the age of tires.

The conclusion was that environment and storage conditions are very important factors in service length of tires. In short,...
Forum: Early V8 (1932-53) 09-25-2020, 07:18 PM
Replies: 23
Views: 580
Posted By tubman
Re: New Rebuild Overheating

To be clear; if it only overheats at idle, I'd run the piss out of it. If it overheats going down the road, I think you may have other problems.
Forum: Early V8 (1932-53) 09-25-2020, 12:51 PM
Replies: 40
Views: 1,288
Posted By tubman
Re: new engine start-up problems

Maybe not such a long shot; I had this exact thing happen to me.

From my long experience with fouled plugs in snowmobiles, I don't think it would be a bad idea to buy a fresh set of plugs to try.
Forum: Early V8 (1932-53) 09-25-2020, 12:47 PM
Replies: 23
Views: 580
Posted By tubman
Re: New Rebuild Overheating

I had the 327 in my Corvette rebuilt a while ago. When I got it running, it ran well, but would not idle for any period of time at all before it started to boil. I tried everything; changed the...
Forum: Early V8 (1932-53) 09-24-2020, 08:55 PM
Replies: 24
Views: 583
Posted By tubman
Re: 1938 Firestone whitewall tire pressure

You have to remember that the car companies recommended the tire pressure that would yield the best handling and ride quality, while the tire companies recommended the pressure that would give the...
Forum: Early V8 (1932-53) 09-24-2020, 07:51 PM
Replies: 24
Views: 583
Posted By tubman
Re: 1938 Firestone whitewall tire pressure

Again; radials or bias-ply? It does make a difference.

I am quite surprised that many of you suggest deviating from what Ford Motor Company recommends by a substantial amount. And that you seem to...
Forum: Early V8 (1932-53) 09-24-2020, 02:09 PM
Replies: 9
Views: 311
Posted By tubman
Re: edlebrock 4 barrel manifold broken bolt

Don't 8BA manifolds have a 4 degree tilt down in front and the pre '48's have none?
Forum: Early V8 (1932-53) 09-24-2020, 10:01 AM
Replies: 24
Views: 583
Posted By tubman
Re: 1938 Firestone whitewall tire pressure

Here's what the owners manual says. In 1951, the "DeLuxe" (base) models came with 6.00 X 16 tires. Note the significantly higher pressure they call for. It's on the bottom of the right hand page. For...
Forum: Early V8 (1932-53) 09-24-2020, 09:48 AM
Replies: 40
Views: 1,288
Posted By tubman
Re: new engine start-up problems

I always use a known good stock carb and manifold on the initial start of any engine I build, regardless of other modifications. It's easy on a flathead because you don't have to drain the cooling...
Forum: Early V8 (1932-53) 09-24-2020, 09:41 AM
Replies: 24
Views: 583
Posted By tubman
Re: 1938 Firestone whitewall tire pressure

You haven't told us if you have radials or bias plys. 32 is a decent general number for radials. Bias plys need less. Previously, I had a set of Firestone wide white bias plys on my '51 Ford. The...
Forum: Early V8 (1932-53) 09-24-2020, 12:23 AM
Replies: 9
Views: 311
Posted By tubman
Re: edlebrock 4 barrel manifold broken bolt

That's in the heat riser passage from the exhaust system. It looks like a hole got put into it, and someone tapped the hole and put a bolt into it to plug the hole. There isn't supposed to be a hole...
Forum: Early V8 (1932-53) 09-23-2020, 03:15 PM
Replies: 9
Views: 300
Posted By tubman
Re: Stromberg carbs

OK. That explains it. (Modern stuff.) Sounds healthy, though. It might run OK progressive, but I bet straight would be better. The only time I ran 4 97's was on the 331 Hemi in my racecar (straight...
Forum: Early V8 (1932-53) 09-23-2020, 02:10 PM
Replies: 9
Views: 300
Posted By tubman
Re: Stromberg carbs

Now you have piqued my interest. Would you mind sharing what kind of an engine this is? The only 300+ ci vintage inline sixes I can think of are Hudsons (308 ci) and GMC's (302 ci). Since yours is...
Forum: Early V8 (1932-53) 09-23-2020, 11:35 AM
Replies: 9
Views: 300
Posted By tubman
Re: Stromberg carbs

And that can get real expensive.:eek:
Forum: Early V8 (1932-53) 09-22-2020, 08:22 PM
Replies: 41
Views: 845
Posted By tubman
Re: First 100 Miles!!! Or a touch more. My '39 Pickup

When I was about 19, I had a friend who had a pretty nice "barrel-nose" pickup. We all kinda looked down on him because it wasn't a '40-'41. It's funny what a few years can do to improve ones taste...
Forum: Early V8 (1932-53) 09-22-2020, 09:37 AM
Replies: 14
Views: 683
Posted By tubman
Re: Moose And The Mercury

Damn! You never have your camera when you really need it!

Nice picture, anyway.:)
Forum: Early V8 (1932-53) 09-19-2020, 01:57 PM
Replies: 16
Views: 580
Posted By tubman
Re: Timing light

I have had two "dial-back" timing lights. One was a Sears Craftsman and I don't remember what the other one was. Both quit working almost as soon as I got them. Can someone recommend one that works...
Forum: Early V8 (1932-53) 09-19-2020, 01:46 PM
Replies: 11
Views: 450
Posted By tubman
Re: spark plug wire set

Did you read the reviews on the Jeg's site about this? They are all "one star". It seems to be universally disliked.
Forum: Early V8 (1932-53) 09-18-2020, 09:00 PM
Replies: 11
Views: 450
Posted By tubman
Re: spark plug wire set

I will second the recommendation on a special spark plug crimper. Until I got one, the spark plug wires I made were second rate.
Forum: Early V8 (1932-53) 09-18-2020, 08:46 PM
Replies: 20
Views: 1,648
Posted By tubman
Re: Skip's rebuilt coils

Yep. Many of you would be surprised at how he does it.
Forum: Early V8 (1932-53) 09-18-2020, 08:39 PM
Replies: 19
Views: 657
Posted By tubman
Re: 1947 back up light switch bracket

I mounted the camera on the rear license plate. That was the easy part. The screen is he hard part. Currently, I have it temporarily mounted on the dash board above the radio. It is not a good place,...
Forum: Early V8 (1932-53) 09-17-2020, 10:33 PM
Replies: 64
Views: 3,126
Posted By tubman
Re: Wildfire evacuation

Before this gets to far, I think people should know that the "Oregon Catalyst" (sic) is a known conservative blog.

Make your own judgement.

Let's get back to cars.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 05:22 AM.