Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 208
Search took 0.02 seconds.
Search: Posts Made By: abachman3
Forum: Model A (1928-31) 01-15-2020, 11:05 AM
Replies: 17
Views: 667
Posted By abachman3
Re: Cracked Head

Yes, that is a cracked head. It appears that the engine has been dormant for awhile, with the light rusting on the plugs, the head gasket area and around the crack. Stock heads, used are quite...
Forum: Model A (1928-31) 01-03-2020, 08:44 PM
Replies: 32
Views: 1,203
Posted By abachman3
Re: Clutch slipping.

The vendors sell a head puller that is made by Stipe. I have used one several times now and it works great. It bolts into two spark plug holes and then as it is tightened down by pressing on two...
Forum: Model A (1928-31) 12-14-2019, 12:23 PM
Replies: 7
Views: 486
Posted By abachman3
Re: Body Kit

Canopy Express/Huckster.
Forum: Model A (1928-31) 11-29-2019, 10:40 AM
Replies: 24
Views: 1,060
Posted By abachman3
Re: wedding decoaration ideas

We tied tin cans on the car and drove it around the church parking lot, for the effect and photos, then removed them for driving on the city streets.
Forum: Early V8 (1932-53) 11-21-2019, 09:59 AM
Replies: 3
Views: 615
Posted By abachman3
Re: 1932 Ford Panel Truck

The passenger seat with the small gas tank. Thanks.
Forum: Early V8 (1932-53) 11-16-2019, 05:51 PM
Replies: 3
Views: 615
Posted By abachman3
Forum: Model A (1928-31) 11-15-2019, 03:06 PM
Replies: 42
Views: 2,561
Posted By abachman3
Re: Removed engine; some improvements?

If you are removing the water pump, replace the 4-studs with bolts. We use clutch housing-to-flywheel bolts, correct pitch and length. This makes it much easier to replace the water pump on the car...
Forum: Model A (1928-31) 11-15-2019, 02:58 PM
Replies: 2
Views: 285
Posted By abachman3
Bendix Spring bolts

A question comes up periodically at the club meetings regarding the bendix spring bolts. Should they be tight against the spring or slightly loose, with the tabs on the washer keeping the bolts from...
Forum: Model A (1928-31) 11-10-2019, 02:09 PM
Replies: 18
Views: 915
Posted By abachman3
Re: Carb Rebuild

We store the gallon can of carb cleaner in a plastic bucket with the lid on the bucket, but only snug. Haven't had a rusting issue and have the same gallon for several years now. Just put the...
Forum: Model A (1928-31) 11-01-2019, 02:13 PM
Replies: 20
Views: 1,124
Posted By abachman3
Re: Mysterious hole in valve chamber?

I too, have seen a number of blocks that look about like this one in question. I have heard that that is just how the were!
Forum: Early V8 (1932-53) 10-29-2019, 09:26 PM
Replies: 3
Views: 615
Posted By abachman3
1932 Ford Panel Truck

I'm looking for photos of 1932 Ford Panel trucks. I'm especially interested in seeing the passenger front seat and how it is mounted in the truck. I am aware that the second seat (passenger seat) was...
Forum: Model A (1928-31) 10-16-2019, 09:45 AM
Replies: 15
Views: 982
Posted By abachman3
Re: Bud Vase bracket

There is a vendor that sells various shaped ones that is at the Spring/Fall Jefferson swap meets in Wisconsin. I have purchased from her in the past. I looked through my business cards but didn't...
Forum: Model A (1928-31) 09-14-2019, 10:32 AM
Replies: 36
Views: 2,240
Posted By abachman3
Re: Restored Nebraska Model "A" Is junk

In Illinois, a few years ago, we had a number of titles revoked by the Secretary of State because the titles had been 'washed' by one of the out of state non-title required businesses. All of the...
Forum: Model A (1928-31) 09-09-2019, 09:14 AM
Replies: 8
Views: 724
Posted By abachman3
Re: Flat spot in carburetor

I too recommend that for more 'power' to open the GAV a small amount. When I'm running mine at 55 mph I find that it definitely needs to be opened more than driving around town.
Forum: Model A (1928-31) 09-01-2019, 09:39 AM
Replies: 11
Views: 600
Posted By abachman3
Re: Towing my Model A

Cross the straps that you use as tie downs as this keeps the vehicle from moving sideways while on the trailer.
Forum: Model A (1928-31) 08-26-2019, 10:20 AM
Replies: 17
Views: 901
Posted By abachman3
Re: Gas Gauge Calibration

To answer the second part of #3, most model A's get something like 18-20 miles per gallon. A little less if only in-town stop and go driving.
Forum: Model A (1928-31) 08-24-2019, 04:32 PM
Replies: 12
Views: 1,170
Posted By abachman3
Re: Tudor front seat

My extenders were on the car when I bought it... but I do see them listed in the catalogs of the major vendors.
Forum: Model A (1928-31) 08-21-2019, 07:56 AM
Replies: 15
Views: 878
Posted By abachman3
Re: Which tap and die set

Here in USA the model A's has many fine threads. Way more than one might have expected.
Forum: Model A (1928-31) 08-21-2019, 07:51 AM
Replies: 40
Views: 2,334
Posted By abachman3
Re: 1930 Ford Model A 4Dr (Inherited Don't Know Much - HELP)

As it is not very well cleaned, inside and out, I would say that it is more of a $10-12,000. car. If we knew it runs and stops, I could see a little bit more. Yes, it is a blindback sedan. The...
Forum: Model A (1928-31) 08-07-2019, 10:26 AM
Replies: 1
Views: 291
Posted By abachman3
Re: Electrical supply

Contact Ron Ehrenhofer in the Illinois Region of MARC.
Forum: Model A (1928-31) 08-04-2019, 12:09 PM
Replies: 9
Views: 717
Posted By abachman3
Re: stumped

I have had the clutch 'stick' to the plate during cold damp freezing weather before. Also know several others that have had a similar occurrence. I just put it into gear and start it up. It will...
Forum: Model A (1928-31) 08-04-2019, 12:01 PM
Replies: 28
Views: 1,622
Posted By abachman3
Re: Service Truck

The Beller museum has a '28-29 model very similar. It has not been restored as yet.
Forum: Model A (1928-31) 08-02-2019, 02:26 PM
Replies: 14
Views: 1,048
Posted By abachman3
Re: Oil pan bolts

I too, use the 1/4 inch socket. For all the tighter it needs to be, the 1/4 inch is plenty.
Forum: Model A (1928-31) 07-24-2019, 08:05 AM
Replies: 36
Views: 9,996
Posted By abachman3
Re: Model "A" Sportlight - How many still around ?

Ron Ehrenhofer in Illinois refurbishes and sells the correct Sport Lites for the Model A Fords. He makes/has made some of the hard to find parts.
Forum: Model A (1928-31) 07-24-2019, 07:59 AM
Replies: 23
Views: 2,777
Posted By abachman3
Re: 1931 Passenger Bus

This bus was donated by Ken Ehrenhofer to MAFFI. It was purchased by Ken at the Hartung auction a few years back.
Showing results 1 to 25 of 208

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:59 AM.