Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 59
Search took 0.01 seconds.
Search: Posts Made By: Tomjc
Forum: Late V8 (1954+) 05-16-2021, 09:05 AM
Replies: 2
Views: 449
Posted By Tomjc
Re: 54 Mercury Sun Valley Trim Piece

it looks correct to me I have had my Sun Valley for 47 years
Forum: Late V8 (1954+) 03-26-2021, 03:47 PM
Replies: 17
Views: 1,154
Posted By Tomjc
Re: T-85 with R-11 OD Output Shaft Slip Yoke

I sent you a private message and I never heard back, I have the yoke you need message me and I can send it to you and if it works I will take $100.
Forum: Late V8 (1954+) 03-04-2021, 08:40 AM
Replies: 12
Views: 715
Posted By Tomjc
Re: 1954 Mercury Turn Signal Switch

You can use the Ford version to rebuild your Mercury, That what I had to do.
Forum: Late V8 (1954+) 02-22-2021, 09:08 AM
Replies: 7
Views: 594
Posted By Tomjc
Re: 1954 Mercury Steering Column

I think you need to remove steering wheel and take a picture, Does the gear shift seem to work ok.
Forum: Late V8 (1954+) 02-12-2021, 11:44 AM
Replies: 17
Views: 1,154
Posted By Tomjc
Re: T-85 with R-11 OD Output Shaft Slip Yoke

I know what you are going thru. It took me 2 years to find that same yoke, and then I found another one. The yoke is a Spicer with C-2.3.249 on the reverse side. mine has a 5 1/4 inch long shaft....
Forum: Late V8 (1954+) 01-08-2021, 05:01 PM
Replies: 15
Views: 1,039
Posted By Tomjc
Forum: Late V8 (1954+) 11-30-2020, 09:20 AM
Replies: 27
Views: 1,468
Posted By Tomjc
Re: Front engine mount for 292 Y-block

I have owned 4 Mercs all 54 and none had the front mount. My first 54 was a 1 owner Sunvalley that my uncle owned and no front motor mount
Forum: Late V8 (1954+) 11-29-2020, 12:06 PM
Replies: 27
Views: 1,468
Posted By Tomjc
Re: Front engine mount for 292 Y-block

why do you think Mercury did not use front mount?
Forum: Late V8 (1954+) 07-27-2020, 04:17 PM
Replies: 18
Views: 1,186
Posted By Tomjc
Re: 55 ford Ranch Wagon Pinion Seal

Mac's has them #49-19378 or 64-19378
Forum: Late V8 (1954+) 05-04-2020, 10:44 AM
Replies: 2
Views: 496
Posted By Tomjc
Re: 1954 Mercury Oil Pan Removal

If I remember correctly I had to turn the engine over by hand a couple times to clear the rods, and keep pulling it back until it clears
Forum: Late V8 03-07-2019, 04:03 PM
Replies: 0
Views: 1,079
Posted By Tomjc
54 merc

Looking for small hubcap for 54 Merc with the red center.
Forum: Late V8 02-28-2019, 03:17 PM
Replies: 0
Views: 741
Posted By Tomjc
clock delete

I am looking for a clock delete for a 54 Merc. I am pretty sure most of you have never seen one. But just maybe someone has it sitting on shelf.
Forum: Late V8 09-16-2018, 08:03 AM
Replies: 0
Views: 743
Posted By Tomjc
speedo gear

I have a T85 with overdrive and 411 rear gears, looking for a 20/21 speedo gear for 54 Merc, I am not sure on the year of trans. It has the 16 spline yoke
Forum: Late V8 08-26-2018, 05:22 PM
Replies: 0
Views: 557
Posted By Tomjc
63/64 Ford bucket seats

looking for a pair of OEM bucket seats for 63/64 Ford or Merc full size.
Forum: Late V8 02-16-2018, 05:32 PM
Replies: 0
Views: 557
Posted By Tomjc
41 ford pickup hood stainless

need hood stainless that fits the center of hood.
Forum: Late V8 (1954+) 01-01-2018, 03:05 PM
Replies: 452
Views: 77,117
Posted By Tomjc
Re: Two-Door Ford and Mercury Wagons

My 54 Merc wagon did start as a 54 Ford, Ranch wagon. with 54 not 51 rear quarter panel weld in. 54 Merc dash, steering column, seats even the wheels are Merc. Has a 54 Merc wagon rear bumper and gas...
Forum: Late V8 12-12-2017, 10:19 AM
Replies: 0
Views: 486
Posted By Tomjc
54 MERC hubcap

Looking for 1 perfect hubcap or as some people call them wheel covers for 54 MERC. paint not important.
Forum: Late V8 (1954+) 11-16-2017, 09:31 AM
Replies: 452
Views: 77,117
Posted By Tomjc
Forum: Late V8 (1954+) 05-10-2016, 09:05 PM
Replies: 10
Views: 1,737
Posted By Tomjc
Re: Mercury speaker grille.

They are a hammer tone silver/ grey
Forum: Late V8 (1954+) 04-07-2016, 04:01 PM
Replies: 3
Views: 875
Posted By Tomjc
Re: Kansas City Car Club for Y Blocks

Join IMOA ( international mercury owners association ). Our annual meeting is in Louisville this year.
Forum: Late V8 (1954+) 03-14-2016, 02:12 PM
Replies: 6
Views: 1,477
Posted By Tomjc
Re: 54 Mercury floor shift conversion

why don't you sell me your 54 Merc convertible and get rid of al those problems.
Forum: Late V8 02-19-2016, 06:58 PM
Replies: 0
Views: 562
Posted By Tomjc
1964 Comet 2door

looking for 64 Comet 2 dr, project
Forum: Late V8 (1954+) 12-02-2015, 05:05 PM
Replies: 30
Views: 5,261
Posted By Tomjc
Re: Selling my stuff

Do you have any 4 barrel breathers ( not the oil bath type )?
Forum: Late V8 (1954+) 07-05-2015, 12:32 PM
Replies: 0
Views: 779
Posted By Tomjc
T85 OD trans

The OD trans I am using has the rare 16 spline slip yoke and I am in need of a speedometer gear. 22 or 23 tooth. The gears I have tried do not mesh or spin in trans. Does any one know what gear I...
Forum: Late V8 (1954+) 09-17-2014, 11:03 AM
Replies: 10
Views: 1,701
Posted By Tomjc
Re: T85 Over drive

Thanks for all your input. I removed the governor and it would not go to ground when I hooked a drill to it. (New one on the way) I copied the schematic from the old car manual and notice the wire...
Showing results 1 to 25 of 59

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 10:52 AM.