Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.08 seconds.
Search: Posts Made By: redmodelt
Forum: Model A (1928-31) Yesterday, 10:37 AM
Replies: 28
Views: 974
Posted By redmodelt
Re: Cap and Comp Jet Helicoil repair

Bummer, would have been easier fix then some of the suggestions so far.

Re my suggestion about soldering it in; if that jet is screwed in without the gasket it can interfere with the well going...
Forum: Model A (1928-31) 01-24-2020, 11:55 PM
Replies: 28
Views: 974
Posted By redmodelt
Re: Cap and Comp Jet Helicoil repair

Where is it listed? I looked on line and didn't see any Heli-coils listed only the tap under carburetors. Or is it just in the printed catalog? Do you have a parts number? We too have a couple of...
Forum: Model A (1928-31) 01-24-2020, 07:16 PM
Replies: 29
Views: 11,896
Posted By redmodelt
Re: 6 Volt LED Flasher

They make them in negative ground too;
https://www.ledlight.com/flasher-6-volt-led-3-prong-120-watt-positive-chassis.aspx
Forum: Model A (1928-31) 01-24-2020, 01:21 AM
Replies: 28
Views: 974
Posted By redmodelt
Re: Cap and Comp Jet Helicoil repair

I read that 3 times and still miss read it. Sorry about that. Even if you were to install a hel-coil you would still need to drill/tap oversize to install. What about soldering it in place? About the...
Forum: Model A (1928-31) 01-23-2020, 08:00 PM
Replies: 28
Views: 974
Posted By redmodelt
Re: Cap and Comp Jet Helicoil repair

The secondary well is a different size then the 5M.75 jets. So you need more then just the jets thread repaired to refurb this carb?
Forum: Early V8 (1932-53) 01-22-2020, 01:26 AM
Replies: 26
Views: 2,525
Posted By redmodelt
Re: rear axle nut torque

Never back off a torqued nut/bolt. Start low and work up but never back off.
Forum: Model T (1909-1927) 01-21-2020, 07:48 PM
Replies: 3
Views: 133
Posted By redmodelt
Re: Door opening

Tourings from about 1913 to 1925 had suicide doors in the rear and coupes from about 1915 up to introduction of the 1924 models.
Forum: Model A (1928-31) 01-21-2020, 01:50 AM
Replies: 15
Views: 515
Posted By redmodelt
Re: 1929 Model A-Wood

You might title this as "Need help re wooding 1929 tudor" to get help and maybe say which pieces of wood you are needing help with. You could also google "Model A two door wood"
This might help if...
Forum: Model A (1928-31) 01-21-2020, 01:40 AM
Replies: 4
Views: 255
Posted By redmodelt
Re: AA body building

Maybe if you can post some photos of what you are working with we can make some suggestions. What year?
Forum: Model T (1909-1927) 01-21-2020, 12:17 AM
Replies: 4
Views: 219
Posted By redmodelt
Re: Motometer

No one that I have seen in many years has supplied the Jr. meter thermometer new. One of those you can buy them new or where do they get parts from to rebuild for the Kingston carb questions, they...
Forum: Model T (1909-1927) 01-21-2020, 12:11 AM
Replies: 1
Views: 82
Posted By redmodelt
Re: Tool kit/display question

Best bet would to make his own. It's not hard to find listing of what tools came with the car and which versions would be correct for the year.
...
Forum: Model T (1909-1927) 01-20-2020, 11:57 PM
Replies: 9
Views: 316
Posted By redmodelt
Re: early ford development water cooled vs air cooled

https://www.macsmotorcitygarage.com/henry-fords-incredible-x-8-engine/
Yes also Edison was working on an electric car.

https://www.wired.com/2010/06/henry-ford-thomas-edison-ev/
Forum: Model A (1928-31) 01-20-2020, 10:18 PM
Replies: 18
Views: 814
Posted By redmodelt
Re: Missing Valve seat

The Green books shows valve seat inserts for as early as the 33 100HP engine. Seems to me I was told there were some factory A or B blocks that had insert exhaust seats?
Forum: Model A (1928-31) 01-20-2020, 08:11 PM
Replies: 28
Views: 974
Posted By redmodelt
Re: Cap and Comp Jet Helicoil repair

What about making some thin wall inserts using US thread but drilled and tapped for the 5m.75 thread.
Forum: Model A (1928-31) 01-20-2020, 11:56 AM
Replies: 28
Views: 974
Posted By redmodelt
Re: Cap and Comp Jet Helicoil repair

https://www.snydersantiqueauto.com/ProductDetail/A-9574_COMPENSATOR-JET-TAP?fromCategory=Products/model-a/carburetor/gaskets-parts


https://en.wikipedia.org/wiki/Zenith_Carburetor_Company
They...
Forum: Model A (1928-31) 01-20-2020, 12:02 AM
Replies: 7
Views: 332
Posted By redmodelt
Re: Rear brake arm binding

I have found that the tube that the shaft runs in gets worn between it and the lever and the dust ring wants to slip down and jam in the worn hole where the shaft fits. The last one I did I just...
Forum: Model A (1928-31) 01-18-2020, 01:51 PM
Replies: 10
Views: 579
Posted By redmodelt
Re: inside paint

https://www.google.com/search?client=firefox-b-1-d&q=Glyptal+Red+Insulating+Varnish
Forum: Model A (1928-31) 01-17-2020, 07:52 PM
Replies: 39
Views: 1,653
Posted By redmodelt
Re: Non-Authentic Paint Colors & Schemes

While yes after 1914 and before 1926 all T's were painted black because the paint dried faster. That is only part of the story. With the high volume of T's being made there really wasn't time to...
Forum: Model A (1928-31) 01-16-2020, 09:49 PM
Replies: 14
Views: 683
Posted By redmodelt
Re: Looking for LED replacement bulbs for tail and cowl lights

This is the one I am going to try next for single contact brake light;
https://www.ledlight.com/1156-miniature-bulb-6-volt-ba15s-base-60-smd.aspx
Forum: Model A (1928-31) 01-16-2020, 11:44 AM
Replies: 14
Views: 683
Posted By redmodelt
Re: Looking for LED replacement bulbs for tail and cowl lights

I ran the 1129 shown directly off a good battery for my test. 1129 would be for a stand alone brake light in brightness, the one I tested at 6V was more in the dim tail light range.
Forum: Model A (1928-31) 01-16-2020, 01:30 AM
Replies: 17
Views: 717
Posted By redmodelt
Re: Cracked Head

Re the head gasket area and around the crack.
That area along the head and block looks to be copper-coat not rust.
Forum: Model A (1928-31) 01-15-2020, 08:04 PM
Replies: 14
Views: 683
Posted By redmodelt
Re: Looking for LED replacement bulbs for tail and cowl lights

Are you running 12 volts? Those are the 1129 bulbs I was talking about.
Forum: Questions & Suggestions 01-14-2020, 07:54 PM
Replies: 1
Views: 170
Posted By redmodelt
Re: Early 5 lug type RH wheels for sale

Your ad needs to be in the classifieds for the year the parts fit. Few people will even see it here. There may be someone out there that can tell you what year they fit if you do not know. I suggest...
Forum: Model A (1928-31) 01-14-2020, 07:43 PM
Replies: 3
Views: 356
Posted By redmodelt
Re: 1931 Victoria Doors, Henry Forgot Something

And now for the rest of the story;
https://www.fordbarn.com/forum/showthread.php?t=275338
Forum: Model A (1928-31) 01-14-2020, 07:41 PM
Replies: 3
Views: 219
Posted By redmodelt
Re: Electric Lighting

He posted also in the T section.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:32 AM.