Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: Newc
Forum: Early V8 (1932-53) 07-08-2020, 12:10 AM
Replies: 22
Views: 1,072
Posted By Newc
Re: Wet sand blasting??

Hi; The commercial unit showed up at my place ,contained on a car trailer, compressor and all. Hooked up to my water hose and wet-blasted a '39 cpe shell in my gravel yard. One yr later no rust as I...
Forum: Early V8 (1932-53) 07-07-2020, 12:03 AM
Replies: 14
Views: 438
Posted By Newc
Re: 47 pickup second gear pops out

This soooo common and yes it is 'worn out'. I suffer with 2 cars that do this and the fix is a really good rebuild. DO NOT race with your old Ford transmissions, those days are past. Good gears are...
Forum: Early V8 (1932-53) 07-02-2020, 11:16 PM
Replies: 40
Views: 1,232
Posted By Newc
Re: Antique Insurance a little off Topic

Hi; I had Safeco for 20+ yrs and my collector cars also and then I turned 70, and they went ballistic, with huge unreasonable increases. Dropped them for everything!! Newc
Forum: Early V8 (1932-53) 07-02-2020, 11:08 PM
Replies: 19
Views: 651
Posted By Newc
Re: 1936 ford pickup

Great- just NEVER sell any of the original sheet metal- It can't be replaced these days. Newc
Forum: Early V8 (1932-53) 06-30-2020, 11:19 PM
Replies: 2
Views: 355
Posted By Newc
WW2 surplus '40 parts [pass&trk]

At a Military Swap I saw these on a table, advertised as '40 horn button assemblies. Bought 2 and sure enough here is the result. The cardboard boxes were wrapped in cheese cloth and dipped in...
Forum: Early V8 (1932-53) 06-28-2020, 12:33 AM
Replies: 11
Views: 638
Posted By Newc
Re: Will a 33-34 windsheild crank fit a 35-36 car?

I have a '36 in need of repair on one set of teeth for $25 shipping in USA included. Newc
Forum: Early V8 (1932-53) 06-24-2020, 11:07 PM
Replies: 24
Views: 739
Posted By Newc
Re: Split rim, wide 5?

Hi; appears to be an outside edge locking ring and those are safe. All my military trucks use them. There were Marmon-Herrington 4wd '39 wagons made for the British in WW2, as well as 40/41 wagons. A...
Forum: Early V8 (1932-53) 06-21-2020, 05:38 PM
Replies: 70
Views: 5,406
Posted By Newc
Re: Rare Deuce parts thread

OOPs--- here are the photos Newc
Forum: Early V8 (1932-53) 06-21-2020, 05:37 PM
Replies: 70
Views: 5,406
Posted By Newc
Re: Rare Deuce parts thread

Hi all; Gotta jump in here.. I sold my single pull latches when I found these: The two on the left with the odd bases are WW2 GM truck hood latches- over 500K trucks mfg'd with 2 latches each! The...
Forum: Early V8 (1932-53) 06-21-2020, 05:18 PM
Replies: 13
Views: 578
Posted By Newc
Re: Ignition key

Hi; Same problem with my '35 Ford... Burglar got into my storage garage and stole the only set of keys from the ign lock. He got the column key, door key and spare tire lock key. I am currently...
Forum: Early V8 (1932-53) 06-19-2020, 11:18 PM
Replies: 8
Views: 556
Posted By Newc
Re: Bent rear axles? never seen one?

Hi again; Checked my axles between centers and one had a small .005" wobble, seemed to be the threaded portion. So chucked the gear in the chuck and used a carry stand to hold the axle and yes the...
Forum: Early V8 (1932-53) 06-15-2020, 08:18 PM
Replies: 8
Views: 556
Posted By Newc
Bent rear axles? never seen one?

Hi; I am selling some 18 tooth axles [35/36], and a customer asked if they are bent? I never heard of such a problem, especially a" bent taper". Is this possible and if so is there a repair...
Forum: Early V8 06-14-2020, 09:12 PM
Replies: 0
Views: 103
Posted By Newc
18 tooth Axles [4]-carriers [2]-35/36 housings pr

Just disassembled 3-- 35/36 rear differentials and kept the best parts, scrapped the bad or rusty stuff. the [4] axles are nice no damage.[2] Carriers and spider gears look good. The housings [pr]...
Forum: Early V8 (1932-53) 06-14-2020, 12:45 AM
Replies: 26
Views: 888
Posted By Newc
Re: VIN on '32 commercial frame

Hi; I have 3 '32 BB truck frames here and all have the good Ford numbers in the correct spot by the left firewall foot area. they are stamped fairly well, but only once. Newc
Forum: Early V8 (1932-53) 06-13-2020, 07:49 PM
Replies: 4
Views: 195
Posted By Newc
Re: 1953 M250 Classic questions

The real important parts are the Mercury truck trim and interior trim. I restored a M47 [48] and it was difficult to save all those Mercury only trim pieces. Newc
Forum: Early V8 06-13-2020, 11:42 AM
Replies: 0
Views: 170
Posted By Newc
16" Goodyear "Air wheels" collection of 7 !!!

This is a lifetime collection of these special aftermarket wheels for Early Fords. that is correct 5 on 51/2" bolt circle. These wheels are the 'Solid' type - NO vent holes in the center hubs....
Forum: Early V8 06-12-2020, 09:27 PM
Replies: 0
Views: 120
Posted By Newc
Old Spark plug collection shipping in USA incl'd

Cleaning out the barn find and found this collection... Champion 7 [6], Pink Firestone [2], an old Champion 3 piece- like in the new V8 Times, and a GREEN Splitdorp ???? Hey, I'd bet the GREEN...
Forum: Early V8 (1932-53) 06-12-2020, 07:00 PM
Replies: 6
Views: 296
Posted By Newc
Re: FoMoCo and Ford script stamped 16 x 4.5 wheels.

Hi; when you install those wheels, you may notice the 'outie' has less threads showing, of the studs. One V8 member has noticed different appearing lug nuts also. He has some lug nuts with a...
Forum: Early V8 06-10-2020, 10:08 PM
Replies: 0
Views: 84
Posted By Newc
['32] 33-36 Standard weight Axle -nice part

Cleaned, blasted, primed and blk epoxy paint. Looks straight and good holes for kingpins and spring hangers. 2" boss, will drop your Model A 2" also. Mo's or paypal 'friend'. Ship USA only. It's...
Forum: Early V8 06-10-2020, 10:01 PM
Replies: 0
Views: 87
Posted By Newc
Headliner bows-14- Lot sale from estate

*******************Sold, they were '39/40 cpe!!!*******************************
Forum: Early V8 06-10-2020, 09:52 PM
Replies: 0
Views: 65
Posted By Newc
36-39 Spare tire assembly part??

I had to remember where I've seen these, and I believe it is part of the spare tire cover '36. any way it looks like a bowl or frisbee. so here goes fellows . check, MO, or paypal 'friend'. Shipping...
Forum: Early V8 (1932-53) 06-09-2020, 11:57 PM
Replies: 9
Views: 412
Posted By Newc
Re: Electric Wiper motor (Vintique)

Yes; That is a commercial motor and we have them in the local buses. Will work, but some fiddling is required. the 'stroke' can be too long and too powerful. Newc
Forum: Early V8 (1932-53) 06-07-2020, 11:31 AM
Replies: 41
Views: 1,332
Posted By Newc
Re: Drive shaft lock pin

Loctite co. makes a product for loose splines. It is used industrially and on driveshaft splines [large trucks] Amazon has it but can not ship it so I had to get it from Fastenal. There is a...
Forum: Early V8 06-05-2020, 04:27 PM
Replies: 0
Views: 47
Posted By Newc
Chrome tailgate latch [woodie?]

$40 shipping in USA included Chrome latch that appears to be 'woodie' type.
Nice and clean, works fine, No water damage. 'Patina' Chrome
Just the one from the clean-out. check, MO, paypal...
Forum: Early V8 (1932-53) 06-05-2020, 02:21 PM
Replies: 4
Views: 202
Posted By Newc
Re: 34 pickup door gaskets?

Those early trucks were not wind tight. Tough guys drove them. Newc
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:13 AM.