Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 499
Search took 0.02 seconds.
Search: Posts Made By: Juergen
Forum: Early V8 02-23-2024, 07:04 PM
Replies: 1
Views: 347
Posted By Juergen
Forum: Early V8 (1932-53) 02-17-2024, 11:27 AM
Replies: 12
Views: 538
Posted By Juergen
Re: 1935 sedan delivery rear door latch

Great looking delivery and glad you found a lock. Mine is a 39 delivery and looked just like your body. It was in a junk yard with the frame cut off in the front and back just before the rear end. ...
Forum: Early V8 (1932-53) 02-14-2024, 10:24 AM
Replies: 12
Views: 538
Posted By Juergen
Re: 1935 sedan delivery rear door latch

It is unique to Sedan Deliveries from 35-39.
Forum: Early V8 (1932-53) 02-12-2024, 10:45 AM
Replies: 14
Views: 811
Posted By Juergen
Re: Strange metal welded to torque tube

If a previous owner converted to juice brakes, he needed a bracket for the parking brake cable. . Ford had a bracket attachment where the radius rods attach to the torque tube. This one looks way...
Forum: Early V8 (1932-53) 01-24-2024, 11:11 AM
Replies: 9
Views: 567
Posted By Juergen
Re: what size resistor ????

My Ford heater switch measures between 1-1.5 ohms. Even though it is NOS, the switch is put together by compressing the connections which makes the actual resistance fluctuate by the contact...
Forum: Early V8 (1932-53) 01-19-2024, 09:44 AM
Replies: 7
Views: 834
Posted By Juergen
Re: Remove Trans from 21 stud 36 flattie

If you have a pilot bearing instead of a bushing, the input shaft could be frozen on the bearing. Get two longer bolts (or studs) to support the trans but allow the trans to move back out. See if...
Forum: Early V8 12-30-2023, 10:23 AM
Replies: 1
Views: 347
Posted By Juergen
Rebuilt 1939 Ford transmission

Nice tight rebuilt 1939 Ford style transmission. Standard gear set with 28 tooth cluster. All parts hot tank cleaned and shot peened for final cleaning and stress relief. Good gears with usual...
Forum: Early V8 (1932-53) 12-18-2023, 07:26 PM
Replies: 11
Views: 736
Posted By Juergen
Repro 1940 Deluxe die cast grilles

Based on your experiences, how do you rate the die cast grilles from Drake, CWMoss, Speedway, and "made in the US" suppliers?
Forum: Early V8 (1932-53) 12-13-2023, 08:58 AM
Replies: 7
Views: 636
Posted By Juergen
Re: Valve removal slide hammer?

Thanks, Tim, Just what I was looking for. Juergen
Forum: Early V8 (1932-53) 12-12-2023, 04:12 PM
Replies: 7
Views: 636
Posted By Juergen
Valve removal slide hammer?

I bought this at a swap meet and the fellow thought his dad used it on flatheads to remove valves. The feet have what look like the ends of the flathead spring compressors. When the slide is pulled...
Forum: Early V8 11-26-2023, 01:03 PM
Replies: 1
Views: 358
Posted By Juergen
Forum: Early V8 (1932-53) 11-22-2023, 09:42 AM
Replies: 16
Views: 957
Posted By Juergen
Re: Stock ammeter and 12V conversion - query

The inductive ammeter is failure proof in the sense if it goes bad, nothing bad will happen. Most (all?) add on ammeters are directly in the circuit and if they open, the generator/alternator can...
Forum: Early V8 11-04-2023, 08:52 AM
Replies: 0
Views: 239
Posted By Juergen
1940 Ford Deluxe grille

Nice 1940 Ford Deluxe grille with no breaks. Die cast is in nice shape and has great "patina". Outer stamped pieces include the stainless moldings. The chin and hood latch are also there

Will...
Forum: Early V8 (1932-53) 10-17-2023, 08:00 AM
Replies: 10
Views: 611
Posted By Juergen
Re: 1946 ford lamp circuit breaker help

It should not be there as Henry built it.
Forum: Early V8 (1932-53) 10-04-2023, 08:00 AM
Replies: 31
Views: 2,250
Posted By Juergen
Re: 40 Ford Ignition Woes

You can eliminate the cap/rotor by checking the output of the coil. No spark there (along with no spark at a plug) says it is not a cap/rotor problem.

You have 6.2 volts at the coil. What do...
Forum: Early V8 (1932-53) 10-03-2023, 10:10 AM
Replies: 5
Views: 445
Posted By Juergen
Re: 38 Ford Deluxe Fenders on a 40 Ford Half Ton?

38 deluxe fenders use 37-38 and 39 standard running boards which are significantly different than 40 running boards so the fender mounts are different. I believe 39 deluxe fenders may fit a 40 but...
Forum: Early V8 (1932-53) 10-01-2023, 01:08 PM
Replies: 31
Views: 2,250
Posted By Juergen
Re: 40 Ford Ignition Woes

The first thing I check when a car just stops as check if an ignition or gas problem. Take off the air cleaner and work the throttle to see if the accelerator pump squirts out gas. If so fuel is...
Forum: Early V8 (1932-53) 08-30-2023, 01:55 PM
Replies: 6
Views: 402
Posted By Juergen
Re: Always Showing Charge

The ammeter seems to be wired correctly as it shows a discharge when a load is applied and a charge when running.
If your car has a regulator and the generator power is sufficient, you won't see a...
Forum: Early V8 (1932-53) 08-27-2023, 12:48 PM
Replies: 6
Views: 402
Posted By Juergen
Re: Always Showing Charge

With the engine off, what does the amp show when you turn the lights on?
Forum: Early V8 (1932-53) 08-04-2023, 08:20 AM
Replies: 23
Views: 1,659
Posted By Juergen
Re: 1939 Pedal Assy

Uncle Buck covered this
Forum: Early V8 07-23-2023, 02:41 PM
Replies: 1
Views: 358
Posted By Juergen
Rebuilt 1939 Ford style open transmission (42-50 pickup)

Rebuilt 1939 Ford style (double blocker synchro) trans but for open drive applications (like 42-50 Ford pickups). All parts hot tank cleaned and inspected for good gears. New ball bearings,...
Forum: Early V8 07-19-2023, 01:57 PM
Replies: 0
Views: 215
Posted By Juergen
transmission U-joint and drive shaft clam shells

Nice tight u-joint and a good used set of clam shells for 1932-1948 Ford transmission. Price for each is $60 which includes shipping.


I can be reached through this site or at...
Forum: Early V8 07-15-2023, 04:31 PM
Replies: 0
Views: 308
Posted By Juergen
Nice 1940 Ford Deluxe dash

1940 Ford Deluxe dash looks like early take off. Has been a wall hanger for 30 years. Mostly all there. Uses early year push up ash trays. All gauges tested as OK by momentarily applying 6 v and...
Forum: Early V8 07-15-2023, 03:24 PM
Replies: 0
Views: 183
Posted By Juergen
1940 Ford Standard Dash

Used 1940 Ford Standard Dash mostly complete. Wall hanger for 30 years. Has later year pull out ash trays. All gauges tested as OK by momentarily applying 6 volts and noting needle starts to move. ...
Forum: Early V8 07-12-2023, 11:41 AM
Replies: 0
Views: 273
Posted By Juergen
1940 - 41 Ford crank pulley

Good used crank mounted pulley for 40-41 Fords.

$50 includes shipping in the lower 48.
Showing results 1 to 25 of 499

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:55 PM.