Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 73
Search took 0.01 seconds.
Search: Posts Made By: Dan/Kzo
Forum: Model A (1928-31) 06-06-2020, 04:59 PM
Replies: 5
Views: 385
Posted By Dan/Kzo
Re: Gilmore Museum, Mon. June 8 Members Only

John, a MARC member is not a Gilmore member. A MAFFI member is also not a Gilmore member. However, a MAFFI member can enter the Gilmore campus to see the Model A museum plus all the other marquee...
Forum: Model A (1928-31) 06-06-2020, 04:53 PM
Replies: 23
Views: 935
Posted By Dan/Kzo
Re: Catseye gas gauge

My Sport Coupe has one of these lenses. I had no issues with assembly using cork gaskets.
Forum: Model A (1928-31) 08-23-2019, 08:17 PM
Replies: 30
Views: 3,689
Posted By Dan/Kzo
Re: Radial Tires

The new American Classic Cokerís are the catís meow. They fit the wheel well just fine on my 31. Only 1500 miles so far. Day and night difference. I wonít go back to the bias Goodyearís or...
Forum: Model A (1928-31) 08-05-2019, 07:10 AM
Replies: 8
Views: 932
Posted By Dan/Kzo
Re: Distributor question

If a wireless lower plate was used, such a hard starting condition an occur when the tab rubbing against the bottom plate developed an electrical wear path.
Forum: Model A (1928-31) 03-30-2019, 05:44 AM
Replies: 11
Views: 874
Posted By Dan/Kzo
Re: Tire rubbing

In addition to the long nut mentioned above, make sure the lock washer is behind the nut. Even a missing lock washer can cause the tires to rub the brake rods.
Forum: Model A (1928-31) 02-07-2019, 06:59 PM
Replies: 24
Views: 3,886
Posted By Dan/Kzo
Still no Tom

Been almost 2 months I think. Has anyone corresponded with Tom Wesenberg? Donít remember his trips being this long with surfacing here on the board. Doesnít seem right.
Forum: Model A (1928-31) 01-05-2019, 06:39 AM
Replies: 9
Views: 625
Posted By Dan/Kzo
Re: Marvel schebler main jet flow rate

Google pin vice drill bits for some options
Forum: Model A (1928-31) 10-12-2018, 05:58 AM
Replies: 20
Views: 2,580
Posted By Dan/Kzo
Re: A Model A Thinking out Loud.

A fun read over a morning cup of coffee. Thanks Jack
Forum: Model A (1928-31) 08-22-2017, 08:22 PM
Replies: 79
Views: 13,200
Posted By Dan/Kzo
Re: Spicey Car Photos

There was a car in that pic??
Forum: Model A (1928-31) 07-01-2017, 07:13 PM
Replies: 7
Views: 1,085
Posted By Dan/Kzo
Re: Farmer fix Volt drop?

If I had that on my A, I would get dinged at the annual safety check. Yes, very interesting.
Forum: Model A (1928-31) 02-21-2017, 07:02 AM
Replies: 11
Views: 1,405
Posted By Dan/Kzo
Re: Hastings 60 rings

This should help.
Forum: Model A (1928-31) 12-29-2016, 05:30 PM
Replies: 6
Views: 1,088
Posted By Dan/Kzo
Re: Radiator baffle

Check the level when the engine is hot at a fast idle
Forum: Model A (1928-31) 11-28-2016, 07:19 AM
Replies: 10
Views: 1,772
Posted By Dan/Kzo
Re: Sport coupe values

$7000. If the top is nice then a little more
Forum: Model A (1928-31) 08-17-2016, 07:26 PM
Replies: 1
Views: 833
Posted By Dan/Kzo
Re: Brumfield head gasket

I am 6 or 7 years on a Best 509G with a Brumfield 5.9
Forum: Model A (1928-31) 07-17-2016, 10:44 PM
Replies: 11
Views: 1,541
Posted By Dan/Kzo
Re: car leans can the springs be fixed?

I have the same left side lean on the tudor. A couple years ago I purchased an new front spring, lubed it and installed it. Then I disassembled the rear, smoothed the grooves, lubed, alternately...
Forum: Model A (1928-31) 01-11-2016, 06:11 PM
Replies: 43
Views: 6,710
Posted By Dan/Kzo
Re: Forget Finding an Honest Man Diogenes, Find Me a Good Battery

After reading through the current thread regarding Optima batteries, I would not buy one.
Forum: Model A (1928-31) 06-13-2015, 12:03 PM
Replies: 18
Views: 3,277
Posted By Dan/Kzo
Re: will not idle down

Does this new engine have a lightened flywheel?
Forum: Model A (1928-31) 05-31-2015, 05:45 AM
Replies: 33
Views: 7,579
Posted By Dan/Kzo
Re: License Plate Letters

The easiest method is spray 4 coats of the letter color over the entire plate then 2 coats of the background color. Then lightly sand over the letters with fine sand paper to bring out your color ...
Forum: Model A (1928-31) 04-06-2015, 07:40 PM
Replies: 18
Views: 2,116
Posted By Dan/Kzo
Re: Locked up rear end

Take the shift tower off and make sure it is actually in neutral.
Forum: Model A (1928-31) 02-08-2015, 06:18 PM
Replies: 443
Views: 108,429
Posted By Dan/Kzo
Forum: Model-A 01-02-2014, 08:44 AM
Replies: 12
Views: 2,275
Posted By Dan/Kzo
Re: New Model A Trunk, Rack and more

I will take the trunk rack. let me know total shipped to 49009. Dan Cargo 269-207-5147. dkcargo@sbcglobal.net thanks
Forum: Model A (1928-31) 10-08-2013, 07:21 PM
Replies: 10
Views: 1,626
Posted By Dan/Kzo
Re: Radiator level question

after doing post #3, you may be able to check and see the level when engine is hot at fast idle
Forum: Model A (1928-31) 10-08-2013, 07:09 PM
Replies: 13
Views: 3,195
Posted By Dan/Kzo
Re: Reasons for deceleration vibration

Much good wisdom and feedback here for me to work with, thanks to all who posted. Steve, it would have never occurred to me that a finely tuned "how low will it go" Zenith could fit into this...
Forum: Model A (1928-31) 10-07-2013, 06:28 PM
Replies: 13
Views: 3,195
Posted By Dan/Kzo
Re: Reasons for deceleration vibration

Thanks for the responses and here are answers to posted questions. post #3) vibration appears instantly when I let off, and it does not appear to change whether I brake hard or soft. #4) original...
Forum: Model A (1928-31) 10-06-2013, 07:37 PM
Replies: 13
Views: 3,195
Posted By Dan/Kzo
Reasons for deceleration vibration

When the cold weather settles in I would like to investigate and correct the vibration my truck has when decelerating. It is a pretty good vibration/rumble when the foot comes off the gas pedal. I...
Showing results 1 to 25 of 73

Forum Jump
Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 09:12 PM.