Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Page 1 of 20 1 234511 Last »
Showing results 1 to 25 of 500
Search took 0.03 seconds. Search: Posts Made By: Oldbluoval
Forum: Model A (1928-31) 01-19-2021, 05:36 PM
Replies: 10
Views: 458
Posted By Oldbluoval
Re: front fender brace straightening

Mostly 29 light bar is straighter than 30-31
Lay it out and see if it’s symmetrical
Forum: Model A (1928-31) 01-19-2021, 04:46 PM
Replies: 10
Views: 458
Posted By Oldbluoval
Re: front fender brace straightening

Bobs correct
Using a press works better but it takes.a bunch of
“Off and ons” and trial fittings
Forum: Model A (1928-31) 01-18-2021, 10:05 AM
Replies: 8
Views: 642
Posted By Oldbluoval
Re: NOS paint thickness

The biggest culprit I’ve seen is overloading the substrate
It used to be really bad when red oxide and lacquer-based putty’s were around
Load it up and chips in months. Too much of the new...
Forum: Model A (1928-31) 01-18-2021, 08:25 AM
Replies: 18
Views: 697
Posted By Oldbluoval
Re: Rumble Seat Hinges part 2

Just a sidebar
The best way to restore a deck lid is to take it apart. Separate the liner and skin.
That allows access to the inside to completely clean and repair. The d nuts and a reinforcement...
Forum: Model A (1928-31) 01-15-2021, 09:59 PM
Replies: 6
Views: 298
Posted By Oldbluoval
Re: Door latches

Bert’s may have good or restorable originals
They’re better than repo
Forum: Model A (1928-31) 01-15-2021, 06:28 PM
Replies: 7
Views: 395
Posted By Oldbluoval
Re: Replacing Roadster Door Lower Seal

The hammer/screwdriver is about what I’ve done
Heat gun could get paint and upholstery assuming it matters
Forum: Model A (1928-31) 01-09-2021, 10:00 AM
Replies: 4
Views: 260
Posted By Oldbluoval
Re: Model A Beltline Variations?

The doors are the same
So something else is wrong with all this
Sure you’re not mixing up 28-29 and 30-31?
Belt rails do have different shape so should be evident
Forum: Model A (1928-31) 01-07-2021, 08:12 PM
Replies: 20
Views: 585
Posted By Oldbluoval
Re: posting a pic

Resize
Forum: Model A (1928-31) 01-07-2021, 08:58 AM
Replies: 2
Views: 198
Posted By Oldbluoval
Re: cowl patch

No it has the contour you describe
The better panels (sipe) are closer than the others are
Forum: Model A (1928-31) 01-04-2021, 04:21 PM
Replies: 11
Views: 934
Posted By Oldbluoval
Re: 68C and A400

I make them out of aluminum and polish. Small screws mount them from the backside
Originals were plated pot metal.
I don’t really know what water plating is.....maybe I live under a rock!
Forum: Model-A 01-03-2021, 04:16 PM
Replies: 1
Views: 179
Posted By Oldbluoval
Re: Window riser handle 31 Vic a400

Sold
Forum: Model-A 01-03-2021, 09:19 AM
Replies: 1
Views: 179
Posted By Oldbluoval
Window riser handle 31 Vic a400

Sold


6 original window cranks. Squares are unbroken
$85 shipped USA
Will post pic later
Please direct email to oldbluoval@gmail.com, no PM pls
Forum: Model A (1928-31) 01-02-2021, 01:51 PM
Replies: 14
Views: 727
Posted By Oldbluoval
Re: Nitrocellulose

If you have the paint and it’s been stored properly, why not use it? Maybe I’m misreading that you had paint but no longer have such?
Certain things should be addressed such as substrate and...
Forum: Model A (1928-31) 01-01-2021, 09:57 PM
Replies: 20
Views: 1,458
Posted By Oldbluoval
Re: Model A Victoria

The USPS used to give a lesser rate if it was a magazine or book; don’t know if that’s still exists. I wouldn’t pay $14.50 either; that should mail for $6+-
Forum: Model A (1928-31) 01-01-2021, 04:11 PM
Replies: 17
Views: 973
Posted By Oldbluoval
Re: Are aftermarket hoods any good?

Antiquepa.....
Do you know who made it? As above and with me, I’ve never had one problem with a rootlieb
Forum: Model A (1928-31) 12-31-2020, 04:24 PM
Replies: 17
Views: 973
Posted By Oldbluoval
Re: Are aftermarket hoods any good?

Other than the ones I’m hoarding......
It’s been ages since I’ve seen a really good top.
Louvers are out there but tops are usually beat up, wallowed around, stretched, hinge broken and hard to...
Forum: Model A (1928-31) 12-30-2020, 12:08 PM
Replies: 3
Views: 330
Posted By Oldbluoval
Re: Will a 31 Cabrio Quarter fix a Coupe Quarter from the Body line down?

28 29 might 30 31 won’t
Some have different reveals around rear wheel wells also
Re-read....no, a cabby won’t readily fix a 31 coupe
Forum: Model A (1928-31) 12-30-2020, 04:39 AM
Replies: 3
Views: 411
Posted By Oldbluoval
Re: 31 slantwindow

Vicky doors are wider
Inner won’t work.
Nobody makes a decent outer. The outer bead has a slight arch in it rather than straight
When installed a straight one looks like it dips
Forum: Model A (1928-31) 12-29-2020, 11:09 AM
Replies: 2
Views: 181
Posted By Oldbluoval
Re: Wanted to know the #'s for rear bumper cross brace

What month 31?
Most later 31 take the one with the boss for the bolt for strength
Forum: Model A (1928-31) 12-28-2020, 07:51 PM
Replies: 17
Views: 973
Posted By Oldbluoval
Re: Are aftermarket hoods any good?

I’ve used 30-31 made by rootlieb with success
No report for 28-29
Forum: Model A (1928-31) 12-28-2020, 11:56 AM
Replies: 19
Views: 902
Posted By Oldbluoval
Re: Using magnets instead of holes

Be aware that they will scratch finishes even by small vibrations
If u care
Forum: Model A (1928-31) 12-28-2020, 09:18 AM
Replies: 9
Views: 468
Posted By Oldbluoval
Re: Wood rot - wood hardener

Are you attempting to stabilize to hold nails and/or screws. If so, forget it ....never had acceptable results to me
Forum: Model A (1928-31) 12-26-2020, 01:42 PM
Replies: 26
Views: 1,645
Posted By Oldbluoval
Re: Never Tried To Restore

A funny thing about me and stripping...
I’m right handed. I can stripe the drivers side going front to rear to my so~so satisfaction.
Then there’s the passengers side.....OMG. You’d think going...
Forum: Model A (1928-31) 12-25-2020, 09:33 AM
Replies: 63
Views: 3,906
Posted By Oldbluoval
Re: Signs, back in the day

Over my favorite burger (and other) bar in college

Our credit manager is Helen Waite
If you want credit go to Helen Waite
Forum: Model A (1928-31) 12-24-2020, 10:44 AM
Replies: 4
Views: 808
Posted By Oldbluoval
Re: Yet another scammer

Flathead
The word scam is enough for me
The email address will change every time
Stay away from people just joining until u know more in every case
Showing results 1 to 25 of 500
Page 1 of 20 1 234511 Last »

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:30 PM.