Forum: Early V8 (1932-53)
04-10-2019, 03:57 AM
|
Replies: 11
Views: 1,609
Re: schramm air compressor
Mick
If you dont get any info via the forum, try the Chinchilla Museum in qld
I visited there a few year ago and they had a compressor generator setup
They may have manuals
Web address is...
|
Forum: Early V8 (1932-53)
09-21-2016, 06:01 AM
|
Replies: 105
Views: 27,130
Re: Fords in the Fall
Hi
Photo of my 35 ute taken in Canberra (Aust) in Autumn (Fall) earlier this year taken by my son.
Roger
35 ute
|
Forum: Early V8 (1932-53)
05-10-2016, 05:42 AM
|
Replies: 10
Views: 2,394
|
Forum: Early V8 (1932-53)
05-09-2016, 07:30 AM
|
Replies: 9
Views: 2,264
Re: 40 Helmet distributor shaft movement
If you have a number of different rotors, you will find that they have different lengths due to wear, manufacturing tolerances or supplier differences. Pick the one that gives the appropriate fit -...
|
Forum: Early V8 (1932-53)
05-09-2016, 05:10 AM
|
Replies: 10
Views: 2,394
|
Forum: Early V8 (1932-53)
01-21-2016, 05:25 AM
|
Replies: 6
Views: 2,126
Re: Dimensioned drawing of flathead V8 engine
Thanks for responses. The “dead stop” method and the two piston method I mentioned are very similar in sensitivity. The latter is best explained by the attached instructions and drawing from the...
|
Forum: Early V8 (1932-53)
01-20-2016, 06:46 AM
|
Replies: 6
Views: 2,126
Dimensioned drawing of flathead V8 engine
I have been reviewing all the posts in relation to finding TDC and setting the initial timing – this forum has been a fantastic source of information - thanks.
As well as the various other methods...
|
Forum: Early V8 (1932-53)
01-06-2016, 04:32 AM
|
Replies: 11
Views: 2,916
Re: Milesmor Timing Device
For the crab and pre 42 type distributors, the timing plate is held in by a large wire ring type retainer – easily removed with a screw driver. If you don't have an IPB, check out this website below...
|
Forum: Early V8 (1932-53)
01-05-2016, 05:04 AM
|
Replies: 11
Views: 2,916
Re: Milesmor Timing Device
There are two types of Milesmor tools, instructions are similar in most (not all) respects. Attached are photos of original pre 42 instructions. Not sure if they are readable.
Just in case, the...
|
Forum: Early V8 (1932-53)
12-21-2015, 06:41 AM
|
Replies: 19
Views: 5,379
Re: Dimensioned drawing of flathead engine
I have been reviewing all the posts in relation to finding TDC and setting the initial timing – this forum has been a fantastic source of information.
As well as the various other methods mentioned...
|