Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: Terry,OH
Forum: Early V8 (1932-53) Today, 08:28 AM
Replies: 4
Views: 141
Posted By Terry,OH
Re: 35 Ford Exterior Door Handle

The 38 hardware book indicates the front can be used on the rear if the rear handle was not available. It appears to be a simple drill and tap for the 10-32 screw, if necessary.
Forum: Early V8 (1932-53) Today, 08:19 AM
Replies: 3
Views: 313
Posted By Terry,OH
Re: Ford stroboscope

As mentioned above by Juergen but depending upon what model you have. Big difference between the pre and post war machines.
Forum: Early V8 (1932-53) Today, 08:08 AM
Replies: 4
Views: 141
Posted By Terry,OH
Re: 35 Ford Exterior Door Handle

The 3W and the Cabriolet also used die cast handles, but the Conv. Sedan handle is unique. The 3W and Cabriolet handle shaft has a recess in the square operator shaft. I bought 48-702350 from Mac's...
Forum: Early V8 (1932-53) Yesterday, 05:48 AM
Replies: 10
Views: 366
Posted By Terry,OH
Re: ford aluminum heads

If the heads you have now have a part number embossed what is it? This could give you a good idea if they are for flat top pistons. Otherwise the best way to tell is to remove a head.
Forum: Early V8 (1932-53) 10-24-2020, 05:24 PM
Replies: 10
Views: 366
Posted By Terry,OH
Re: ford aluminum heads

Since your car does not have the original heads, you have to make sure the pistons are flat top otherwise the original 35 style heads will not work.
Forum: Early V8 (1932-53) 10-17-2020, 05:58 AM
Replies: 14
Views: 555
Posted By Terry,OH
Re: 33 Tranny to Driveshaft Oil Leak

The bearing can be replaced with a bearing that has a seal on one side, the output side. You may have too much oil in the case.
Forum: Early V8 (1932-53) 10-12-2020, 07:59 AM
Replies: 23
Views: 1,073
Posted By Terry,OH
Re: '37 Ford all locked up

I agree the locked up condition does sound like the transmission is in two gears. It also sounds like the battery is bad. I suggest he take the battery to an auto parts store and have it tested or...
Forum: Early V8 (1932-53) 10-10-2020, 10:51 AM
Replies: 3
Views: 203
Posted By Terry,OH
Re: 34 five window seat

Not sure of 33-34 but the 35 seat does use angle brackets on the upper, rear L & R top corners of the back rest to the sides of the side pieces.
Forum: Early V8 (1932-53) 10-10-2020, 09:59 AM
Replies: 23
Views: 1,073
Posted By Terry,OH
Re: '37 Ford all locked up

Are you trying to start with the clutch depressed? Or is the transmission in neutral? What is the condition of the battery?
Forum: Early V8 (1932-53) 10-07-2020, 07:08 AM
Replies: 25
Views: 825
Posted By Terry,OH
Re: 1941 convertible backfire to carb, with video

Fuel pressure is too high 2 to 2-1/2. The high pressure will cause engine to flood with fuel, since the carburetor fuel shut off valve was not designed for the pressure you have.

Can you...
Forum: Early V8 (1932-53) 10-06-2020, 08:02 AM
Replies: 52
Views: 1,768
Posted By Terry,OH
Re: Cooling system help needed

Fill coolant to just cover the radiator tubes. Too much and it will come out.
Forum: Early V8 (1932-53) 10-05-2020, 09:44 AM
Replies: 1
Views: 180
Posted By Terry,OH
Re: 37-48 V8 water pump

It is later vintage not early 37-41. It is an original Ford Part. The early ones do not have the Ford Script.
Forum: Early V8 (1932-53) 10-05-2020, 06:30 AM
Replies: 18
Views: 653
Posted By Terry,OH
Re: Different Key ways??

Do you have an adjustable drag link?
Forum: Early V8 (1932-53) 10-03-2020, 01:16 PM
Replies: 15
Views: 664
Posted By Terry,OH
Re: Problem Removing Steering Wheel

Near the bottom of the horn rod there is a recess in the recess is a C-clip. The C-clip holds the light switch spider and spring in place. The C-clip has to be removed usually by compressing the...
Forum: Early V8 (1932-53) 09-29-2020, 06:49 AM
Replies: 17
Views: 633
Posted By Terry,OH
Re: 33-34 Ford radiator mount pieces

They show up from time to time on the auction site. The pair below is 34 as mentioned above the 33 are much different.
Forum: Early V8 (1932-53) 09-28-2020, 06:36 AM
Replies: 15
Views: 644
Posted By Terry,OH
Re: Trunk Lid won't open

I had thought the 40 and 41 took the same deck lid lock cylinder. If so there are several NOS for sale. You could put the screwdriver in the tool box.
Forum: Early V8 (1932-53) 09-27-2020, 06:55 AM
Replies: 15
Views: 644
Posted By Terry,OH
Re: Trunk Lid won't open

The handle lock bolt could still be installed with the lock cylinder removed. The bold may have moved into the lock position preventing the handle from moving. See if you can insert a small...
Forum: Early V8 (1932-53) 09-26-2020, 09:40 AM
Replies: 20
Views: 590
Posted By Terry,OH
Re: 33 5w coupe rear window drain tube.

My 34 5W also had the clamp and remnants of the hose to drain in the same location. I do have the hole in the floor for the tube in the other location.
Forum: Early V8 (1932-53) 09-26-2020, 09:34 AM
Replies: 15
Views: 781
Posted By Terry,OH
Re: 1947 Lincoln Zephyr

The glove lock may not have a code and yet a key may be made for it, there are several factors.
Forum: Early V8 (1932-53) 09-26-2020, 06:57 AM
Replies: 15
Views: 781
Posted By Terry,OH
Re: 1947 Lincoln Zephyr

Not an expert here but I looked over the electrical drawings. The hydraulic system is for the windows, I saw no switch for the trunk or electrical wiring in the trunk for an opener. For Ford from...
Forum: Early V8 (1932-53) 09-25-2020, 05:15 AM
Replies: 3
Views: 265
Posted By Terry,OH
Re: Temperature gauge assembly

Use a line wrench, and a bit of heat helps.
Forum: Early V8 (1932-53) 09-24-2020, 06:04 AM
Replies: 55
Views: 2,425
Posted By Terry,OH
Re: new engine start-up problems

Beside above suggestion from Bursonaw check the ignition wiring to the coil and ignition switch.
Forum: Early V8 (1932-53) 09-22-2020, 06:20 AM
Replies: 15
Views: 753
Posted By Terry,OH
Re: syncro hub position for second

I am confused, the hub is the center part of the syncro and the syncro sleeve is the outer part. On the early syncro with 6 steel balls the hub moves on the splined shaft and the later syncros with...
Forum: Early V8 (1932-53) 09-16-2020, 11:12 AM
Replies: 6
Views: 265
Posted By Terry,OH
Re: Steering gear box leak

No seal there, leave the box empty of lube until after reinstalled.
Forum: Early V8 (1932-53) 09-16-2020, 06:40 AM
Replies: 15
Views: 703
Posted By Terry,OH
Re: 1936 Overheating Problem

35-6 are prone to over heat issues. Ford added modifications to several items such as louvers to the inner fender panels of 36 to improve cooling but they work best when the car is moving. IMO I...
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:50 PM.