Forum: Early V8 (1932-53)
07-05-2022, 07:40 AM
|
Replies: 9
Views: 3,496
|
Forum: Early V8 (1932-53)
07-04-2022, 02:43 PM
|
Replies: 9
Views: 3,496
Repair chip in my fender
I live in Birmingham Alabama. My 1935 Ford has a chip in the drivers side fender,. Does anyone know of someone that can fix my chip around Birmingham?
|
Forum: Early V8 (1932-53)
07-08-2014, 01:44 PM
|
Replies: 1
Views: 765
1935 ran hot
About 10 years ago I bought a 1935 Ford Cabriolet. All it did was run hot. Did a lot of things to it to make it run cooler. Thanks for all your help and suggestions. my car had a 1936 LB engine that...
|
Forum: Early V8 (1932-53)
10-04-2013, 05:52 PM
|
Replies: 5
Views: 1,514
Re: Radiator Hoses
For some reason I thoufgt that I had to have hoses that were offset for the 59ab to 1935 radiator. Is that not correct?
|
Forum: Early V8 (1932-53)
10-04-2013, 02:36 PM
|
Replies: 5
Views: 1,514
Radiator Hoses
I am putting a 59AB engine in my 1935 ford. What hoses do I need for the upper and lower radiator hoses. I think I have read that I can use a Gates #21253 for the upper hoses. I am unsure which ones...
|
Forum: Early V8
09-10-2013, 01:07 PM
|
Replies: 0
Views: 980
1937 -1939 light bracket
I AM PUTTING A 1937 - 1939 STEERING BOX IN MY 1935 fORD. I NEED THE BRACKET THAT THE LIGHT BAIL GO ON (78-3569). IT IS SQUARE AND NOT DIMOND SHAPED. PLEASE SEND PICTURES AND COST TO ME AT MY EMAIL...
|
Forum: Early V8
04-21-2013, 08:21 PM
|
Replies: 0
Views: 829
1936 LB Engine
I am looking for a 1936 LB engine. I would like for it to be in good running condition. You may contact me at [email protected] Please send pictures.
|
Forum: Early V8
04-14-2013, 08:13 PM
|
Replies: 15
Views: 2,867
|
Forum: Early V8 (1932-53)
03-02-2013, 11:27 AM
|
Replies: 1
Views: 1,483
|
Forum: Early V8 (1932-53)
02-17-2013, 03:28 PM
|
Replies: 17
Views: 5,121
Re: Engine swap
Took my heads off this morning. 10 studs came out with the bolts attached to them. Looked at the cylinders and .060 is marked on the ones I looked at. Also one of the valves was a light tan while...
|
Forum: Early V8 (1932-53)
02-14-2013, 01:46 PM
|
Replies: 17
Views: 5,121
Re: Engine swap
Water comes out the overflow. I know this because I put a gallon juge under the over flow and drove it. I also installed an overflow tank. The last time I looked there were no bubles in the water...
|
Forum: Early V8 (1932-53)
02-13-2013, 06:14 PM
|
Replies: 17
Views: 5,121
Re: Engine swap
Skip did my water pumps, distributor and coil. I also have the valve to keep water in my radiator.
|
Forum: Early V8
02-12-2013, 06:15 PM
|
Replies: 1
Views: 1,080
1935 Heads for my flathesd
I am looking for some good 1935 heads for my car. The ones I bought a few years ago are not what I thought. Some of the spark plug holes are crossthreaded. I need some good ones. My engine has...
|
Forum: Early V8 (1932-53)
02-12-2013, 06:01 PM
|
Replies: 17
Views: 5,121
Re: Engine swap
I do not know what the bore is. I will be pulling the heads this weekend and maybe I can tell.
|
Forum: Early V8 (1932-53)
02-11-2013, 07:11 PM
|
Replies: 17
Views: 5,121
Re: Engine swap
I recored my radiator, Skip rebuilt my water pumps, engine rebuilt but studs keep coming out ( THere were 15 or so heli coils put in when the engine was rebuilt). Even when the head bolts were...
|
Forum: Early V8 (1932-53)
02-11-2013, 05:34 PM
|
Replies: 17
Views: 5,121
Engine swap
Well I have finely made the decision to put another engine in my 1935 Ford. I have been dealing with it overheating for the last 8 years. I have done everything to this motor (thanks for everyones...
|
Forum: Early V8
01-11-2013, 03:17 PM
|
Replies: 4
Views: 4,725
|
Forum: Early V8
09-13-2010, 12:33 PM
|
Replies: 4
Views: 1,292
Re: Wanted Good Flathead engine
This engine has been a problem since I bought this car. I have had the radiator recored, the water pumps rebuilt, engine rebuilt, and 3 sets of heads (all milled before I put them on). Every time I...
|
Forum: Early V8
09-12-2010, 04:37 PM
|
Replies: 4
Views: 1,292
Wanted Good Flathead engine
I am looking for a flathead to replace my 1936 LB engine (mine keeps blowing headgaskets every time I drive it). I would like another one just like it but will consider 1937 - 1953. A mercury...
|
Forum: Early V8 (1932-53)
07-15-2010, 02:48 PM
|
Replies: 9
Views: 1,532
With or without hood
:):cool:I have never seen this question posted before. I have a 1935 ford. It has a tendency to run a little hot. My question is: Would a car like mine run cooler with or without a hood? Right...
|
Forum: Early V8 (1932-53)
06-17-2010, 03:18 PM
|
Replies: 13
Views: 2,122
|
Forum: Early V8 (1932-53)
06-09-2010, 03:21 PM
|
Replies: 36
Views: 6,134
|
Forum: Early V8 (1932-53)
06-07-2010, 03:54 PM
|
Replies: 6
Views: 1,779
Re: 1935 Convertibles
I have a 1935 Cabriolet. I do not have a problem putting it up or taking it down by my self.:)
|
Forum: Early V8 (1932-53)
06-04-2010, 02:25 PM
|
Replies: 5
Views: 1,421
|