Forum: Model A (1928-31)
03-09-2017, 01:09 PM
|
Replies: 31
Views: 7,339
|
Forum: Model A (1928-31)
03-08-2017, 03:17 PM
|
Replies: 31
Views: 7,339
|
Forum: Model A (1928-31)
03-08-2017, 02:50 PM
|
Replies: 31
Views: 7,339
|
Forum: Model A (1928-31)
03-08-2017, 02:25 PM
|
Replies: 31
Views: 7,339
Inner bearing rotates on the spindle
In my Ford Model A, the inner bearing rotates on the spindle, it has no clearance, but it is not fixed and can be rotated. Is that correct or should I fix the inner bearing with loctite?
I mean the...
|
Forum: Model A (1928-31)
02-26-2017, 04:43 PM
|
Replies: 18
Views: 7,062
Re: Idle adjustment problem
I had the same problem in my Model A of 1929. When the engine was in idle, had too much air, because the idle screw was very unscrewed. I solved it by screwing the idle screw all the way to the...
|
Forum: Model A (1928-31)
12-13-2015, 05:44 PM
|
Replies: 19
Views: 4,642
Re: Oil transmission level
A few drops of oil on the floor of the garage from u-joint and bellhousing, but very, very few drops. There isn't any oil into the driveshaft tube (front tube of the Mitchell overdrive). I will...
|
Forum: Model A (1928-31)
12-13-2015, 12:59 PM
|
Replies: 19
Views: 4,642
|
Forum: Model A (1928-31)
12-13-2015, 06:34 AM
|
Replies: 19
Views: 4,642
Re: Oil transmission level
I have mounted a Mitchell overdrive, I'll check in the front tube. I have to find where is the gearbox fluid. The oil can go out through the shaft splines. Thank you.
|
Forum: Model A (1928-31)
12-13-2015, 05:12 AM
|
Replies: 19
Views: 4,642
Re: Oil transmission level
It is not dripping fluid out of the transmission. Is a new gearbox with rear shielded bearing (4,000 miles). The rear oil baffle, I think it is not installed, but the bearing is shielded, so I think...
|
Forum: Model A (1928-31)
12-13-2015, 03:37 AM
|
Replies: 19
Views: 4,642
|
Forum: Model A (1928-31)
12-12-2015, 07:17 PM
|
Replies: 19
Views: 4,642
|
Forum: Model A (1928-31)
11-13-2015, 01:55 PM
|
Replies: 43
Views: 7,233
|