Forum: Early V8 (1932-53)
03-27-2021, 02:19 PM
|
|
Replies: 11
Views: 1,947
Re: 33/34 side mirror brackets
I made my own Mirror Assembly that attaches to the shaft of the Cowl Lights that goes thru the body, made it up of Stainless steel 3/8 ths SS Rod and a piece of SS plate, that I shaped and drilled a...
|
|
Forum: Early V8 (1932-53)
03-26-2021, 07:14 PM
|
|
Replies: 14
Views: 1,644
|
|
Forum: Early V8 (1932-53)
03-26-2021, 06:56 PM
|
|
Replies: 14
Views: 1,644
Re: Holley 94 throttle shaft
I would think , Clean both sides of the Plate on a small wire wheel and the Brass shaft and Sweat Solder the shaft in place, both sides, it can always be reheated and moved if desired at any time ,...
|
|
Forum: Early V8 (1932-53)
12-12-2020, 05:14 PM
|
|
Replies: 11
Views: 2,797
|
|
Forum: Early V8 (1932-53)
12-12-2020, 05:10 PM
|
|
Replies: 11
Views: 2,797
Re: Red Liquid for the Hydrostatic Gas Gauge
Hi Deuce Roadster, Thanks so much for the offer, re the Red Liquid for the 34 Gas Gauge, Very much appreciated and Yes , I will take the Tank unit out and check and clean and repair if necessary,...
|
|
Forum: Early V8 (1932-53)
12-11-2020, 09:59 PM
|
|
Replies: 11
Views: 2,797
Red Liquid for the Hydrostatic Gas Gauge
I am looking for the "Red Liquid" or Substitute for the Hydrostatic Gas Gauge on my 1934 Ford Car and Info re Installing the liquid,( if I can find the Red liquid ),I have flushed and cleaned the...
|
|
Forum: Early V8 (1932-53)
11-07-2020, 10:40 PM
|
|
Replies: 11
Views: 3,727
Re: Leaking Holley 94 carbs
I have the same problem, I changed the base and used new gaskets, one thing I did was, I added a small amount of Valve lifter oil to the Gas tank to try and stop a noisy valve lifter or lifters,...
|
|
Forum: Early V8 (1932-53)
10-16-2020, 10:18 PM
|
|
Replies: 16
Views: 2,267
Re: connector sleeve for choke rod
My fix was , went to a Shop for Nuts & Bolts, Got a long sleeve that was a 10/24 thread , threaded the Two Rod ends with a 10/24 Die (Carb end and the Dash Knob end) ,you can adjust the proper Rod...
|
|
Forum: Early V8 (1932-53)
10-02-2020, 05:26 PM
|
|
Replies: 14
Views: 2,192
Re: Ford Blue Hub cap paint?
I Found that Testors Enamel # 1111 Dark Blue was a very good match, Shops that sell Models sell the paint, here in Canada , Toys R Us has the Testors Paint.
|
|
Forum: Early V8 (1932-53)
11-19-2019, 02:13 PM
|
|
Replies: 5
Views: 1,185
Re: 1934 Ford Battery compartment floor cover
Hi Classic... I made a Battery Compartment floor cover, made a pattern from a piece of cardboard,I trimmed it until I had a good fit, then make a nice plywood plate from the pattern , varnished the...
|
|
Forum: Early V8 (1932-53)
11-16-2019, 11:33 PM
|
|
Replies: 5
Views: 1,469
|
|
Forum: Early V8 (1932-53)
11-15-2019, 04:40 PM
|
|
Replies: 5
Views: 1,469
1934 and a 1937 Ford Transmission
Can someone tell me if the Canadian 1937 Ford Transmissions have the Syncro Mesh in the gears like the 1939 transmissions years, thanks guys RS.:)
|
|
Forum: Early V8 (1932-53)
08-23-2019, 03:43 PM
|
|
Replies: 15
Views: 1,769
Trqnsmissions casting numbers
I have three numbers for possibly 39 ford transmissions, can anyone tell me if and what these numbers on the castings are for ? are they 39 or other years ,.Thanks so much
6E1- 6001 ..Top...
|
|
Forum: Early V8 (1932-53)
07-31-2019, 01:59 PM
|
|
Replies: 3
Views: 918
1934 Ford Compression
Could any one tell me what the Compression be in a 34 V/8, and if the motor should be warm when the Comp. test is performed, thanks guys.. RS :)
|
|
Forum: Early V8 (1932-53)
06-22-2019, 09:00 AM
|
|
Replies: 9
Views: 2,253
|
|
Forum: Early V8 (1932-53)
06-21-2019, 02:51 PM
|
|
Replies: 9
Views: 2,253
|
|
Forum: Early V8 (1932-53)
01-05-2019, 11:21 PM
|
|
Replies: 8
Views: 1,732
|
|
Forum: Early V8 (1932-53)
01-05-2019, 04:33 PM
|
|
Replies: 8
Views: 1,732
|
|
Forum: Early V8 (1932-53)
03-13-2018, 11:51 AM
|
|
Replies: 3
Views: 1,095
|
|
Forum: Early V8 (1932-53)
03-11-2018, 05:04 PM
|
|
Replies: 3
Views: 1,095
Serial numbers, Trans & Frame
I have different serial numbers on my 1934- 4 dr Ford , can someone tell me what YEAR the Transmission is with a serial number of... C 18 M 2240.. stamped on the case at the top and a Serial #...
|
|
Forum: Early V8 (1932-53)
03-10-2018, 08:27 PM
|
|
Replies: 6
Views: 1,571
|
|
Forum: Early V8 (1932-53)
03-08-2018, 11:03 PM
|
|
Replies: 6
Views: 1,571
48 f1 Trans for a 34 will it work ?
I have the opportunity to get a 1948 Ford f1 3 speed transmission very reasonable, will this trans. fit up to a 1934 Ford sedan? a stock car, or do I have to take it all apart and change out the...
|
|
Forum: Early V8 (1932-53)
06-11-2017, 06:35 PM
|
|
Replies: 8
Views: 1,018
|
|
Forum: Early V8 (1932-53)
06-09-2017, 07:13 PM
|
|
Replies: 8
Views: 1,018
|
|
Forum: Early V8 (1932-53)
05-19-2017, 07:38 PM
|
|
Replies: 1
Views: 614
Changing 34 Springs and Shackles,
I Just received my new Shackles for the Front & Rear Springs , I am changing out both Springs , are they a Press fit ? or do I have to hone out the holes in the spring Eyes so they fit ? the thru...
|
