Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 23 of 23
Search took 0.00 seconds.
Search: Posts Made By: Flathead41ford
Forum: Late V8 10-26-2019, 11:24 AM
Replies: 0
Views: 232
Posted By Flathead41ford
1968 Ford Country Sedan PART OUT

I am parting out this 68 Ford wagon. 390, c6, rear axle and bucket seats are not available. The only accessory off the 390 that I am keeping is the alternator. The car was totaled around 1990 and sat...
Forum: Early V8 12-30-2017, 02:09 PM
Replies: 0
Views: 248
Posted By Flathead41ford
1946-48 Ford Fiberglass front fenders

I have a pair of fiberglass front fenders that fit a 46-48 Ford. They may fit a 42 but I don't know the differences between 42-46. I really don't know the value and I am selling them for my cousin....
Forum: Late V8 12-29-2017, 11:51 AM
Replies: 0
Views: 384
Posted By Flathead41ford
1972 Ford 351 Cleveland CJ 4V heads 4 bolt mains

I have a 1972 Ford 351CJ for sale. If this is too far off topic feel free to delete. D2 block and D1 heads and intake. This is fully disassembled and needs full rebuild. I everything minus...
Forum: Early V8 09-21-2017, 03:22 PM
Replies: 1
Views: 758
Posted By Flathead41ford
Re: 1932 Ford Panel Delivery/commercial parts wanted

Bump. I no longer need the gauge tunnel.
Forum: Early V8 (1932-53) 06-21-2016, 05:00 PM
Replies: 2
Views: 777
Posted By Flathead41ford
1941 Ford grill questions

I have a 41 Ford Special Tudor sedan. The grills I pulled off of it were stamped steel not the cast like I have normally seen. I have been told the stamped steel grill was factory on the Specials....
Forum: Early V8 (1932-53) 02-24-2016, 09:39 PM
Replies: 58
Views: 7,268
Posted By Flathead41ford
Re: Why the flathead?

I bought my 41 Ford the end of July of 1995. I wasn't able to open the hood on it at the time but it had the V8 emblem. At the time I didn't care too much because I was thinking of an early Olds...
Forum: Early V8 (1932-53) 02-17-2016, 09:38 AM
Replies: 10
Views: 1,282
Posted By Flathead41ford
Re: 1932 deluxe delivery value ?

An almost complete one sold on a facebook page for 2500 about 2 months ago. Pretty rough but most of the panel specific parts were there. I paid 10500 for mine and it came with a fully restored,...
Forum: Early V8 (1932-53) 02-01-2016, 11:22 AM
Replies: 13
Views: 2,062
Posted By Flathead41ford
Re: 1934 Panel truck

My 32 Panel Delivery is painted black on the inside. But, I don't know if it was done from the factory or later in life.
Forum: Early V8 (1932-53) 11-21-2015, 09:40 AM
Replies: 11
Views: 1,972
Posted By Flathead41ford
Re: Results of woodgraining.com wood graining

Did you run the roller left to right or up and down? I was looking at that link you left on my 41 ford interior color. Does the roller seem to follow the contour of the dash well?
Forum: Early V8 (1932-53) 11-20-2015, 11:11 AM
Replies: 2
Views: 895
Posted By Flathead41ford
Forum: Early V8 (1932-53) 11-18-2015, 11:10 AM
Replies: 2
Views: 895
Posted By Flathead41ford
1941 Ford interior paint code

I am getting ready to strip down the dash and garnish on my 41 Ford. It was originally a tanish color with woodgrain on the dash and garnish. I was wondering if anyone has the base tanish paint code....
Forum: Early V8 08-08-2015, 10:42 AM
Replies: 1
Views: 758
Posted By Flathead41ford
1932 Ford Panel Delivery/commercial parts wanted

I am looking for some Panel Delivery specific parts and commercial truck parts.

Seats and brackets, Panel Delivery
Commercial gauge tunnel with gauges
Rear inner fenders. I think that is what...
Forum: Early V8 (1932-53) 08-08-2015, 10:24 AM
Replies: 14
Views: 2,390
Posted By Flathead41ford
Re: 1932 Panel Delivery questions

I would like to bump this up. I am still hunting for parts. A fellow Fordbarn member was able to sell me some rear inner body braces which gets me a little closer. I am hoping a restorer can chime in...
Forum: Early V8 (1932-53) 06-17-2015, 10:36 AM
Replies: 7
Views: 2,019
Posted By Flathead41ford
Re: 1941 Car clutch pedal linkage question.

http://i307.photobucket.com/albums/nn294/ford371/1941%20Ford/PA120027.jpg

http://i307.photobucket.com/albums/nn294/ford371/1941%20Ford/stuff021.jpg
...
Forum: Early V8 (1932-53) 04-30-2015, 11:53 AM
Replies: 14
Views: 2,503
Posted By Flathead41ford
Re: Hot Air Heater 1940

My 41 had that set up. The fan/motor were kind of centered above the right manifold. There was a heat exchanger on the Y pipe that was plumbed to one side of the fan, then another tube going to the...
Forum: Early V8 (1932-53) 04-22-2015, 11:55 AM
Replies: 1
Views: 650
Posted By Flathead41ford
Re: 1932 ford panel truck seats

https://www.fordbarn.com/forum/showthread.php?t=161692

I am on the same hunt as you. There are a few pics in the thread I started a while back that may help.
Forum: Early V8 (1932-53) 03-06-2015, 01:10 PM
Replies: 21
Views: 3,094
Posted By Flathead41ford
Forum: Early V8 (1932-53) 02-22-2015, 09:25 AM
Replies: 17
Views: 2,716
Posted By Flathead41ford
Re: 1941 bumper?

I don't know if this is of any help. I have a 41 ford Tudor Special. My bumpers are smooth with no bumperetts or ends. My rear is the same with "ford" stamped in the middle. Ends are rounded and...
Forum: Early V8 (1932-53) 02-19-2015, 09:50 AM
Replies: 14
Views: 2,390
Posted By Flathead41ford
Re: 1932 Panel Delivery questions

I compared what I have to what you showed. It looks like mine are not panel truck. Passenger car I would think. Something else to hunt for. Thanks again for the help. Once I get farther into my 41...
Forum: Early V8 (1932-53) 02-18-2015, 10:50 AM
Replies: 14
Views: 2,390
Posted By Flathead41ford
Re: 1932 Panel Delivery questions

That is just what the previous owner did. He cleaned, painted and has had this frame on display in his small museum up the road from my shop. That is polished and I am pretty sure there are a million...
Forum: Early V8 (1932-53) 02-18-2015, 10:35 AM
Replies: 14
Views: 2,390
Posted By Flathead41ford
Re: 1932 Panel Delivery questions

Thank you for the help DavidG. This body also came with a set of rear fenders. They can be seen next to the passenger side door in one of the first sets of pics. Do you know if they are the same as...
Forum: Early V8 (1932-53) 02-17-2015, 04:19 PM
Replies: 14
Views: 2,390
Posted By Flathead41ford
Re: 1932 Panel Delivery questions

DavidG. I am under the same assumption that it is a standard because of the lack of cowl lights. The headlight bar also does not have a hole for the v8 emblem so my guess was that the car was a...
Forum: Early V8 (1932-53) 02-17-2015, 01:34 PM
Replies: 14
Views: 2,390
Posted By Flathead41ford
1932 Panel Delivery questions

Hello all. I normally hang around the HAMB and this is my first post here on the Ford Barn. I had picked up a 32 Panel Delivery a few months back. It came with a fully restored frame with a 40 Ford...
Showing results 1 to 23 of 23

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 09:26 AM.