Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 309
Search took 0.01 seconds.
Search: Posts Made By: jayvee34
Forum: Model A (1928-31) 09-16-2021, 05:46 PM
Replies: 4
Views: 345
Posted By jayvee34
Re: Pertronix With Original Pop Out Switch….

If you wire from the battery side of the terminal box to the power side of the
ignition switch, wire from the other side of the ignition switch to the + side
of the coil, wire from the - side of...
Forum: Model A (1928-31) 09-16-2021, 05:22 PM
Replies: 31
Views: 918
Posted By jayvee34
Re: Overheating 1930 Model A

Water boils @ 212 degrees, 180 is considered normal, when it starts getting
200 and rising I would get concerned. If it is not steaming or blowing hot water out of the overflow or the cap and temp...
Forum: Model A (1928-31) 09-15-2021, 09:10 PM
Replies: 31
Views: 918
Posted By jayvee34
Smile Re: Overheating 1930 Model A

Good starting advise. Also check out your water pump.
Semper Fi Brother:)
Forum: Late V8 (1954+) 09-15-2021, 03:52 PM
Replies: 21
Views: 790
Posted By jayvee34
Re: Odometer reset

In Florida, vehicle's 25 years old and older are mileage exempt. It is illegal to reset
the mileage on later vehicles.
Also on restored cars, if the odometer numbers are not lined up across, they...
Forum: Early V8 (1932-53) 09-15-2021, 03:06 PM
Replies: 21
Views: 527
Posted By jayvee34
Re: Speed bleeders for 1949 F1

Check fluid in master cylinder, could be drawing air if fluid is to low. Also check all your
connections for loose screws or flare nuts, and faulty flex hose.
Forum: Model A (1928-31) 09-15-2021, 10:53 AM
Replies: 22
Views: 760
Posted By jayvee34
Smile Re: Voltage/Amperage question?

Thanks, My battery is fully charged, My amp meter reads about 2 amps.,
and my voltage is 7.62 volts.

Thanks again to all who answered. Great Forum of knowledgeable folks.:)
Forum: Model A (1928-31) 09-15-2021, 10:45 AM
Replies: 22
Views: 760
Posted By jayvee34
Wink Re: Voltage/Amperage question?

Thanks, I thought so too! Just wanted to say what I did so those who answered
my question would know.;)
Forum: Early V8 (1932-53) 09-14-2021, 07:13 PM
Replies: 28
Views: 938
Posted By jayvee34
Re: Ford Motor Co during the war.

Thanks for sharing, and thanks to the GREATEST GENERATION.
Forum: Model A (1928-31) 09-14-2021, 03:49 PM
Replies: 22
Views: 760
Posted By jayvee34
Re: Voltage/Amperage question?

Flashed, meaning excited, sorry about the wrong terminoloy.

Yep, Number one terminal to the case, got the info from Gary @
QuickStart. "Jumper wire connected to the case (grounded), just touch...
Forum: Model A (1928-31) 09-14-2021, 01:06 PM
Replies: 22
Views: 760
Posted By jayvee34
Re: Voltage/Amperage question?

Thanks again everyone, got it going (fixed). Flashed the alternator, got 7.72 Volts,
loaded got 7.55 volts, 30 amps, then backs off to 15amps.
Forum: Model A (1928-31) 09-14-2021, 10:47 AM
Replies: 22
Views: 760
Posted By jayvee34
Re: Voltage/Amperage question?

Thanks to all. A big help!
Forum: Model-A 09-14-2021, 07:52 AM
Replies: 1
Views: 437
Posted By jayvee34
Angry Re: 1930 ford model a murray body town sedan

Tried to delete or cancel this ad to no avail!!:mad: Would like to know how.
Forum: Model A (1928-31) 09-14-2021, 07:34 AM
Replies: 22
Views: 760
Posted By jayvee34
Smile Re: Voltage/Amperage question?

Thanks very much, your answer is most appreciated.:)
John
Forum: Model A (1928-31) 09-13-2021, 05:07 PM
Replies: 22
Views: 760
Posted By jayvee34
Smile Voltage/Amperage question?

On a 6 volt negative ground alternator that test 6.57 Volts with headlights on
low beam and the Amp meter reads 5 amps +. With the headlights on high beam the voltage is still testing 6.57 volts,...
Forum: Early V8 (1932-53) 09-09-2021, 08:40 AM
Replies: 17
Views: 1,234
Posted By jayvee34
Re: This is a joke; don't read it if you've no humour

Good one - Here's another Highway Patrol joke.

A old guy always wanted a Corvette, so he bought one. Out on the highway he exhilarated to 70 MPH, and he felt good at that speed and thought he...
Forum: Model A (1928-31) 09-07-2021, 09:03 PM
Replies: 19
Views: 565
Posted By jayvee34
Re: Small Introduction

Welcome to the Barn!! "Ole' Clyde" is a beauty.
Forum: Model A (1928-31) 09-06-2021, 03:56 PM
Replies: 34
Views: 1,273
Posted By jayvee34
Re: Four Post Lift Recommendations….

Bought my Back Yard Buddy 4 post lift 25 plus years ago. I use it most every day
and have 0 problems with it. Made in the USA, claims to be the safest lift made.
IMO it is quality made. I installed...
Forum: Early V8 (1932-53) 08-31-2021, 07:06 PM
Replies: 11
Views: 413
Posted By jayvee34
Smile Re: 32 ford f-1 type cpp power steering

No play, no leaks, steers great.:)
Forum: Early V8 (1932-53) 08-31-2021, 06:16 AM
Replies: 11
Views: 413
Posted By jayvee34
Re: 32 ford f-1 type cpp power steering

I have one of Mel's (Randy Gross) F-100 steering box conversion's in my
30 Model A Town Car. Work's great, easy steering, great quality workmanship.
Forum: Model A (1928-31) 08-30-2021, 08:33 PM
Replies: 16
Views: 733
Posted By jayvee34
Re: Is Bars Leak still a good temp fix

I have used it successfully in the past. I believed I have seen it on the shelves of
Wal mart and Advance Auto Parts.
Forum: Early V8 (1932-53) 08-29-2021, 12:57 PM
Replies: 11
Views: 413
Posted By jayvee34
Smile Re: 32 ford f-1 type cpp power steering

I used one of there kits on my 50 F-1, It was engineered for the 53 to 56 F-1,
but I used it by relocating the box by opening up the hole in the frame and
filling in where needed. I t worked...
Forum: Model A (1928-31) 08-29-2021, 12:39 PM
Replies: 6
Views: 459
Posted By jayvee34
Smile Re: Where did my compression go

The thread is titled "It ran well when I parked it" is toward the bottom of this page.
Forum: Model A (1928-31) 08-27-2021, 06:22 AM
Replies: 20
Views: 1,221
Posted By jayvee34
Smile Re: Vaccum Gauge

Like he said, I've got some time on hand. Do it, gives you something to do.:)
Forum: Model A (1928-31) 08-25-2021, 12:25 PM
Replies: 22
Views: 736
Posted By jayvee34
Re: Low compression, all holes

IMHO, Put some MMO in each cylinder and in in the gas, also, maybe some SeaFoam, drive it awhile, see if the sticky valves loosen up. Worth a try before tearing into the engine.
Forum: Early V8 (1932-53) 08-23-2021, 07:49 PM
Replies: 28
Views: 1,401
Posted By jayvee34
Wink Re: Bleeding Brake lines on a 1939 Ford Deluxe

That is called ingenuity!!! Great idea.;)
Showing results 1 to 25 of 309

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 09:10 AM.