Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: Kube
Forum: Early V8 (1932-53) 06-14-2021, 01:05 PM
Replies: 19
Views: 953
Posted By Kube
Re: 1940 Ford Convertible Wire Loom Routing

Just for clarity... ALL convertibles had these brackets and were bolted to the frame in this area forward of the dash.
Why some brackets had a hole in the left side and others did not requires...
Forum: Early V8 (1932-53) 06-13-2021, 01:17 PM
Replies: 19
Views: 953
Posted By Kube
Re: 1940 Ford Convertible Wire Loom Routing

Brackets are there of course - they, as you know, mount the body to the frame. NO hole in either side.
Forum: Early V8 (1932-53) 06-12-2021, 05:48 PM
Replies: 19
Views: 953
Posted By Kube
Re: 1940 Ford Convertible Wire Loom Routing

I just went out and looked at the '40 convertible I am currently restoring. I had to look as the CRS is setting in. Anyway, NO hole in this one.
Forum: Early V8 (1932-53) 06-10-2021, 03:53 PM
Replies: 19
Views: 953
Posted By Kube
Re: 1940 Ford Convertible Wire Loom Routing

Well, yes, not exactly like other models but it works.

I tend to think Fords routing in that area was not of the best design - too much going on in a limited area.
Still, it works.

The few...
Forum: Early V8 (1932-53) 06-10-2021, 11:46 AM
Replies: 19
Views: 953
Posted By Kube
Re: 1940 Ford Convertible Wire Loom Routing

I route the wires just like any of the coupes I've restored. There is, as you surely know, a small wire clamp that fastens to the frame and keeps the loom in place.
I have restored (5) '40...
Forum: Early V8 (1932-53) 06-10-2021, 08:43 AM
Replies: 19
Views: 953
Posted By Kube
Re: 1940 Ford Convertible Wire Loom Routing

I am guessing what you are describing as "L" shaped bracket" is the dash panel mount to the frame. Yes?
Showing results 1 to 6 of 6

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:10 AM.