How many Tudor Model A's can you get on 18' trailer
 

I bought 2 1930 Tudor Sedans and was wondering if you take front and rear bumpers off can you get both cars on a 18' trailer with 3 foot ramps extended out the rear of the trailer. Has anyone tryed this before?

Re: How many Tudor Model A's can you get on 18' trailer
 

i put mine on a 18 footer kinda in the center, itll prob be pretty tight, how far is the pick up site

Re: How many Tudor Model A's can you get on 18' trailer
 

When (IF) you get them on the trailer, be sure and take a picture to show us how you did it!

Re: How many Tudor Model A's can you get on 18' trailer
 

If I remember correctly, the wheelbase is 103 inches which is 8.58 feet times 2 equals 17.16 feet plus 19 inches times 2 for front and back wheels plus tires (12 in. est.) times 2 equals 22.32 feet. Plus you have fenders that extend beyond that. Would seem like it would be kind of tight even with bumpers off.

Re: How many Tudor Model A's can you get on 18' trailer
 

It will be 800 loaded miles

Re: How many Tudor Model A's can you get on 18' trailer
 

Based on my experience, it takes a 26' trailer to get two complete Model A's inside of an enclosed one.

On an open trailer, you can get them on a 24'. Below is my trailer that has a 25' deck (including the dovetail on the back). As you can see, the entire vehicles are on the trailer with room in-between. This is because the front car's overhang is backed over the tongue.

http://a2.sphotos.ak.fbcdn.net/hphot...345_8091_n.jpg

.

Re: How many Tudor Model A's can you get on 18' trailer
 

More than two if you crush them first...:p

Re: How many Tudor Model A's can you get on 18' trailer
 

16 foot trailer
http://i416.photobucket.com/albums/p...t/4bd00b8f.jpg

Re: How many Tudor Model A's can you get on 18' trailer
 

Just to drive the point home, even without bumper brackets and fenders you're dealing with approx 11' 4" for each. Do something like Brent's first car backed on (depending on deck layout at front), and the rear car right up against the end of the deck (not much safety margin) and you're still about 3' short of enough trailer.

Re: How many Tudor Model A's can you get on 18' trailer
 

my original smart-ass answer is "1.5" but I like the other answers above better......:cool:

Re: How many Tudor Model A's can you get on 18' trailer
 

stack-em.....

Re: How many Tudor Model A's can you get on 18' trailer
 

Put one "A" on the trailer and have the other one tow it.

Re: How many Tudor Model A's can you get on 18' trailer
 

If you have the b-lls- get a 20' trailer and hang the first A front onto the tongue and you might just make it with the rear whls of the 2nd a just on the back of the trailer....

You have to be real careful on cornering....

I piggybacked a 31 chevy chassis under the front of a 30 A chassis on a 16' trailer. It worked, but was tight.... no bodies.

Re: How many Tudor Model A's can you get on 18' trailer
 

Since I am assuming you already have a 18' trailer, ...and I'm assuming you don't want to buy another trailer but you do want to transport these with some resemblance of safety.;)

I just drew this up during lunch to show how I think I would add another 4-5 foot onto the tongue of your current trailer by building an adapter. All you would be out $$-wise is a stick of 6" channel iron, a trailer hitch ball, and another trailer hitch assembly. Either weld or clamp the tongue adapter onto the existing tongue at the rear. The trailer hitch ball on the adapter control the forward/rearward movement of the trailer. This drawing should give some food for thought, and hopefully you can engineer from there....


.

Bad idea.....
 

Bad idea ..... :rolleyes:

Altering the trailer frame voids the manufacturer rating.
That means no insurance coverage.
That means vehicle enforcement will have a field day
when you get pulled over.
If you don't have the proper equipment to safely
transport two vehicles - rent or buy it.


Jim

Re: Bad idea.....
 

With all due respect Jim, are you sure you are correct regarding legality and insurance? :eek: I find that hard to believe but maybe you know something different??

As far as altering the frame, my proposal does not alter the frame because it can be totally safe just by bolting it on if that is what the trailer owner wants to do.

And, while we're on this subject please explain to me what happens when the manufacturer of the trailer (such as the one below) is me? Are you implying if I alter my trailer the "warranty" is voided and my insurance company won't insure me?? :D



http://a2.sphotos.ak.fbcdn.net/hphot...345_8091_n.jpg

Re: How many Tudor Model A's can you get on 18' trailer
 

I drove a semi for years and agree with Brent. If the mods are done safely and legaly they have no problem. Look at all the homemade hack jobs some people use, they are dangerous and in ky your auto ins covers whatever you are hooked too. found this out when I bought a 34 ft pull along camper......I like the spread axle set up on your trailer Brent ..very stable.

Been pulled over lately ????
 

If you want to build a home made trailer and license it in your state,
good for you .....

You - as the builder - take responsibility ....

Sketching a frame alteration to increase payload capacity
to a manufactured trailer and passing it off as legitimate
for someone else - thats' completely different ... :rolleyes:

You are not a trailer manufacturer.

When a manufactured trailer with a VIN number leaves
a factory - it has a GVWR based on the design of the
trailer and the axle size and tire size.

Alter that - have an accident - your insurance will not cover
you .....

Alter that - get stopped by vehicle enforcement - get inspected
and get ticketed ....



http://a2.sphotos.ak.fbcdn.net/hphot...345_8091_n.jpg

Depends on who does the modifications ...

Been pulled over lately ... ?

In New York and Pennsylvania - vehicle enforcement
will ticket you for any overhang off the back of your trailer
deck ..... ;)


The bottom line - if you don't own the equipment to do the job
then go out and rent it, borrow it, buy it.

Don't do a home alteration on a manufactured trailer.


Jim

Re: How many Tudor Model A's can you get on 18' trailer
 

I would think to get two full fendered cars on the initial one is going to have the front axle lashed down in the tongue area. Somewhere near the ball. That is not a good idea. Probably have to remove the front wheels. That will give you maybe three more feet for the second car. I tow alot and if it was me going on an 800 mile loaded trip I would try to find the right trailer before embarking on the journey you are describing. If you are going to do this toward the end of the month when the local police departments are enforcing their traffic violation quotas on their uniformed personnell, expect to get pulled over for safety violation inspections at least twice more like three times in 800 miles. Hell forget about quotas...if I saw you in my neighborhood doing this I would probably alert the police with my cell phone before you killed somebody.

Don't put yourself at risk when towing and certainly don't put the people around you at risk by doing something that the trailer wasn't designed for. If you have an incident with this, the dream car you want to build will never happen because of all the law suits you will have to defend the rest of your life.

Re: How many Tudor Model A's can you get on 18' trailer
 

Thanks for everyones thoughts this a great place with good people to share many different ideas. 2 model A cars turned out to be a total of 4 model a cars and 2 AA trucks that We bought from one person so we bought a 42 foot car hauler to pull with my dads
F350 dually and with my 18' trailer and two trips the vehicle we be at there new home.

Thanks alot

Mike