![]() |
Powder Mill Trekked up to Hazardville, CT this am for the monthly swap meet. Nice to run into Barry B. and Ken, CT and BS for a while. Thanks guys.
Paul in CT :):) |
Re: Powder Mill I here alot about this swap meet but I don't see it advertised.When and where is it held each month? Thanks, Dennis/CT
|
Re: Powder Mill You will only see it advertized on here. 1st sunday of the mth. Its small,very small about a dozen vendors,mostly model A and V8 stuff and tools [not jap stuff] usa made scockets ,wrenches screwdrivers etc etc, [1 vendor] nice little swap in the winter mths. Good seeing you again 31 flamingo take care fellas and see you nxt mth. ken ct. Oh you tooo Barry lol.
|
Re: Powder Mill Add me to the list of people that haven't been to it yet, maybe next month if someone posts a reminder.
|
Re: Powder Mill Put it on your calendar, it will be Mar.4 and I think that will be it for this year. Saw 2 nice 28/29 ccpickups drive in when we were leaving. Get there early, there were people there today before 7AM. Nice to chat with you too Paul (Flamingo) and Ken ct.
PS bought a nice clutch disc and pressure plate with only 1200 miles from Lenny. Good guy to deal with, usually rebuilds carbs and distributors. |
Re: Powder Mill How about an address or directions?
|
Re: Powder Mill " Saw 2 nice 28/29 ccpickups drive in when we were leaving. "
The NEXT Generation!;) |
Re: Powder Mill Quote:
|
Re: Powder Mill Quote:
|
Re: Powder Mill They were at Tractor Supply too!
|
Re: Powder Mill Dennis/ CT: It's actually in hazardville, take the way Ken CT said but after you get onto 190 it's about 5 miles, at traffic light there's a Whole Donut shop on the left just before you're going to turn right. Bring some Jimmie's dogs and clams with you. haha
Paul in CT |
All times are GMT -5. The time now is 02:57 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.