Front License Plate Holders
 

I plan to use my almost fully restored 1930 Model A CCPU as a "daily driver". In the state of NE, this requires a license plate mounted on the front and rear of the vehicle.

I do not like the looks of the usual front license plate mounting on the headlight bar. See picture. I would like to see comments as to what others have done regarding hardware for mounting of a front license plate in other places, such as on the front bumper or other places.

Thanks.

Re: Front License Plate Holders
 

There is an aftermarket bracket to attach your license plate to your front bumper clamp.

Re: Front License Plate Holders
 

Or bolt one of these thru the bumper bolt left or right side.

Re: Front License Plate Holders
 

There is a guy selling these for $25 in Model A Times. Or take a rear holder and mount upside down.

http://i371.photobucket.com/albums/o...nseBracket.jpg

https://www.fordbarn.com/forum/showth...=license+plate

Re: Front License Plate Holders
 

I made a front license plate holder that mounts on the center of the front bumper. I used a Cruiser Accessories license mounting plate, part number 79150 from Advance Auto Parts. It is also available from Amazon. I mounted it with perforated 1/2 inch channel left over from a garage door opener mount, and two center bumper clamps. I painted the angle, and covered the holes with electrical tape. Pictures are attached.

Re: Front License Plate Holders
 

Thanks for the suggestions.

Re: Front License Plate Holders
 

Glade to see these cars used as a daily drivers! Cant wait till my tudor is done in the spring! Its gonna be my summertime daily driver :)