Grille shell emblem ID
 

I have a nice reproduction grille shell emblem that doesn’t fit my 34 pickup. It measures about 1 3/4” wide and 7/8” tall. What’s it go on? Thanks

Re: Grille shell emblem ID
 

Re: Grille shell emblem ID
 

Is there a B or 40- number on the back?

Re: Grille shell emblem ID
 

Nope

Re: Grille shell emblem ID
 

1932 badge I have here (repro) is 2.200 x 1.100 give or take a frog hair.

Re: Grille shell emblem ID
 

Does it have a clip or bolt on the back?

Re: Grille shell emblem ID
 

34 PU uses the same one as 1932.In fact 32-35 Commercial is the same.What is on the back? A clip or a threaded stud? If its a clip it is 35,36 and 38 STD pass car. If its a stud it appears to be 1934 from the shape of the face.33 pass car also has a stud but the curve of it is different.The orig emblems Never had a part number,only the maker like Fox or Ross Ad Seal etc.
Here is an original '32-35 commercial.3rd and 4th pics are of an original '34 pass car.The last 2 pics are of an orig '33 pass car.


If you buy a repro I suggest the Vintique.The reason is Drakes is made to fit HIS bezels SO it will not fit tight in an original bezel.There are slight gaps all the way around.

Re: Grille shell emblem ID
 

Threaded stud on the back, no numbers or letters on the back either.

Re: Grille shell emblem ID
 

Then its a 1934 pass car emblem

Re: Grille shell emblem ID
 

Thanks. Just posted pic of back side

Re: Grille shell emblem ID
 

Take the nut of and compare the base of the stud and see if matches to a pic of one I sent. The orig 33 has a square base ,34's like 32's are round.Many of the early repros just had a screw soldered on. No originals had part numbers on back,just makers or vendor mark. The correct emblem for your application should be approx 2 1/8 " wide across the front.The 34's approx 1 7/8" or a bit less. Looking at the curve of yours it appears '34 which was more pronounced .35'56 had a curve like the '34 but had a clip on the back.

Re: Grille shell emblem ID
 

found that a tiny O ring makes the best 'lock' washer. Does not stress the solder of the bolt. Newc

Re: Grille shell emblem ID
 

Just trying to ID this emblem. I will remove the nut for comparison to your pics.

FYI, I do have an emblem and ornament for my 34 pickup as well as extra ornament.

Thanks