![]() |
41 ford coupe door weather stripping I have been going through articles on door seals, but not really 41 coupe. I have the seals and my understanding is that the top seal goes on the body and the hinge seal goes on the door. I have the lower seal in the channel across the bottom of the door on the floor. I guess the little seal goes on the bottom back side of the door. Not sure about back side of door seal, does it go from top of door or from top corner of body? My one question on this car is I can't hardly get at the front of the door near the hinges - do I have to loosen the door hinge bolts to get at the front edge? Any comments on the 41 doors would be appreciated. Getting closer to getting this car done.
|
Re: 41 ford coupe door weather stripping I’ll took pictures of my ‘41 door, I’ll post them tonight.
|
Re: 41 ford coupe door weather stripping thanks
|
Re: 41 ford coupe door weather stripping 7 Attachment(s)
Lighting is not the greatest but this is the passenger door.
|
Re: 41 ford coupe door weather stripping Thanks , looks like double seal on back of door - seems to have a piece going down body and on back of door? Is the piece on the front of the door below the top hinge on the door? thanks again.These were the clearest pictures that I saw.
|
Re: 41 ford coupe door weather stripping Quote:
https://www.fordbarn.com/forum/attac...3&d=1753614772 https://www.fordbarn.com/forum/attac...4&d=1753614772 https://www.fordbarn.com/forum/attac...5&d=1753614772 https://www.fordbarn.com/forum/attac...6&d=1753614772 |
Re: 41 ford coupe door weather stripping 2 Attachment(s)
Additional pictures. This rubber is stuck to the door halfway up from bottom. It goes around the bottom of door up the side around the top and ends just below the chrome trim on fender/door.
|
Re: 41 ford coupe door weather stripping Quote:
https://www.fordbarn.com/forum/attac...6&d=1753647752 |
Re: 41 ford coupe door weather stripping thanks , best pictures I have seen -
|
All times are GMT -5. The time now is 03:20 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.