Looking for a rearend rebuilder in Los Angeles area
 

I have a rear-end with a Halibrand center section and a Mitchell Overdrive in a basket. I'm looking for some to correctly assemble and set it up. :confused:

Re: Looking for a rearend rebuilder in Los Angeles area
 

That stuff is junk - call me I'll dispose of it properly......
Is the Mitchell apart also? If so I'd get Mitchell to put it back together.
If the rear was all together at one point it's simple assembly. If you don't have all the pieces some others can be modified to fit.
Here is a Halibrand manual if you don't have one. https://www.ebay.com/itm/251330935830
This is a good - but old - writeup on the HAMB - https://www.jalopyjournal.com/forum/...hanges.148241/
You might want to post there too as someone may know a guy in your area.

Re: Looking for a rearend rebuilder in Los Angeles area
 

Thanks for the link on the manual.
The Mitchell IS NIB. The rest of it has been gathered from swap meets ETC. All new bearings and races.
Simply looking for the person with the knowledge to put it together correctly.

Re: Looking for a rearend rebuilder in Los Angeles area
 

Al Zannino in Hemet does a great job on transmission and rear ends, including QC's. [email protected].

Re: Looking for a rearend rebuilder in Los Angeles area
 

Thanks Jim.

Re: Looking for da rearend rebuilder in Los Angeles area
 

Tom Endy:)

Re: Looking for a rearend rebuilder in Los Angeles area
 

Chris,
I sent you a fordbarn email.
Neil

Re: Looking for a rearend rebuilder in Los Angeles area
 

Didn't get it.

Re: Looking for a rearend rebuilder in Los Angeles area
 

2nd Jim on Al Zannino, great to deal with.

Re: Looking for a rearend rebuilder in Los Angeles area
 

Tom Endy. 714 - 897 - 5861 Donates his fees to the votec school !