31’ Victoria body to frame mount
 

My choke rod bares hard against the bottom of its firewall hole suggesting that the body is mounted too high or tipped back. A previous owner used 1/4” rubber spacers between the frame and body mounts. I’ve removed most of them but don’t seem to be getting the choke rod position to free up. I believe I’ve read that Victoria’s did not have wood block mounts. They only used the canvas strip between the body and frame. Can anyone lend suggestions as to what was used between the body and frame and how to align the two? My goal is to get my choke rod to run without interference with the hole in the firewall. It seems that I should shim up the rear of the body up to change the angle so that the firewall goes down as to relieve pressure on the choke rod.
For reference, the intake and carburetor are mounted correctly and my doors line up correctly (an indication that the body isn’t twisted).
Thanks in advance for your collective insight. Much appreciated!

Re: 31’ Victoria body to frame mount
 

the original rubber pads were about 3/16". your engine might setting to high. does your front pulley line up with your crank hole. and what kind of rear engine mounts do you have.

Re: 31’ Victoria body to frame mount
 

My front pulley does line up. My rear engine mount is shown in the attached image.

Hopefully I attached it correctly.

Re: 31’ Victoria body to frame mount
 

Sagged frame?

Re: 31’ Victoria body to frame mount
 

How would I check that?

Re: 31’ Victoria body to frame mount
 

With the body on checking frame is difficult.
If bare frame a string pulled tight will reveal. Like a brick mason lays brick!

Re: 31’ Victoria body to frame mount
 

you have float-a motor mounts in the rear. if the rubbers are bad the engine will set to low in the rear.
Note I for one do not like float-A motor mounts for a number of reasons,

Re: 31’ Victoria body to frame mount
 

Okay. What would you suggest I buy and replace them with? Is there a reference dimension I can check to verify the back of the engine is too low? Say, a feature on the motor relative to the top or bottom of the frame?

Re: 31’ Victoria body to frame mount
 

You can buy the replacement rubber from several of the suppliers.
https://www.snydersantiqueauto.com/p...8486&cat=41704

Re: 31’ Victoria body to frame mount
 

Very evident the float a motor mounts have sagged. Ben there and done that. Also will cause bottom radiator hose to break loose from the tank.

Re: 31’ Victoria body to frame mount
 

The FAM part mounted to the engine has an "UP" side, should be able to see it marked in the square pad, check above and below, to make sure "this side is up".

Re: 31’ Victoria body to frame mount
 

These sketches may help you.

Re: 31’ Victoria body to frame mount
 

This is great!!!! Thank you!

Re: 31’ Victoria body to frame mount
 

Thank you. New bushings are on order!

Re: 31’ Victoria body to frame mount
 

I will verify this when I put the new bushings in. Thank you!