The Ford Barn

The Ford Barn (https://www.fordbarn.com/forum/index.php)
-   Early V8 (1932-53) (https://www.fordbarn.com/forum/forumdisplay.php?f=4)
-   -   Serial number (https://www.fordbarn.com/forum/showthread.php?t=346851)

Chris Haynes 02-25-2025 08:58 PM

Serial number
 

Is there a serial number anywhere on a 1932 frame?

DavidG 02-25-2025 09:11 PM

Re: Serial number
 

If originally a passenger car frame the engine number should be stamped on top of the left frame rail in three places. First is the full number just forward of the foot of the firewall. Second and third exclude the prefix and are hidden from view under the body at the B pillar and rear axle kickup.


If a commercial vehicle frame, only the full number near the left firewall foot is stamped on the frame.

Charlie Stephens 02-25-2025 09:21 PM

Re: Serial number
 

You might find a little more serial number information here: http://www.vanpeltsales.com/FH_web/f...ialnumbers.htm

Charlie Stephens

40larry 02-26-2025 11:02 AM

Re: Serial number
 

You call it the engine number but is it found on the engine?

tubman 02-26-2025 11:16 AM

Re: Serial number
 

Quote:

Originally Posted by 40larry (Post 2372306)
You call it the engine number but is it found on the engine?

It is found on a pad on the transmission. Therefore it is not an engine number. Many, many transmission and engine changes may have taken place in the last 93 years, so there are a lot of mismatches out there.

Newc 02-26-2025 01:01 PM

Re: Serial number
 

Warning; all vin numbers are now in a Federal data base. duplicates have shown up [36 Ford]The trans mission vin numbers were originally matching the frame. Newc

Chris Haynes 02-26-2025 09:28 PM

Re: Serial number
 

Quote:

Originally Posted by 40larry (Post 2372306)
You call it the engine number but is it found on the engine?

Actually 1932 models had no number on the engine. It was on the transmission.

Chris Haynes 02-26-2025 09:29 PM

Re: Serial number
 

Can the frame number be seen with the fender removed?

alchemy 02-27-2025 07:58 AM

Re: Serial number
 

It can be seen with the fender on even.

51shoeboxer 02-28-2025 12:42 PM

Re: Serial number
 

VIN number, as in vehicle identification number number?

TJ 02-28-2025 12:59 PM

Re: Serial number
 

Quote:

Originally Posted by 51shoeboxer (Post 2372805)
VIN number, as in vehicle identification number number?

Yes and it's the number used by the DMV

Charlie Stephens 02-28-2025 01:16 PM

Re: Serial number
 

Quote:

Originally Posted by Chris Haynes (Post 2372441)
Actually 1932 models had no number on the engine. It was on the transmission.

Minor addition, the serial number for the 4 cylinder was on the flywheel housing and not the transmission. Of course it was also on the frame like the V8.

Charlie Stepehns

TomC750 02-28-2025 08:10 PM

Re: Serial number
 

Quote:

Originally Posted by TJ (Post 2372809)
Yes and it's the number used by the DMV

Quoted wrong party

TomC750 02-28-2025 08:11 PM

Re: Serial number
 

Quote:

Originally Posted by TJ (Post 2372809)
Yes and it's the number used by the DMV

Point missed...

Chris Haynes 03-29-2025 09:28 PM

Re: Serial number
 

Can someone show a picture of where this number is located? TIA

corvette8n 03-30-2025 06:32 AM

Re: Serial number
 

1 Attachment(s)
From Vanpelts website drawing shows 38-39 but 32 should be the same. I used this to find the number on my ‘41. Mine was light but I cleaned the area and rubbed white chalk over the number.

alchemy 03-30-2025 09:09 AM

Re: Serial number
 

The picture is kinda wrong for a 32. The front number is right at the firewall foot, the second number is under the B pillar area, and the third number is on the upswing of the rear frame, in front of axle centerline.

petehoovie 03-30-2025 01:00 PM

Re: Serial number
 

Quote:

Originally Posted by corvette8n (Post 2379955)
From Vanpelts website drawing shows 38-39 but 32 should be the same. I used this to find the number on my ‘41. Mine was light but I cleaned the area and rubbed white chalk over the number.

https://www.fordbarn.com/forum/attac...6&d=1743334108


All times are GMT -5. The time now is 09:27 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.