New manufactured coolant pump question
 

The impeller to housing clearance is .003" on the Ford pump. It's .050" on the new one. See photo. Just wondering if this will affect the flow and how.

Re: New manufactured coolant pump question
 

Re: New manufactured coolant pump question
 

That's a considerable difference between the original and the new one. Closer is certainly better the difference in volume moved between the two might be substantial. Any time I rebuild a water pump the impeller clearance to the housing is no more than .010 to .015.
Ronnieroadster

Re: New manufactured coolant pump question
 

Joe, contact "Skip" Haney on Fordbarn about rebuilding your pumps using his curved impellor that pumps more water. He also cleans and paints the pumps with a cast iron finish, installs new bearings and seals and mounting gaskets. Well worth the $$. He rebuilt my 8BA pumps a few years ago and they are still working fine.

Re: New manufactured coolant pump question
 

First, thanks for the responses. .050" seems way excessive, but the pump is in and after a road test, the temps measured with a heat gun at the sensor are what they were previously, (the old pump was dripping at the shaft).


The Bill Hirsch engine paint is a good match and I also did the road draft tube, crossover pipe, gravel shield, new motor mount, and cleaned the manifold heat valve, (it works perfect) while I had her apart. Also, a lot of degreasing.
Happy with the result. I'll keep Skip in mind.

Re: New manufactured coolant pump question
 

Looks like success!…….i like the extra ground straps!…….Mark

Re: New manufactured coolant pump question
 

Thanks, well you know what the "old timers" say about ground straps on a 6 volt car.

Re: New manufactured coolant pump question
 

Just had a thought. When the gasket and iron thickness at the block are added and factored in, maybe the impeller to housing dimension is a moot point.

Re: New manufactured coolant pump question
 

Joe makes a good point.

Here's more info. on flathead water pump flow rate.
https://www.fordbarn.com/forum/showt...9442&showall=1

Re: New manufactured coolant pump question
 

Thanks for the interesting link.