36 pickup bell support over universal left out
 

Was installing the engine and trans, after being out for 5 years. Forgot about the support that goes over the universal, and inside the bell on the driveline. Had every thing bolted in and found it. Dang it! All unbolted and ready to install it. Just wondering how many times it has been left out, and what would have happened if it was left out? A good lesson which should not have to be learned. Thanks for your input. Ron

Re: 36 pickup bell support over universal left out
 

well you wont do that again...

Re: 36 pickup bell support over universal left out
 

In a perfect world, we learn from our mistakes, but I for one am not always so perfect!

Re: 36 pickup bell support over universal left out
 

What is that? I've not been into a pre-'37 driveline but have been into several post-'37s and can't visualize that part. What have I missed?

Re: 36 pickup bell support over universal left out
 

I assume that you are refering to the universal joint inner cap (4513) as shown below.

Re: 36 pickup bell support over universal left out
 

Thanks Don, I wasn't sure of the correct name. I'm sure if I left it out there would be a problem. Ron

Re: 36 pickup bell support over universal left out
 

There sure would be. That inner cap serves as a support and swivel point for the drive shaft housing.