226 H parts suppliers
 

What reputable suppliers are left? I want to learn from others which ones to use and which ones to avoid. Plus if anyone on here has parts I'd be interested. right now the pistons are std. so I kinda believe the rest of the motor hasnt been touched either. It runs, its just low on compression an smokes..

Re: 226 H parts suppliers
 

I purchased every part you could replace in my H engine except crank rods & cam from Bob Selzan @ 1/2 Ton fun or NJparts on eBay (same) My cam was completely junk so that came from Egge. Most parts were genuine Ford.

Re: 226 H parts suppliers
 

Parts. Try N.B.Pease & Co. in Palmer, Mass. 1-413-283-7620. Nelson specializes in mechanical parts. He has been in business in Mass. for more than 40 years. He knows his stuff.

Re: 226 H parts suppliers
 

Bob Selzam had great NOS parts. The business has been closed for a couple of years.

Re: 226 H parts suppliers
 

Bob Selzam may still be in business but just through email. Last time I contacted him by email he said he was still going. Of course I have lost his email address, but someone may chime in. Good NOS real parts.

Re: 226 H parts suppliers
 

And don't forget Fred at South Side Obsolete; he seems to have a bit of everything!:)

Re: 226 H parts suppliers
 

The parts for the 226H is available...Egge,Kanter,Falcon and others still have the rebuild kits available.
If i remember right the oilpump and camshaft is what´s not available off the shelf from them.

Re: 226 H parts suppliers
 

I am sure nobody has new lifters for the 226. Nobody!
I have found a lot of parts on eBay, including bearings and pistons.

Re: 226 H parts suppliers
 

Are we talking G or H series ?

Re: 226 H parts suppliers
 

"Are we talking G or H series ?"

The title of the post says 226 H.

Sal

Re: 226 H parts suppliers
 

Bob had H lifters

Re: 226 H parts suppliers
 

https://www.ebay.com/itm/1948-51-FOR...gAAOSwQTdcsSyG

There you have 12 fresh sets...so not total unobtainium...

Re: 226 H parts suppliers
 

It's been 20 years but I got all my overhaul parts for a 226H from Kanter. Not sure now, but then the parts came in NOS original boxes. No Chinese junk.