Intake question
 

Will a Fenton 3x2 intake accept Holley 94s without any carb mods? Thanks in advance, Craig.

Re: Intake question
 

I'm sure everyone is going to need a lot more info to answer that. But more than likely NO.

Re: Intake question
 

"lonewolf" - I think you're missing the point. I THINK he is asking if 94's will bolt onto a Fenton 3 deuce manifold without interference. I know that they won't on an Offenhauser 3 carb manifold, but will on an Edelbrock. I don't know about a Fenton, but I'm sure someone out there has done it (or found out that it won't work).

I know this, because I once found a Weiand four carb manifold for an early hemi for a great price. Since I had a bunch of 94's, I thought is was a no brainer. Nope, they wouldn't fit unless you removed the front center screw on the back three carbs and then ground down the bosses. I decided that I didn't want to do that, so I spent the next year hunting down some 97's which did fit.

If the O/P was asking about function, and not fitment, then I'm all wet. I will admit the question could have been more specific.

O/P; what do you want to know?

Re: Intake question
 

And this unvarnished truth is the backstory behind the popularity of the 97's over the 94's.

Re: Intake question
 

Craig I complexly understand your question heres what you can do measure the center line of the stud spacing on the outer studs if the Fenton measures 5-1/4 inches the Ford 94 carbies will clear each other.
Ronnieroadster