The Ford Barn

The Ford Barn (https://www.fordbarn.com/forum/index.php)
-   Model A (1928-31) (https://www.fordbarn.com/forum/forumdisplay.php?f=3)
-   -   Nice Gasoline Filter (https://www.fordbarn.com/forum/showthread.php?t=276651)

Werner 02-12-2020 04:26 PM

Nice Gasoline Filter
 

1 Attachment(s)
N'Abend miteinander!

Does anyone have a tip for an good antique-old gasoline filter? There are nice filters for Harley D., but they are much too coarse in the strainer and are of no use.

The mounted plastic filter (micronic paper) works very well, but unfortunately ugly for a classic car.

Gary WA 02-12-2020 04:48 PM

Re: Nice Gasoline Filter
 

No, But get rid of rubber hose/filter and put on stock style gas line. If your tank is clean and have a pencil filter in gas tank shouldn't need that filter.plus the firewall filter

Werner 02-12-2020 04:54 PM

Re: Nice Gasoline Filter
 

Thank you, Gary. But no, the tank is unfortunately not clean. There is some rust in it, but also old tough residues that only dissolve very slowly.

Therfore because of this, I unfortunately have to use a fine gasoline filter in the line.

Sunnybrook Farm 02-12-2020 05:19 PM

Re: Nice Gasoline Filter
 

If you have a glass sediment bowl, a NAPA 3039 filter will fit right at the top where the brass screen is. I got one today for a little over $6. The guy said it showed as being for some GM products back in the early 60s so there wasn't any in the store but they got one shipped in next day. It looks like it is made to be there.

Synchro909 02-12-2020 06:06 PM

Re: Nice Gasoline Filter
 

I run a disposable filter similar to that on each of my cars, rubber connections and all. I figure a flexible section in the fuel line reduces the possibility of a fracture, hence reduces the risk of fire. I also use FAMs so the motor moves a bit and without the flexible section, all that movement has to be taken by the fuel line and it will eventually fail, IMO. 80,000 miles and no problem.

whirnot 02-12-2020 06:20 PM

Re: Nice Gasoline Filter
 

I too run one inside the sediment bowl.

Conaway2 02-12-2020 07:26 PM

Re: Nice Gasoline Filter
 

Quote:

Originally Posted by Synchro909 (Post 1851317)
I run a disposable filter similar to that on each of my cars, rubber connections and all. I figure a flexible section in the fuel line reduces the possibility of a fracture, hence reduces the risk of fire. I also use FAMs so the motor moves a bit and without the flexible section, all that movement has to be taken by the fuel line and it will eventually fail, IMO. 80,000 miles and no problem.

Interesting Synchro....I run a similar filter arrangement as well, but just replaced the rubber tubing with a steel line for the same reason - worry that vibration would lead to tubing failure. Maybe I should rethink.....
Jim

Tacoma Bob 02-12-2020 08:33 PM

Re: Nice Gasoline Filter
 

Quote:

Originally Posted by Sunnybrook Farm (Post 1851294)
If you have a glass sediment bowl, a NAPA 3039 filter will fit right at the top where the brass screen is. I got one today for a little over $6. The guy said it showed as being for some GM products back in the early 60s so there wasn't any in the store but they got one shipped in next day. It looks like it is made to be there.

1959 General motors. (Cadillac) I have run them for years.

Mulletwagon 02-12-2020 08:55 PM

Re: Nice Gasoline Filter
 

Quote:

Originally Posted by whirnot (Post 1851322)
I too run one inside the sediment bowl.

Went this route -

https://www.brattons.com/glass-sedim...el-filter.html

daveymc29 02-12-2020 11:19 PM

Re: Nice Gasoline Filter
 

I'm with Gary in No. 2. I have never had much luck with the other filters. Well that's not entirely true if you count bad luck. Had to be hauled home twice before I removed the filters except the pencil filters inside the tank attached to the shut off valve. Helps me pick up clear fuel from higher up in the tank. Some forego the filter and just use a small length of tubing inside the shutoff. I prefer the pencil filter and haven't experienced any clogging in the carburetor since I replaced the filters in the line with the one filter in the shut off. Your results may vary if the tank is extremely rusted.

Brentwood Bob 02-13-2020 01:15 AM

Re: Nice Gasoline Filter
 

Werner, does the filter have a direction of flow? Seems to me it should be 180 degrees switched so the tapered end would discharge into the carburetor?
Maybe it doesn't matter.

Werner 02-13-2020 06:18 AM

Re: Nice Gasoline Filter
 

Guten Morgen.


My car's year of construction is 1928 with the original iron bowl. I will use copper for the fuel line, it is elastic and does not tend to crack when vibrating. At this time there is brass.

My problem is that I need a very finely screened filter. The plastic-paper-filter in the past was very dirty after 3000 mls. But such a plastic thing doesn't look good for this classic car. -


Bob, yes, the filter is mounted the right way round. The large filter area should always pointing towards the inlet.


Thank you for the hints!

Bob Bidonde 02-13-2020 10:06 AM

Re: Nice Gasoline Filter
 

1 Attachment(s)
The original Ford sediment bowls without add-ons work very. Any additional filter in the system is a flow restriction.

katy 02-13-2020 10:34 AM

Re: Nice Gasoline Filter
 

What year did Ford switch from the cast iron to glass sediment bowl?

rocket1 02-13-2020 10:56 AM

Re: Nice Gasoline Filter
 

If you think you need an xtra gas filter the ones on riding lawn mowers are small.

100IH 02-13-2020 11:28 AM

Re: Nice Gasoline Filter
 

Copper is more likely to harden and crack than steel line.

GPierce 02-13-2020 12:01 PM

Re: Nice Gasoline Filter
 

Quote:

Originally Posted by Bob Bidonde (Post 1851508)
The original Ford sediment bowls without add-ons work very. Any additional filter in the system is a flow restriction.

Mine like that was letting fine particles into the carb and eventually stopping up the jets. Installing the NAPA 3039 solved the problem. I drained the tank thru that filter and it pissed a steady stream.

I check it occasionally and changed it when necessary. Takes 5 minutes. Much easier than changing the finger screen inside the tank which requires dissembling the plumbing after draining the tank.

I know, I'm a heretic for removing the finger screen but it got stopped up on a tour and was a PITA on the side of the road.

ryanheacox 02-13-2020 01:23 PM

Re: Nice Gasoline Filter
 

Quote:

Originally Posted by 100IH (Post 1851537)
Copper is more likely to harden and crack than steel line.


I was thinking the same thing. Maybe Werner was referring to copper-nickle line? That stuff doesn't work harden like straight copper and it bends beautifully.

Ernie Vitucci 02-13-2020 01:33 PM

Re: Nice Gasoline Filter
 

Good Morning all...Back in the 60's an old mechanic working on my Model A changed my car to the glass bowl filter on the fire wall and inserted a big magnet that covered the bottom of the glass bowl...it seems to trap what ever comes out of the tank and I can look into the bowl and see when to open the filter and clean the red rust/stuff off the magnet, wipe out the bowl and put it back together...Ernie in Arizona

54vicky 02-13-2020 01:44 PM

Re: Nice Gasoline Filter
 

in Werners case I think form follows function.I second the nicopp for lines if going that direction


All times are GMT -5. The time now is 10:28 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.