Oversize pilot bearing ? Model A or B
 

Anyone know if there is a oversize pilot bearing for a A or B flywheel ?? Model A or B ? flywheel hole has been enlarged due to neglect and ware from bad trans front bearing...any help much appec...sc

Re: Oversize pilot bearing ? Model A or B
 

Have one made by a machinist.

Re: Oversize pilot bearing ? Model A or B
 

Look at metric sizes, or have the flywheel opened up to the next standard dimension. Then there is always J-B Weld!

Re: Oversize pilot bearing ? Model A or B
 

You could have the flywheel turned out and a sleeve pressed in.

Re: Oversize pilot bearing ? Model A or B
 

Here's what you can do, measure the bore then measure the bearing OD and divide by 2, cut a piece of steel shim stock, check to see it's the right length and width, jb weld the shim stock in the bore, tap the bearing in. Some of you may be shocked by this, but I've done this and it works.
carry on

Re: Oversize pilot bearing ? Model A or B
 

Flywheels are dime a dozen get another one why try to fix scrap iron?

Re: Oversize pilot bearing ? Model A or B
 

Hey, with that attitude the Model A would be extinct! Fix the part or use it for at least shop art.

Re: Oversize pilot bearing ? Model A or B
 

Someone said to use a Model A flywheel in the Model B engine but get it machined down to weight specs ??