victoria visors
 

How are the visor brackets attached to the visors on a Victoria?

Re: victoria visors
 

Art
Rivets were used
I will send you pictures tomorrow

Re: victoria visors
 

they use hollow rivets similar to hood handle rivets but a different size. I just mounted some up last week. Art if you need some rivets let me know, I have the correct size.

Re: victoria visors
 

I tried some from Lebaron Bonney that are too short. They are 1/8 diameter 5/16 long nickle plated tubular rivets. I could not get them to go thru the visor and bracket and leave anything to roll over. What did you use? Thank you for your offer, i sent a PM Art

Re: victoria visors
 

Look up larger rivets they are available from many sources.

Re: victoria visors
 

I found some 1/8” x 7/16 nickle plated tubular rivets at an office supply store and ordered them. Thanks for the responses. Art

Re: victoria visors
 

They paint brown on the visor side (bout the same as seat frame).

Re: victoria visors
 

Art
here are pictures of my cars sun visors. My sun visor bracket is the more common style. The one in the other post is not seen as often.

Re: victoria visors
 

our new slant visor bracket in s/steel is en route to us for inspection, once viewed we will have them produced , We will advise which dealer in USA will stock them, This has been a 13 month mission & not over yet , But looks like we are going to get there , Good things take time ?

Re: victoria visors
 

Can the stainless steel be nickle plated?

Re: victoria visors
 

Art not totally sure , have seen it done by mistake , Can you tell the difference between the two , Im sure someone will advise here , Thanks, Summer is back in NZ ,

Re: victoria visors
 

if it is 304 stainless when polished out the color is pretty much dead on.

Re: victoria visors
 

Thanks for that , I knew someone would speak up, We decided stainless as would be close too Nickel & better than plating, Thanks

Re: victoria visors
 

Here are the visor locations and installations:

Re: victoria visors
 

Do any of you gentlemen know if the Victoria visors & brackets are the same as used in a 1931 S/W Fordor Sedan?

How can we find out when the reproduction brackets will become available?

Thank you.

Re: victoria visors
 

They are the same. See attached photos of visors in a 1931 S/W.

Re: victoria visors
 

160B
on the 31 SW 4 doors the visors are attached to a block of wood that goes between two of the top bows. on the Victoria`s there is a bigger top bow that the visors are attach too. I just installed the visors in Robert`s 160C yesterday.