It's been a good day👍 1 Attachment(s)
I can see light at the end of the tunnel.
|
Re: It's been a good day👍 Its not a train is it?
|
Re: It's been a good day👍 Ok she is all there so fire her up! Congratulations!
Mike |
Re: It's been a good day👍 Remember to post a video of it running!!!!
|
Re: It's been a good day👍 Here it is!!
https://youtu.be/kiBp-S1ef_s |
Re: It's been a good day👍 Looks and sounds great. Congrats, and nice oil pressure.
|
Re: It's been a good day👍 great job!
|
Re: It's been a good day👍 Cool!! Looks & sounds great! Get it on the road!
|
Re: It's been a good day👍 Sounds real good!
|
Re: It's been a good day👍 So that's what you do after putting the motor back in the car!
I have been trying to figure that out for a few weeks! |
Re: It's been a good day👍 Still have a little way to go before hitting the road. While I have the floorboards out I'm going to try to shim the body so the doors fit better.
Hugh |
Re: It's been a good day👍 It took all day but she runs great.
https://youtu.be/qdUuDKprF_g |
Re: It's been a good day👍 Nice!!!
|
Re: It's been a good day👍 1 Attachment(s)
First I-10 adventure.
I now have about 250 miles on my counterbalanced engine project. I can get almost everything I need in my little town but today I needed a boat part in the next town. It's only an 11 mile trip but I have to run down I-10 for a couple of miles before I can get back on the feeder road. It didn't hurt that traffic was light:) Also got a lot of positive attention from the 18 wheelers. Hugh |
Re: It's been a good day👍 Wow! Travelling at that speed on a new motor.:eek:
On another front, I suggest you turn that ignition coil over if it is oil filled. https://www.fordbarn.com/forum/showth...7161&showall=1 |
Re: It's been a good day👍 I have a Mitchell 1.26% OD so it's only turning about 2200 RPM & it was only for 2 minutes. This engine is very happy between 1750-2200 RPM.
Is there a way to tell if my coil is oil filled or should I assume it is and turn it over? Hugh |
Re: It's been a good day👍 Quote:
|
All times are GMT -5. The time now is 12:44 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.