wide box
 

I`m sure this was brought up before. does someone reproduce rear steel fenders for the wide box. John

Re: wide box
 

Not to my knowledge. Google: Westcott's. Quality, been around a looong time and Karl posts on F/barn.
Paul in CT

Re: wide box
 

You could consider what I did on my huckster, bolt up regular pickup fenders and slice them in the middle and weld up to match the outside of the running board. I think regular fenders are about an inch too wide.

Re: wide box
 

Hey john
They are not repo'd except fiberglass as I know
They can be made best by slicing and dicing sedan fenders.
Yep I know they are not easy to find too
Making them from coupe/roadster is much harder. I've tried both ways!
Bill U

Re: wide box
 

I have an old Mack Products Catalogue which shows such steel fenders for the wide box.
Not sure if they still make them.
They are also known as Mack Hils Inc in Moberly Missouri
Ph 660 263 7444

Good luck...

Re: wide box
 

same as above.

Re: wide box
 

Hash, you may have struck GOLD with this lead.
I hope they still make them...

Re: wide box
 

Hi John,
I have a few photos comparing a nos wide bed fender to an early take off coupe/roadster rear fender. Note the inner lip is larger than the coupe. Also the wide bed fender in 10" in with and the coupe is 12" in with. Also the inner/outer rear area below the rear mounting bracket is shaped diff.than coupe or sedan.
Jim Sinclair

Re: wide box
 

They are no longer on Fulton ave and this is on the site,

" We supply truck bed parts for Dodge, Willys, Studebaker and Plymouth. Complete assembled beds or kits are also available for Chevrolet 1928 through 1972 and Fords 1928 through 1972. Contact us for a quotation and shipping costs on any of these kits or custom beds at [email protected]."

Mack Hils, Inc.
Address: 544 North Avenue
Mailing: P.O. Box 856
Moberly, MO 65270
Phone: (660) 263-7444
Fax: (660) 263-4403
Hours: 7am - 5pm (CDT)

Re: wide box
 

thanks Jim for the pictures and size. it looks like I will be cutting down some fenders.
John

Re: wide box
 

pm sent. Bob