Block needs surfacing
 

Need some help guys. Bottom radiator hose split, engine got real hot very fast. The head gasket blew between #3 and 4 cylinder. I bought a new gasket cleaned everything up as much as possible installed gasket and head torqued to 55lbs. I decided to do a leak down test before adding water and oil.
Head was leaking between all cylinders. I removed head since there wasn't anybody nearby that could resurface the head I glued some emery paper on to a large ground surface plate. Every once in a while I would turn the head over and noticed I was making pretty good progress. I turned it over and saw a crack between cylinder #2 and 3 from water port to head blot to other water port.

By the way this is a model B engine. I ordered a 5.5:1 head from Snyder's and the gasket they recommend for the B Block. Plugged the steam holes as recommended. Installed the gasket and head torqued to 55lbs. Did a leak down test. Still leaks between all cylinders.

My question looks like the block isn't level? If I remove the valves does anyone know how to resurface the block with engine in car, or should I just remove the engine disassemble and do everything that needs to be done.

By the way this engine has been running great and was overhauled about 10,000 miles age about 3 years.
Richard

Re: Block needs surfacing
 

Re: Block needs surfacing
 

On your leakdown test where is the air escaping?
Bill

Re: Block needs surfacing
 

Al, yes the rings were wet.

Bill, with each cylinder at top dead center I could hear air leaking out of the adjacent spark plug hole. Head gasket just not sealing between cylinders.
Richard

Re: Block needs surfacing
 

Firstly, clean the top of the block carefully. Have the block straightness checked with a precision straight edge and a feeler gage. This will show how much and where the warp is. Check several places across the width of the block and also diagonally both ways. If it is out, it will have to come out of the car and be stripped down to be surfaced. The A and B engine are hard to hold head gaskets as there are only 14 studs spaced wide apart. When Henry went to the v8, same basic layout had 21 studs per head with smaller cylinders. To hold well both head and block must be FLAT!

Re: Block needs surfacing
 

If it was a ring issue the leak down air would come out of the crankcase... If your valves are not sealing it can go into another cylinder via the manifolds then through an open valve..

Re: Block needs surfacing
 

Thanks Mark Haven't checked with straight edge and feeler gage. Good idea

Re: Block needs surfacing
 

Mitch,
The engine was running great before it overheated. I'm probably prolonging the inevitable. If it's a valve problem it would have to be a valve problem in every cylinder.
Thanks Mitch
Richard

Re: Block needs surfacing
 

not much way to resurface the block without stripping it. At the very least you will get drugs and grit into the cylinders that you won't be able to remove that will damage the bores and rings. Best to do a compression test before doing a leakdown. If you don't have the pistons at the compression stroke the pressure will leak into adjacent cylinders through the manifolds. I'm not saying you are doing it wrong, just suggesting you check yourself. The compression test can isolate rings or valves or gasket leaks.

Re: Block needs surfacing
 

I posted that scenario cause I don't want you to mis diagnose your issue.

Re: Block needs surfacing
 

James,
Good advice I'll do it again making sure I'm on Compression on each cylinder. I'll do a compression test also.
Richard

Re: Block needs surfacing
 

BY the way guys, I dumped the White Walls. I like it better.