The Ford Barn

The Ford Barn (https://www.fordbarn.com/forum/index.php)
-   Model A (1928-31) (https://www.fordbarn.com/forum/forumdisplay.php?f=3)
-   -   28 roadster under cowl clips (https://www.fordbarn.com/forum/showthread.php?t=184664)

pooch 12-13-2015 02:12 AM

28 roadster under cowl clips
 

Have not seen these before...

Is a 28/29 roadster/phaeton cowl RHD , seems to be original and unmolested .

Has 2 holed clips on right side and one holed clip on the left side.

Q1. I was thinking the only thing that may go in this direction and place is a wiper wire or vacuum line ?

Did a roadster /phaeton even have a vacuum wiper.

The one I had had a hand wiper.

Q2. Why is there another (one only ) clip over on the other side ?

http://i86.photobucket.com/albums/k1...psymbyil8k.jpg

http://i86.photobucket.com/albums/k1...psibaioaiu.jpg

http://i86.photobucket.com/albums/k1...psvqcwlmpr.jpg

Fullraceflathead 12-13-2015 05:07 AM

Re: 28 roadster under cowl clips
 

My 1928 Roadster Pick up has them too.

updraught 12-13-2015 06:44 AM

Re: 28 roadster under cowl clips
 

The rear clips look familiar. Can't remember seeing the front one.

https://www.fordbarn.com/forum/showth...2673&showall=1

photos #17 show the same.

2manycars 12-13-2015 08:07 AM

Re: 28 roadster under cowl clips
 

The clip in the first photo is for a wire to the windshield wiper motor. The other two are also for wire routing, but even if wires are not used, they also position the cowl kick panel at the front top of each panel.

wrndln 12-13-2015 08:47 AM

Re: 28 roadster under cowl clips
 

2manycars is correct. You need the two toward the front of the car to secure the top front corner of the cowl panel even if you don't have an electric wiper.
Rusty Nelson

pooch 12-13-2015 05:53 PM

Re: 28 roadster under cowl clips
 

Good info, so has anyone got a pic of an original kick panel and how it fits into the rear clips ?

Lawrie 12-13-2015 06:01 PM

Re: 28 roadster under cowl clips
 

Would it not just fit up into the groove in the clip,
Lawrie

wrndln 12-13-2015 06:19 PM

Re: 28 roadster under cowl clips
 

Yes, the hardboard panel fits in the subrail extension channel at the bottom. There are three oval head sheetmetal screws that fasten the hardboard panel to the A pillar flange for the windlace with special cup washers. The clips in the top front shown in the pictures above are used to retain the top front corner of the panel in the U shaped part of the clips.
Rusty Nelson

pooch 12-13-2015 07:41 PM

Re: 28 roadster under cowl clips
 

Ahh OK, did not look at my own pic hard enough .

Thanks all.


All times are GMT -5. The time now is 10:28 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.