open car wind screen -28 phaeton
 

hello- anyone have any thoughts on drilling out the 2 screws on top of each side of the w-screen in order to disassemble it? the screws are badly rusted. also, i guess there must be a 90 degree round fixture on the top corners to make the windscreen strong -is this correct? thank you

Re: open car wind screen -28 phaeton
 

I believe there is a L shapped bracket in the corner. I don't believe it is round. I think it is rectangular bar stock bent into a right angle with tapped holes for the screws on the stanchion sides. I am not sure, but I think the right angled bracket is spot welded or somehow fastened without screws to the top windshield piece (or windscreen as you would call it). I have 3 open car windshield frames, but haven't disassembled them yet. I suspect I will have the same problem you are having.
Rusty Nelson

Re: open car wind screen -28 phaeton
 

A pic

Re: open car wind screen -28 phaeton
 

Screws

Re: open car wind screen -28 phaeton
 

Hope these help

Re: open car wind screen -28 phaeton
 

many thanks to all who replied - from the replies i think if i ruin the slot trying to get screws out, i'll be safe in drilling and atpping some new threads - you were a big help

Re: open car wind screen -28 phaeton
 

I use a very small bit for starters and work up..................